A new tuning rule is introduced for linear active disturbance rejection control (ADRC), which results in similar closed-loop dynamics as the commonly employed bandwidth parameterization design, but with lower feedback gains. In this manner the noise sensitivity of the controller is reduced, paving the way for using ADRC in more noise-affected applications. It is proved that the proposed tuning gains, while rooted in the analytical solution of an algebraic Riccati equation, can always be obtained from a bandwidth parameterization design by simply halving the gains. This establishes a link between optimal control and pole placement design.
In this work, an advanced motion controller is proposed for buck converter-fed DC motor systems. The design is based on an idea of active disturbance rejection control (ADRC) with its key component being a custom observer capable of reconstructing various types of disturbances (including complex, harmonic signals). A special formulation of the proposed design allows the control action to be expressed in a concise and practically appealing form reducing its implementation requirements. The obtained experimental results show increased performance of the introduced approach over conventionally us…
Control systems are inevitably affected by external disturbances, and a major objective of the control design is to attenuate or eliminate their adverse effects on the system performance. This paper presents a disturbance rejection approach with two main improvements over existing results: 1) it relaxes the requirement of calculating or measuring the state derivatives, which are not available for measurement, and their calculation is corrupted by noise, and 2) it achieves finite-time disturbance rejection and control. To this end, the disturbance is first modeled by an unknown dynamics, and an…
This paper presents an improved active disturbance rejection control scheme (IFO-ADRC) with an improved fractional-order extended state observer (IFO-ESO). The structural information of the system is utilized in IFO-ESO rather than buried as in the typical fractional-order extended state observer (FO-ESO) and help significantly improve the performance of IFO-ESO and closed-loop system. Compared with the integer-order active disturbance rejection controller (IO-ADRC), the auxiliary tracking controller of IFO-ADRC has a simpler form and fewer parameters need to be tuned. Frequency-domain analysi…
This paper solves the problem of station-keeping control of a surface vessel under conditions of sinusoidal disturbances with unknown parameters. The proposed control algorithm is based on the geometric approach with the use of the adaptive internal model and the extended observer. The paper analytically proves the boundedness of the trajectories of the system and their semiglobal convergence to an arbitrarily small set. The performance of the algorithm is illustrated by computer simulation.
The high tech industry which requires fast stable motion with nanometer precision continues to mainly use PID which is limited by fundamental linear control limitations. Floor vibrations as disturbance significantly affect performance and their rejection is particularly affected by these limitations. Reset control has provided a promising alternative to surpass these, while simultaneously allowing the use of industry standard loop-shaping during design. However, the reset action introduced higher order harmonics can induce unwanted dynamics and negatively influence performance. This paper inve…
Considering the control problem for nonlinear uncertain systems, the tolerable range of uncertain control input gain is a fundamental issue. The paper presents the necessary and sufficient condition for the well-performed closed-loop system based on active disturbance rejection control (ADRC) design. Via the proposed necessary and sufficient condition, the maximum tolerable range of the uncertain control gain is quantitatively presented, which reveals the capability of ADRC to handle the uncertainties related with control input. Moreover, under the proposed necessary and sufficient condition, …
The increasing demand for target tracking, environmental surveys, surveillance and mapping requires multi-axis gimbal systems with high tracking and stabilization performance. In this paper, first, computed torque model is generated to estimate the complex disturbances acting on the system. Then, two different control strategies based on active disturbance rejection control (ADRC) and computed torque model are implemented on a two-axis gimbal system. The purpose is to improve the robustness, environmental adaptability and tracking accuracy of the system and reduce the tuning effort of ADRC by …
Practical applications of controllers often impose further requirements on the implementation beyond the actual control performance, such as the ability to switch between manual and automatic control or between different control laws or controller parameter settings, known as bumpless transfer. Another common requirement is to limit the control signal in magnitude and/or rate. This article examines and extends several discrete-time variants of active disturbance rejection control (ADRC), which is increasingly being applied especially in the field of power electronics and drives, in this regard…
This paper presents an active disturbance rejection control (ADRC) scheme with an improved fractional-order extended state observer (IFO-ESO).Based on the new ADRC scheme, the open-loop transfer function of a high-order system can be approximately rendered to a so-called Weighed Bode's ideal transfer function, whose closed-loop performance is less prone to the controller parameter variations. The design of the IFO-ESO helps reduce the number of system states to be estimated and improves the performance of closed-loop system over %the previously proposed the fractional-order active disturbance …
A general controller scheme for stabilizing a non-linear system, which has its origin from the linear system theory, is proposed in this paper. The proposed controller can stabilize the non-linear system subjected to initial conditions. An effective way to obtain the controller parameters is presented with the knowledge of the system model. The controller is designed for the linear time-invariant (LTI) system, which can reject any disturbance acting on it. Paper emphasis the idea of an integrator controller in disturbance rejection. The concept is extended to the application to non-linear syst…
We consider the task of motion control for non-prehensile manipulation using parallel kinematics mechatronic setup, in particular, stabilization of a ball on a plate under unmeasured external harmonic disturbances. System parameters are assumed to be unknown, and only a ball position is measurable with a resistive touch sensor. To solve the task we propose a novel passivity-based output control algorithm that can be implemented for unstable linearized systems of an arbitrary relative degree. In contrast to previous works, we describe a new way to parametrize harmonic signal generators and an e…
This thesis is concerned with the rejection of time-varying disturbances in linear model predictive control of discrete-time systems. In the literature, disturbances are widely rejected by using velocity models, disturbance model with observer approach or a scheme that combines the compensation of a disturbance observer and the feedback regulation of MPC. Contrary to the widely used methods, the technique proposed in this research utilises the increment model of plants, with the assumption of fast-changing disturbances, to formulate a control law to reject the varying-disturbances. The uniquen…
Matched disturbance rejection for energy-shaping controlled underactuated mechanical systems
The University of Newcastle（纽卡斯尔大学）；PRC CDSC（过程控制与系统研究中心）；University of Naples Federico II（那不勒斯费德里科二世大学）；PRISMA Lab（PRISMA实验室）；Queensland University of Technology（昆士兰科技大学）；Laboratoire des Signaux et Systèmes（信号与系统实验室）；CNRS-SUPELEC（法国国家科学研究中心-苏佩莱克）
The performance of active disturbance rejection control (ADRC) algorithms can be limited in practice by high-frequency measurement noise. In this work, this problem is addressed by transforming the high-gain extended state observer (ESO), which is the inherent element of ADRC, into a new cascade observer structure. Set of experiments, performed on a DC-DC buck power converter system, show that the new cascade ESO design, compared to the conventional approach, effectively suppresses the detrimental effect of sensor noise over-amplification while increasing the estimation/control performance. Th…
In this paper the stability of a closed-loop cascade control system in the trajectory tracking task is addressed. The considered plant consists of underlying second-order fully actuated perturbed dynamics and the first order system which describes dynamics of the input. The main theoretical result presented in the paper concerns stability conditions formulated based on the Lyapunov analysis for the cascade control structure taking advantage of the active rejection disturbance approach. In particular, limitations imposed on a feasible set of an observer bandwidth are discussed. In order to illu…
Universidad Complutense de Madrid（马德里康普顿斯大学）；School of Automation, Nanjing University of Science and Technology（南京理工大学自动化学院）
This paper addresses the problem of end-effector formation control for manipulators that are subjected to external disturbances: input disturbance torques and disturbance forces at each end-effector. The disturbances are assumed to be non-vanishing and are superposition of finite number of sinusoidal and step signals. The formation control objective is achieved by assigning virtual springs between end-effectors, by adding damping terms at joints, and by incorporating internal model-based dynamic compensators to counteract the effect of the disturbances; all of which presents a clear physical i…
The extended state observer (ESO) plays an important role in the design of feedback control for nonlinear systems. However, its high-gain nature creates a challenge in engineering practice in cases where the output measurement is corrupted by non-negligible, high-frequency noise. The presence of such noise puts a constraint on how high the observer gains can be, which forces a trade-off between fast convergence of state estimates and quality of control task realization. In this work, a new observer design is proposed to improve the estimation performance in the presence of noise. In particular…
The robust disturbance rejection controller has been the subject of intensive research due to its undeniable importance for automation. Modern control theory tends to use model-based approaches versus model-free approaches, especially when it comes to highly modern applications. The backbone of the dissertation is based on the systematic modeling of dynamic systems and the development of advanced control methods. Accordingly, the dissertation begins with the investigation of nonlinearities in dynamic systems. The extension of classic subspace algorithms for linear systems in the frequency doma…
Active disturbance rejection control for unmanned tracked vehicles in leader-follower scenarios: discrete-time implementation and field test validation
In this study, an active disturbance rejection control (ADRC) toolbox for MATLAB/Simulink is introduced. Although ADRC has already been established as a powerful robust control framework with successful industrial implementations and strong theoretical foundations, a comprehensive tool for computer-aided design of ADRC has not been developed until now. The proposed open-source ADRC Toolbox is a response to the growing need in the scientific community and the control industry for a straightforward software application of the ADRC methodology. Its main purpose is to fill the gap between the curr…
Robotic laparoscopic grasper is a surgical tool with minimal invasion. In this robot, achieve goals like precise tracking, stability and disturbance rejection are very important. In this paper, first the stages of modeling and simulating of laparoscopic robot will be discussed and the reasons for selecting the appropriate materials for different parts of proposed practical robot will be explained. Inverse dynamic controller with integral action is applied to improve the accuracy of tracking procedure for a surgical manipulator to track a specified reference signal in the presence of tremor tha…
This paper proposes a new fraction-order active disturbance rejection controller based on an improved fraction-order extended state observer (IFESO) for a class of fraction-order systems. Applying the IFESO, the fraction-order system can be approximated as an integer-order integrator (1/s). The parameters that ensure the stability of the IFESO and closed-loop system are provided. The frequency-domain analysis shows that the IFADRC has a stronger disturbance estimation performance for the fraction-order system than an integer-order active disturbance rejection controller (IADRC). The simulation…
In this paper, we consider the tracking control problem for robot manipulators which are affected by constant bounded disturbances. Three control schemes are applied for the problem, which composed of integral action and tracking controllers. The goal is improving the accuracy of tracking procedure for a robot manipulator to track a specified reference signal in the presence of constant bounded disturbances. Inverse dynamics controller, improved Lyapunov-based controller with integral action and discontinuous Lyapunov-based controller are three schemes that are evaluated in this paper. Third o…
