探索共溅射ZnO:Al和SiO2在硅太阳能电池上形成有效的电子选择性接触
Exploring co-sputtering of ZnO:Al and SiO2 for efficient electron-selective contacts on silicon solar cells
摘要:
近年来,人们致力于开发用于晶体Si(c-Si)太阳能电池的新型电子选择性材料,试图简化制造工艺并提高效率。本研究以ZnO:Al(AZO)与SiO2共溅镀,以形成不同SiO2含量的AZO:SiO2薄膜。这些纳米尺度的薄膜,沉积在薄的本征氢化非晶硅薄膜的顶部,并与低功函数金属(如铝和镁),被证明有效地作为电子选择性接触的c-Si太阳能电池。一方面,AZO:SiO2在这种电子选择性接触中起着重要的作用,其厚度是一个关键参数,2 nm的厚度显示出最佳。另一方面,在AZO:SiO2的最佳厚度下,发现太阳能电池的开路电压(VOC)对AZO:SiO2的功函数或带隙相对不敏感。而对于填充因子(FF),不含SiO2的AZO是最佳选择。通过使用AZO/Al作为电子选择性接触,我们成功地实现了19.5%的效率的太阳能电池,VOC超过700 mV和FF约75%,这是使用ZnO作为电子选择性接触的c-Si太阳能电池中的最好结果。同时,本工作也暗示了用磁控溅射法可以制备出高效率的载流子选择性薄膜。
英文摘要:
In recent years, considerable efforts have been devoted to developing novel electron-selective materials for crystalline Si (c-Si) solar cells with the attempts to simplify the fabrication process and improve efficiency. In this study, ZnO:Al (AZO) is co-sputtered with SiO2 to form AZO:SiO2 films with different SiO2 content. These nanometer-scale films, deposited on top of thin intrinsic hydrogenated amorphous silicon films and capped with low-work-function metal (such as Al and Mg), are demonstrated to function effectively as electron-selective contacts in c-Si solar cells. On the one hand, AZO:SiO2 plays an important role in such electron-selective contact and its thickness is a critical parameter, thickness of 2 nm showing the best. On the other hand, at the optimal thickness of AZO:SiO2, the open circuit voltage (VOC) of the solar cells is found to be relatively insensitive to either the work function or the band gap of AZO:SiO2. Whereas, regarding the fill factor (FF), AZO without SiO2 content exhibits to be the optimal choice. By using AZO/Al as electron-selective contact, we successfully realize a 19.5%-efficient solar cell with VOC over 700 mV and FF around 75%, which is the best result among c-Si solar cells using ZnO as electron-selective contact. Also, this work implies that efficient carrier-selective film can be made by magnetron sputtering method.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。