When dealing with unsaturated wet granular materials, a fundamental question is: what is the effect of capillary cohesion on the bulk flow and yield behavior? We inwestigate the dense flow rheology of unsaturated granular materials through experiments and discrete element simulations of homogeneous, simple annular shear flows of frictional, cohesive, spherical particles.
Multi-phase flows encountered in nature or in industry, exhibit non trivial rheological properties, that can be understood better thanks to model materials and appropriate rheometers. Here, we use model unsaturated granular materials: assemblies of frictional spherical particles bonded by a small quantity of a wetting liquid, over a rough inclined plane. Our results show steady uniform flows for a wide range of parameters (the inclination angle and the mass flow-rate). A theoretical model, based on the Mohr-Coulomb yield criterion extended to inertial flows: $τ$ = $τ$c + $μ$(I)P, in which $τ$c…
We explore the rheology predicted by a recently proposed constitutive model for jammed suspensions of soft elastic particles derived from particle-level dynamics [Cuny et al., Phys. Rev. Lett. 127, 218003 (2021)]. Our model predicts that the orientation of the anisotropy of the microstructure, governed by an interplay between advection and contact elasticity, plays a key role at yielding and in flow. It generates normal stress differences contributing significantly to the yield criterion and Trouton ratio. It gives rise to non-trivial transients such as stress overshoots in step increases of s…
Hypothesis: Particle-laden fluid interfaces are the central component of many natural and engineering systems. Understanding the mechanical properties and improving the stability of such interfaces are of great practical importance. Janus particles, a special class of heterogeneous colloids, might be utilized as an effective surface-active agent to control the assembly and interfacial rheology of particle-laden fluid interfaces. Experiments: Using a custom-built interfacial stress rheometer, we explore the effect of Janus particle additives on the interfacial rheology and microscopic structure…
The rheological behavior of metallic alloys containing both solid and liquid phases is investigated in the low solid fraction range (<50%). This behavior depends on both the solid fraction and the shear rate. The concept of Effective Volume Fraction (EVF) is used to decorrelate the influence of these two parameters. At high shear rate the slurry behaves like a suspension of hard spheres, whereas at lower shear rate, particles tend to aggregate in clusters, entrapping liquid and thus, increasing the EVF and the viscosity. A lattice model is introduced to simulate the aggregation / break-up proc…
The microstructure and rheological properties of suspensions of neutrally buoyant hard spherical particles in Newtonian fluid under conditions of finite inertia are studied using the lattice-Boltzmann method (LBM), which is based on a discrete Boltzmann model for the fluid and Newtonian dynamics for the particles. The suspensions are subjected to simple-shear flow and the properties are studied as a function of Reynolds number and volume fraction, $ϕ$. The inertia is characterized by the particle-scale shear flow Reynolds number $Re = \frac{ρ\dotγa^{2}}μ$, where $a$ is the particle radius, $\d…
Recent studies have highlighted that oscillatory and time-dependent shear flows might help increase flowability of dense suspensions. While most focus has been on cross-flows we here study a simple two-dimensional suspensions where we apply simultaneously oscillatory and stationary shear along the same direction. We first show that the viscosities in this set-up significantly decrease with an increasing magnitude of the oscillations, contrary to previous claims. The decrease can be attributed to the large decrease in the number of contacts and an altered microstructure as the magnitude of the …
Magnetic nanoparticles in a colloidal solution self-assemble in various aligned structures, which has a profound influence on the flow behavior. However, the precise role of the microstructure in the development of the rheological response has not been reliably quantified. We investigate the self-assembly of dipolar colloids in simple shear using hybrid molecular dynamics and multi-particle collision dynamics simulations with explicit coarse-grained hydrodynamics; conduct simulated rheometric studies and apply micromechanical models to produce master curves, showing evidence of the universalit…
Under inhomogeneous flow, dense suspensions exhibit complex behaviour that violates the conventional homogenous rheology. Specifically, one finds flowing regions with a macroscopic friction coefficient below the yielding criterion, and volume fraction above the jamming criterion. We demonstrate the underlying physics by incorporating shear rate fluctuations into a recently proposed tensor model for the microstructure and stress, and applying the model to an inhomogeneous flow problem. The model predictions agree qualitatively with particle-based simulations.
Using mode-coupling theory, we derive a constitutive equation for the nonlinear rheology of dense colloidal suspensions under arbitrary time-dependent homogeneous flow. Generalizing previous results for simple shear, this allows the full tensorial structure of the theory to be identified. Macroscopic deformation measures, such as the Cauchy-Green tensors, thereby emerge. So does a direct relation between the stress and the distorted microstructure, illuminating the interplay of slow structural relaxation and arbitrary imposed flow. We present flow curves for steady planar and uniaxial elongati…
Rheology of dense suspensions of granular spherocylinders by particle-based simulation
School of Engineering, University of Edinburgh（爱丁堡大学工程学院）；Syngenta Jealott’s Hill International Research Centre（先正达乔洛特山国际研究中心）；School of Physics and Astronomy, The University of Edinburgh（爱丁堡大学物理与天文学院）
We study granular suspensions under a variety of extensional deformations and simple shear using numerical simulations. The viscosity and Trouton's ratio (the ratio of extensional to shear viscosity) are computed as functions of solids volume fraction $ϕ$ close to the limit of zero inertia. Suspensions of frictionless particles follow a Newtonian Trouton's ratio for $ϕ$ all the way up to $ϕ_0$, a universal jamming point that is independent of deformation type. In contrast, frictional particles lead to a deformation-type-dependent jamming fraction $ϕ_m$, which is largest for shear flows. Trouto…
Oscillatory shear has been widely used to study the rheological properties of suspensions under unsteady shear. Furthermore, recent works have shown that oscillatory flows can improve the flowability of dense suspensions. While most studies have been done under constant volume we here study oscillatory shear flows of a two-dimensional suspensions using a normal pressure-controlled set-up. To characterise the rheology, we introduce both a complex macroscopic friction coefficient $μ^{*}$, following the convention of the complex viscosity $η^{*}$, and a shear-rate averaged viscous number $J'$. Th…
The frequency dependence of third-harmonic medium amplitude oscillatory shear (MAOS) modulus $G_{33}^{*}(ω)$ provides insight into material behavior and microstructure in the asymptotically nonlinear regime. Motivated by the difficulty in the measurement of MAOS moduli, we propose a test for data validation based on nonlinear Kramers-Kronig relations. We extend the approach used to assess the consistency of linear viscoelastic data by expressing the real and imaginary parts of $G_{33}^{*}(ω)$ as a linear combination of Maxwell elements: the functional form for the MAOS kernels is inspired by t…
Single polymer dynamics offers a powerful approach to study molecular-level interactions and dynamic microstructure in materials. Direct visualization of single chain dynamics has uncovered new ideas regarding the rheology and non-equilibrium dynamics of macromolecules, including the importance of molecular individualism, dynamic heterogeneity, and molecular sub-populations that govern macroscale behavior. In recent years, the field of single polymer dynamics has been extended to increasingly complex materials, including architecturally complex polymers such as combs, bottlebrushes, and ring p…
A fundamental challenge for disordered solids is predicting macroscopic yield from the microscopic arrangements of constituent particles. Yield is accompanied by a sudden and large increase in energy dissipation due to the onset of plastic rearrangements. This suggests that one path to understanding bulk rheology is to map particle configurations to their mode of deformation. Here, we perform laboratory experiments and numerical simulations that are designed to do just that: 2D dense colloidal systems are subjected to oscillatory shear, and particle trajectories and bulk rheology are measured.…
Colloidal dispersions are commonly encountered in everyday life and represent an important class of complex fluid. Of particular significance for many commercial products and industrial processes is the ability to control and manipulate the macroscopic flow response of a dispersion by tuning the microscopic interactions between the constituents. An important step towards attaining this goal is the development of robust theoretical methods for predicting from first-principles the rheology and nonequilibrium microstructure of well defined model systems subject to external flow. In this review we…
The recoverable strain is shown to correlate to the temporal evolution of microstructure via time-resolved small-angle neutron scattering (SANS) and dynamic shear rheology. Investigating two distinct polymeric materials of wormlike micelles and fibrin network, we demonstrate that, in addition to the nonlinear structure-property relationships, the shear and normal stress evolution is dictated by the recoverable strain. A distinct sequence of physical processes under large amplitude oscillatory shear (LAOS) is identified that clearly contains information regarding both the steady-state flow curv…
In the vicinity of their glass transition, dense colloidal suspensions acquire elastic properties over experimental timescales. We investigate the possibility of a visco-elastic flow instability in curved geometry for such materials. To this end, we first present a general strategy extending a first-principles approach based on projections onto slow variables (so far restricted to strictly homogeneous flow) in order to handle inhomogeneities. In particular, we separate the advection of the microstructure by the flow, at the origin of a fluctuation advection term, from the intrinsic dynamics. O…
Extrusion is a widely used process for forming pastes into designed shapes, and is central to the manufacture of many industrial products. The extrusion through a square-entry die of a model paste of non-Brownian spheres suspended in a Newtonian fluid is investigated using discrete element simulations, capturing individual particle contacts and hydrodynamic interactions. The simulations reveal inhomogeneous velocity and stress distributions, originating in the inherent microstructure formed by the constituent particles. Such features are shown to be relevant to generic paste extrusion behaviou…
Univ Lyon, Ens de Lyon, CNRS, Laboratoire de Physique（里昂大学、巴黎高等师范学校里昂分校、法国国家科学研究中心、物理实验室）；Department of Polymer Engineering, IPC, University of Minho（米尼奥大学高分子工程系）
Soft materials such as colloidal suspensions, polymer solutions and liquid crystals are constituted by mesoscopic entities held together by weak forces. Their mechanical moduli are several orders of magnitude lower than those of atomic solids. The application of small to moderate stresses to these materials results in the disruption of their microstructures. The resulting flow is non-Newtonian and is characterised by features such as shear rate-dependent viscosities and non-zero normal stresses. This article begins with an introduction to some unusual flow properties displayed by soft matter. …
Foams made of complex fluids such as particle suspensions have a great potential for the development of advanced aerated materials. In this paper we study the rheological behavior of liquid foams loaded with granular suspensions. We focus on the effect of small particles, i.e. particle-to-bubble size ratio smaller than 0.1, and we measure the complex modulus as a function of particle size and particle volume fraction. With respect to previous work, the results highlight a new elastic regime characterized by unequaled modulus values as well as independence of size ratio. A careful investigation…
Our understanding of the elasticity and rheology of disordered materials, such as granular piles, foams, emulsions or dense suspensions relies on improving experimental tools to characterize their behaviour at the particle scale. While 2D observations are now routinely carried out in laboratories, 3D measurements remain a challenge. In this paper, we use a simple model system, a packing of soft elastic spheres, to illustrate the capability of X-ray microtomography to characterise the internal structure and local behaviour of granular systems. Image analysis techniques can resolve grain positio…
