Intelligent reflecting surfaces (IRSs) have recently attracted the attention of communication theorists as a means to control the wireless propagation channel. It has been shown that the signal-to-noise ratio (SNR) of a single-user IRS-aided transmission increases as $N^2$, with $N$ being the number of passive reflecting elements in the IRS. This has been interpreted as a major potential advantage of using IRSs, instead of conventional Massive MIMO (mMIMO) whose SNR scales only linearly in $N$. This paper shows that this interpretation is incorrect. We first prove analytically that mMIMO always provides higher SNRs, and then show numerically that the gap is substantial; a very large number of reflecting elements is needed for an IRS to obtain SNRs comparable to mMIMO.
This paper considers a multi-antenna multicast system with programmable metasurface (PMS) based transmitter. Taking into account of the finite-resolution phase shifts of PMSs, a novel beam training approach is proposed, which achieves comparable performance as the exhaustive beam searching method but with much lower time overhead. Then, a closed-form expression for the achievable multicast rate is presented, which is valid for arbitrary system configurations. In addition, for certain asymptotic scenario, simple approximated expressions for the multicase rate are derived. Closed-form solutions …
In this paper, we study an intelligent omni-surface (IOS)-assisted downlink communication system, where the link quality of a mobile user (MU) can be improved with a proper IOS phase shift design. Unlike the intelligent reflecting surface (IRS) in most existing works that only forwards the signals in a reflective way, the IOS is capable to forward the received signals to the MU in either a reflective or a transmissive manner, thereby enhancing the wireless coverage. We formulate an IOS phase shift optimization problem to maximize the downlink spectral efficiency (SE) of the MU. The optimal pha…
With the advancement of sensing technologies over the years, it has become critical to ensure the seamless connectivity of the Internet of Things (IoT) gadgets. With the advancement of communication technology, cellular networks are increasingly being utilized to link IoT systems. An IRS is a rectangular metasurface made up of a vast number of reflecting components that has recently gained research attention due to its ability to significantly improve the energy and spectral efficiencies of communication networks by modifying wireless transmission environments.
Reconfigurable Intelligent Surfaces (RISs) are envisioned to play a key role in future wireless communications, enabling programmable radio propagation environments. They are usually considered as nearly passive planar structures that operate as adjustable reflectors, giving rise to a multitude of implementation challenges, including an inherent difficulty in estimating the underlying wireless channels. In this paper, we propose the concept of Hybrid RISs (HRISs), which do not solely reflect the impinging waveform in a controllable fashion, but are also capable of sensing and processing a port…
Terahertz (THz) and intelligent reflecting surface (IRS) have been regarded as two promising technologies to improve the capacity and coverage for future 6G networks. Generally, IRS is usually equipped with large-scale elements when implemented at THz frequency. In this case, the near-field model and beam squint should be considered. Therefore, in this paper, we investigate the far-field and near-field beam squint problems in THz IRS communications for the first time. The far-field and near-field channel models are constructed based on the different electromagnetic radiation characteristics. N…
Reconfigurable intelligent surface (RIS) is a promising technology for establishing spectral- and energy-efficient wireless networks. In this paper, we study RIS-enhanced orthogonal frequency division multiplexing (OFDM) communications, which generalize the existing RIS-driven context focusing only on frequency-flat channels. Firstly, we introduce the delay adjustable metasurface (DAM) relying on varactor diodes. In contrast to existing reflecting elements, each one in DAM is capable of storing and retrieving the impinging electromagnetic waves upon dynamically controlling its electromagnetica…
Intelligent reflecting surfaces (IRS) will represent a key technology in the upcoming sixth-generation (6G) communication networks to extend the network coverage and overcome link blockage. Research on IRS is expected to take a giant leap in the coming years to address the current technological limitations, mainly regarding the IRS re-configuration in highly dynamic scenarios, such as vehicle-to-vehicle (V2V) ones. This paper proposes a fully passive and low-cost solution based on pre-configured IRS to be lodged on the vehicle's body, which does not require any signaling for re-configuration. …
In future 6G millimeter wave (mmWave)/sub-THz vehicle-to-everything (V2X) communication systems, vehicles are expected to be equipped with massive antenna arrays to realize beam-based links capable of compensating for the severe path loss. However, vehicle-to-vehicle (V2V) direct links are prone to be blocked by surrounding vehicles. Emerging metasurface technologies enable the control of the electromagnetic wave reflection towards the desired direction, enriching the channel scattering to boost communication performance. Reconfigurable intelligent surfaces (RIS), and mostly the pre-configured…
Intelligent Reflecting Surfaces for THz Communications: Fundamentals, Key Solutions, and System Prototyping
Shanghai Jiao Tong University（上海交通大学）；University of Macau（澳门大学）；Beijing University of Posts and Telecommunications（北京邮电大学）；Zhengzhou University（郑州大学）；Shanghai University（上海大学）；Henan University of Technology（河南工业大学）；Hubei University（湖北大学）
Reconfigurable Intelligent Surfaces (RIS) or Intelligent Reflecting Surfaces (IRS) are metasurfaces that can be deployed in various places in wireless environments to make these environments controllable and reconfigurable. In this paper, we investigate the problem of using 3D beamforming in RIS-empowered wireless networks and propose a new scheme that provides more degrees of freedom in designing and deploying the RIS-based networks. In the proposed scheme, a base station (BS) equipped with a full dimensional array of antennas optimizes its radiation pattern in the three-dimensional space to …
With growing security threats to the evolving wireless systems, protecting user privacy becomes progressively challenging. Even if the transmitted information is encrypted and the potential wiretap channel is physically limited (e.g. through information-theoretic security approaches), the raw data itself, such as transmitter position and transmission pattern, could expose confidential information. In this context, covert communication that intends to hide the existence of transmission from an observant adversary by exploiting the physical characteristics of the wireless medium has been activel…
While metasurface based intelligent reflecting surfaces (IRS) are an important emerging technology for future generations of wireless connectivity in its own right, the plans for the mass deployment of these surfaces motivate the question of their integration with other new and emerging technologies that would require mass proliferation. This question of integration and the vision of future communication systems as an invaluable component for public health motivated our new concept of Intelligent Reflector-Viral Detectors (IR-VD). In this novel scheme, we propose deployment of intelligent refl…
Recent research and development interests deal with metasurfaces for wireless systems beyond their consideration as intelligent tunable reflectors. Among the latest proposals is the simultaneously transmitting (a.k.a. refracting) and reflecting reconfigurable intelligent surface (STAR-RIS) which intends to enable bidirectional indoor-to-outdoor, and vice versa, communications thanks to its additional refraction capability. This double functionality provides increased flexibility in concurrently satisfying the quality-of-service requirements of users located at both sides of the metasurfaces, f…
Reconfigurable intelligent surfaces (RISs) are two dimensional (2D) metasurfaces which can intelligently manipulate electromagnetic waves by low-cost near passive reflecting elements. RIS is viewed as a potential key technology for the sixth generation (6G) wireless communication systems mainly due to its advantages in tuning wireless signals, thus smartly controlling propagation environments. In this paper, we aim at addressing channel characterization and modeling issues of RIS-assisted wireless communication systems. At first, the concept, principle, and potential applications of RIS are gi…
