Rydberg-assisted atomic electrometry using alkali-metal atoms contained inside a vacuum environment for detecting external electric fields (E-fields) at frequencies $<$ a few kHz has been quite challenging due to the low-frequency E-field screening effect that is caused by the alkali-metal atoms adsorbed on the inner surface of the container. We report a very slow E-field screening phenomenon with a time scale up to $\sim$ second on a rubidium (Rb) vapor cell that is made of monocrystalline sapphire. Using this sapphire-made Rb vapor cell with optically induced, internal bias E-field, we demonstrate vapor-cell-based, low-frequency atomic electrometry that responds to the E-field strength linearly. Limited by the given experimental conditions, this demonstrated atomic electrometer uses an active volume of 11 mm$^3$ and delivers a spectral noise floor around $0.34$ (mV/m)/$\sqrt{\rm Hz}$ and the 3-dB low cut-off frequency around 770 Hz inside the vapor cell. This work investigates a regime of vapor-cell-based atomic electrometry that was seldom studied before, which may enable more applications that utilize atomic E-field sensing technology.
It is clearly important to pursue atomic standards for quantities like electromagnetic fields, time, length and gravity. We have recently shown, using Rydberg states, that Rb atoms in a vapor cell can serve as a practical, compact standard for microwave electric field strength. Here, we demonstrate, for the first time, that Rb atoms excited in a vapor cell can also be used for vector microwave electrometry by using Rydberg atom electromagnetically induced transparency. We describe the measurements necessary to obtain an arbitrary microwave electric field polarization at a resolution of $0.5^\c…
Rydberg atom-based electrometry enables traceable electric field measurements with high sensitivity over a large frequency range, from gigahertz to terahertz. Such measurements are particularly useful for the calibration of radio frequency and terahertz devices, as well as other applications like near field imaging of electric fields. We utilize frequency modulated spectroscopy with active control of residual amplitude modulation to improve the signal to noise ratio of the optical readout of Rydberg atom-based radio frequency electrometry. Matched filtering of the signal is also implemented. A…
Electrometry of extremely-low frequencies from kHz to sub-Hz with a Rydberg-atom sensor
Centre for Quantum Technologies, National University of Singapore（新加坡国立大学量子技术中心）；School of Physical and Mathematical Sciences, Nanyang Technological University（南洋理工大学物理与数学科学学院）；Department of physics and Materials Science, Chiang Mai University（清迈大学物理与材料科学系）；Quantum Sensing Centre（量子传感中心）
Pusan National University（釜山国立大学）；Quantum Sensors Research Center（量子传感器研究中心）；Quantum Science Technology Center, Pusan National University（釜山国立大学量子科学与技术中心）
We demonstrate a method for measuring atom-surface interactions using transmission spectroscopy of thermal vapors confined in a wedged nano-cell. The wedged shape of the cell allows complementary measurements of both the bulk atomic vapor and atoms close to surfaces experiencing strong van der Waals atom-surface interaction. These are used to tightly constrain the dipole-dipole collisional parameters of a theoretical model for transmission spectra that accounts for atom-surface interactions, cavity effects, collisions with the surface of the cell and atomic motion. We illustrate this method on…
We report observation of the $\rm 5S_{1/2} \rightarrow 5D_{5/2}$ two-photon transition in Rb vapor at 778 nm, using an external cavity diode laser system and a heated vapor cell. The spectra in the two isotopes show well-resolved hyperfine transitions. The peaks are Doppler free, and have a Lorentzian lineshape with a typical linewidth of 2.2 MHz. This linewidth is larger than the natural linewidth of 300 kHz, but is still 5--10 times smaller than the linewidth for single-photon transitions in the D$_2$ line. Since the absolute frequency of this transition is measured with 8 kHz precision, it …
We study $Λ$-type Electromagnetically Induced Transparency (EIT) on the Rb D2 transition in a buffer-gas-free thermal vapor cell without anti-relaxation coating. Experimental data show distinguished features of velocity-selective optical pumping and one EIT resonance. The Zeeman splitting of the EIT line in magnetic fields up to 12 Gauss is investigated. One Zeeman component is free of the first-order shift and its second-order shift agrees well with theory. The full width at half maximum (FWHM) of this magnetic-field-insensitive EIT resonance is reduced due to Doppler narrowing, scales linear…
We present a novel and simple method of stabilizing the laser phase and frequency by polarization spectroscopy of an atomic vapor. In analogy to the Pound-Drever-Hall method, which uses a cavity as a memory of the laser phase, this method uses atomic coherence (dipole oscillations) as a phase memory of the transmitting laser field. A preliminary experiment using a distributed feedback laser diode and a rubidium vapor cell demonstrates a shot-noise-limited laser linewidth reduction (from 2 MHz to 20 kHz). This method would improve the performance of gas-cell-based optical atomic clocks and magn…
Rydberg atoms have been used for measuring radio-frequency (RF) electric (E)-fields due to their strong dipole moments over the frequency range of 500 MHz-1 THz. For this, electromagnetically induced transparency (EIT) within the Autler-Townes (AT) regime is used such that the detected E-field is proportional to AT splitting. However, for weak E-fields AT peak separation becomes unresolvable thus limiting the minimum detectable E-field. Here, we demonstrate using the Rydberg atoms as an RF mixer for weak E-field detection well below the AT regime with frequency discrimination better than 1 Hz …
We demonstrated a scalar atomic magnetometer using a micro-fabricated Cs vapor cell. The atomic spin precession is driven by an amplitude-modulated circularly-polarized pump laser resonant on D1 transition of Cs atoms and detected by an off-resonant linearly-polarized probe laser using a balanced polarimeter setup. Under a magnetic field with amplitude in the Earth's magnetic field range, the magnetometer in the gradiometer mode can reach sensitivities below 150 fT/rt-Hz, which shows that the magnetometer by itself can achieve sub-100 fT/rt-Hz sensitivities. In addition to its high sensitivity…
Radio reception relies on antennas for the collection of electromagnetic fields carrying information, and receiver elements for demodulation and retrieval of the transmitted information. Here we demonstrate an atom-based receiver for AM and FM microwave communication with a 3-dB bandwidth in the baseband of $\sim$100~kHz that provides optical circuit-free field pickup, multi-band carrier capability, and inherently high field sensitivity. The quantum receiver exploits field-sensitive cesium Rydberg vapors in a centimeter-sized glass cell, and quantum-optical readout of baseband signals modulate…
We use a radio-frequency $^{85}$Rb alkali-vapor cell magnetometer based on a paraffin-coated cell with long spin-coherence time and a small, low-inductance driving coil to create highly resolved conductivity maps of different objects. We resolve sub-mm features in conductive objects, we characterize the frequency response of our technique, and by operating at frequencies up to 250 kHz we are able to discriminate between differently conductive materials based on the induced response. The method is suited to cover a wide range of driving frequencies and can potentially be used for detecting non-…
We demonstrate a continuous frequency electric field measurement based on the far off-resonant AC stark effect in a Rydberg atomic vapor cell. In this configuration, a strong far off-resonant field, denoted as a local oscillator (LO) field, acts as a gain shifting the Rydberg level to a high sensitivity region. An incident weak signal field with a few hundreds of kHz difference from the LO field is mixed with the LO field in Rydberg system to generate an intermediate frequency (IF) signal, which is read out by the Rydberg electromagnetically induced transparency (Rydberg-EIT) spectroscopy. Not…
