Advanced divertor configurations modify the magnetic geometry of the diverter to achieve a combination of strong magnetic flux expansion, increased connection length and higher divertor volume - to improve detachment stability, neutral/impurity confinement and heat-channel broadening. In this paper, we discuss the modification of the Flux-Coordinate Independent (FCI) turbulence code GRILLIX to treat generalised magnetic geometry, to allow for the investigation of the effect of magnetic geometry on turbulent structures in the edge and SOL. The development of grids and parallel operators from numerically-defined magnetic equilibria is discussed, as is the application of boundary conditions via penalisation, with the finite-width method generalised to treat complex non-conformal boundaries. Initial testing of hyperbolic (advection) and parabolic (diffusion) test cases is presented for the Snowflake scenario.
Turbulent dynamics in the scrape-off layer (SOL) of magnetic fusion devices is intermittent with large fluctuations in density and pressure. Therefore, a model is required that allows perturbations of similar or even larger magnitude to the time-averaged background value. The fluid-turbulence code GRILLIX is extended to such a global model, which consistently accounts for large variation in plasma parameters. Derived from the drift reduced Braginskii equations, the new GRILLIX model includes electromagnetic and electron-thermal dynamics, retains global parametric dependencies and the Boussines…
Results of a three-dimensional, flux-driven, electrostatic, global, two-fluid turbulence simulation for a 5-field period stellarator with an island divertor are presented. The numerical simulation is carried out with the GBS code, recently extended to simulate plasma turbulence in non-axisymmetric magnetic equilibria. The vacuum magnetic field used in the simulation is generated with the theory of Dommaschk potentials, and describes a configuration with a central region of nested flux surfaces, surrounded by a chain of magnetic islands, similarly to the diverted configurations of W7-X. The hea…
The formation of the radial electric field, $E_{\rm r}$ in the SOL has been experimentally studied for attached divertor conditions in stellarator W7-X. The main objective of this study is to test the validity in a complex 3D island divertor of simple models, typically developed in tokamaks, relating $E_{\rm r}$ to the sheath potential drop gradient at the target. Additionally, we investigate the effect of the edge $E_{\rm r}$ shear on the reduction of density fluctuation amplitude, a well-established phenomenon according to the existing bibliography. The main diagnostic for measurements in th…
BOUT++ turbulence simulations are conducted for a 60s steady-state long pulse high \{beta}p EAST grassy ELM discharge. BOUT++ linear simulations show that the unstable mode spectrum covers a range of toroidal mode numbers from low-n (n=10~15) peeling-ballooning modes (P-B) to high-n (n=40~80) drift-Alfvén instabilities. Nonlinear simulations show that the ELM crash is trigged by low-n peeling modes and fluctuation is generated at the peak pressure gradient position and radially spread outward into the Scrape-Off-Layer (SOL), even though the drift-Alfvén instabilities dominate the linear growth…
Shaping of magnetic flux surfaces is found to have a strong impact on turbulence and transport in tokamak edge plasmas. A series of axisymmetric equilibria with varying elongation and triangularity, and a divertor configuration are implemented into a computational gyrofluid turbulence model. The mechanisms of shaping effects on turbulence and flows are identified. Transport is mainly reduced by local magnetic shearing and an enhancement of zonal shear flows induced by elongation and X-point shaping.
Self-consistent simulations of neoclassical and electrostatic turbulent transport in a DIII-D H-mode edge plasma under resonant magnetic perturbations (RMPs) have been performed using the global total-f gyrokinetic particle-in-cell code XGC, in order to study density-pump out and electron heat confinement. The RMP field is imported from the extended magneto-hydrodynamics (MHD) code M3D-C1, taking into account the linear two-fluid plasma response. With both neoclassical and turbulence physics considered together, the XGC simulation reproduces two key features of experimentally observed edge tra…
Self-consistent full-size turbulent-transport simulations of the divertor and SOL of existing tokamaks have recently become feasible. This enables the direct comparison of turbulence simulations against experimental measurements. In this work, we perform a series of diverted Ohmic L-mode discharges on the TCV tokamak, building a first-of-a-kind dataset for the validation of edge turbulence models. This dataset, referred to as TCV-X21, contains measurements from 5 diagnostic systems -- giving a total of 45 1- and 2-D comparison observables in two toroidal magnetic field directions. The dataset …
A coherent structure transport model for scrape-off layer turbulence
Renewable and Sustainable Energy Institute, University of Colorado（科罗拉多大学可再生与可持续能源研究所）；Lodestar Research Corporation（洛德斯特研究公司）；Center for Integrated Plasma Studies, University of Colorado（科罗拉多大学综合等离子体研究中心）；General Atomics（通用原子能公司）；Massachusetts Institute of Technology（麻省理工学院）
We are developing a new continuum gyrokinetic code, Gkeyll, for use in edge plasma simulations, and here present initial simulations of turbulence on open field lines with model sheath boundary conditions. The code implements an energy conserving discontinuous Galerkin scheme, applicable to a general class of Hamiltonian equations. Several applications to test problems have been done, including a calculation of the parallel heat-flux on divertor plates resulting from an ELM crash in JET, for a 1x/1v SOL scenario explored previously, where the ELM is modeled as a time-dependent intense upstream…
The scrape-off layer power width (λ_q) is an important parameter for characterizing the divertor heat loads. Many experimental, theoretical, and numerical studies have been performed in recent years. In this paper, a 2D electrostatic turbulence code, BOUT-HESEL, has been upgraded to simulate H-mode plasmas for the first time. The code is validated against the previous implementation and the experiments. The simulated λ_q is found to agree quite well with the Eich scaling for the EAST H-mode discharge. The code is utilized to simulate the ITER 15MA baseline scenario. The ITER simulation reveals…
