We report an experimental and theoretical study of the global stability and nonlinear dynamics of vertical jets of viscous liquid confined in the axial direction due to their impact on a bath of the same liquid. Previous works demonstrated that in the absence of axial confinement the steady liquid thread becomes unstable due to an axisymmetric global mode for values of the flow rate, $Q$, below a certain critical value, $Q_c$, giving rise to oscillations of increasing amplitude that finally lead to a dripping regime (Sauter & Buggisch, J. Fluid Mech., 2005; Rubio-Rubio et al., J. Fluid Mech., 2013). Here we focus on the effect of the jet length, $L$, on the transitions that take place for decreasing values of $Q$. The linear stability analysis shows good agreement with our experiments, revealing that $Q_c$ increases monotonically with $L$, reaching the semi-infinite jet asymptote for large values of $L$. Moreover, as $L$ decreases a quasi-static limit is reached, whereby $Q_c \to 0$ and the neutral conditions are given by a critical length determined by hydrostatics. Our experiments have also revealed the existence of a new regime intermediate between steady jetting and dripping, in which the thread reaches a limit-cycle state without breakup. We thus show that there exist three possible states depending on the values of the control parameters, namely steady jetting, oscillatory jetting and dripping. For two different combinations of liquid viscosity, and injector radius, $R$, the boundaries separating these regimes have been determined in the $Q-L$ parameter plane, showing that steady jetting exists for small enough values of $L$ or large enough values of $Q$, dripping prevails for small enough values of $Q$ or sufficiently large values of $L$, and oscillatory jetting takes place in an intermediate region whose size increases with the liquid viscosity and decreases with $R$.
This paper presents the second-order perturbation theory of the Navier-Stokes equations for free surface flows, with the wave amplitude considered as the perturbation parameter. Gravity-capillary surface waves in incompressible viscous fluids are subjected. The results provide a systematic derivation of a nonlinear surface wave equation that fully takes into account dispersion, while nonlinearity is included in the leading order. However, the presence of infinitely many overdamped modes has been neglected, and only the two least damped modes are considered. Finally, to describe the elevations …
We discuss the impact of viscosity on nonlinear propagation of surface waves at the interface of air and a fluid of large depth. After a survey of the available approximations of the dispersion relation, we propose to modify the hydrodynamic boundary conditions to model both short and long waves. From them, we derive a nonlinear Schrödinger equation where both linear and nonlinear parts are modified by dissipation and show that the former plays the main role in both gravity and capillary-gravity waves while, in most situations, the latter represents only small corrections. This provides a just…
We propose a numerical approach to regularize the contact line singularity appearing in the computation of viscous capillary-gravity waves with moving contact line in cylindrical containers. The linearized Navier-Stokes equations are complemented by a macroscopic Navier-like slip condition on the container side wall, with a depth-varying slip-length bridging a free-slip condition at the contact line to a no-slip condition further away from the meniscus. In accordance with suggestions from the literature, this characteristic penetration depth is chosen as the typical Stokes layer thickness pert…
The aim of this study is to derive accurate models for quantities characterizing the dynamics of droplets of non-vanishing viscosity in capillaries. In particular, we propose models for the uniform-film thickness separating the droplet from the tube walls, for the droplet front and rear curvatures and pressure jumps, and for the droplet velocity in a range of capillary numbers, $Ca$, from $10^{-4}$ to $1$ and inner-to-outer viscosity ratios, $λ$, from $0$, i.e. a bubble, to high viscosity droplets. Theoretical asymptotic results obtained in the limit of small capillary number are combined with…
Capillary ripples on thin viscous films are important features of coating and lubrication flows. Here we present experiments based on Digital Holographic Microscopy, measuring the morphology of capillary ripples ahead of a viscous drop spreading on a prewetted surface with a nanoscale resolution. Our experiments reveal that upon increasing the spreading velocity, the amplitude of the ripples first increases and subsequently decreases. Above a critical spreading velocity, the ripples even disappear completely and this transition is accompanied by a divergence of the ripple wavelength. These obs…
Harnessing fluidic instabilities to produce structures with robust and regular properties has recently emerged as a new fabrication paradigm. This is exemplified in the work of Gumennik et al. [Nat. Comm. 4:2216, DOI: 10.1038/ncomms3216, (2013)], in which the authors fabricate silicon spheres by feeding a silicon-in-silica co-axial fiber into a flame. Following the localized melting of the silicon, a capillary instability of the silicon-silica interface induces the formation of uniform silicon spheres. Here, we try to unravel the physical mechanisms at play in selecting the size of these parti…
We study drop impacts on immiscible viscous liquid pool and investigate the formation of droplet surface craters using experimental and theoretical analysis. We attribute the formation of air craters to the rapid deceleration of the droplet due to viscous drag force. The droplet response to the external impulsive decelerating force induces oscillatory modes on the surface exposed to the air forming capillary waves that superimpose to form air craters of various shapes and sizes. We introduce a non-dimensional parameter ($Γ$), that is, the ratio of drag force to the capillary force acting on th…
The linear spatiotemporal stability properties of axisymmetric laminar capillary jets with fully developed initial velocity profiles are studied for large values of both the Reynolds number, $Re=Q/(π\,a\,ν)$, and the Froude number, $Fr=Q^2/(π^2\,g\,a^5)$, where $a$ is the injector radius, $Q$ the volume flow rate, $ν$ its kinematic viscosity, and $g$ the gravitational acceleration. The downstream development of the basic flow and its stability are addressed with an approximate formulation that takes advantage of the jet slenderness. The base flow is seen to depend on two parameters, namely a S…
Numerical studies of dimple and jet formation from a collapsing cavity often model the initial cavity shape as a truncated sphere, mimicking a bursting bubble. In this study, we present a minimal model containing only nonlinear inertial and capillary forces, which produces dimples and jets from a collapsing, capillary wave trough. The trough develops from an initial perturbation, chosen to be an eigen-mode to the linearised problem.We explain the physical mechanism of dimple formation and demonstrate that, for moderate steepness, the sharp dimple seen in simulations is well captured by the wea…
We study experimentally the dynamics and statistics of capillary waves forced by random steep gravity waves mechanically generated in laboratory. Capillary waves are produced here by gravity waves from nonlinear wave interactions. Using a spatio-temporal measurement of the free-surface, we characterize statistically the random regimes of capillary waves in the spatial and temporal Fourier spaces. For a significant wave steepness ($0.2-0.3$), power-law spectra are observed both in space and time, defining a turbulent regime of capillary waves transferring energy from large scale to small scale.…
Above a critical field strength, the free surface of an electrified, perfectly conducting viscous liquid, such as a liquid metal, is known to develop an accelerating protrusion resembling a cusp with a conic tip. Field self-enhancement from tip sharpening is reported to generate divergent power law growth in finite time of the forces acting in that region. Previous studies have established that tip sharpening proceeds via a self-similar process in two distinct limits - the Stokes regime at $\textsf{Re}=0$ and the inviscid regime $\textsf{Re} \to \infty$. Using finite element simulations to tra…
We report and discuss, by means of pore-scale numerical simulations, the possibility of achieving a directional-dependent two-phase flow behaviour during the process of invasion of a viscous fluid into anisotropic porous media with controlled design. By customising the pore-scale morphology and heterogeneities with the adoption of anisotropic triangular pillars distributed with quenched disorder, we observe a substantially different invasion dynamics according to the direction of fluid injection relative to the medium orientation, that is depending if the triangular pillars have their apex ori…
Experiments and global linear stability analysis are used to obtain the critical flow rate below which the highly stretched capillary jet generated when a Newtonian liquid issues from a vertically oriented tube, is no longer steady. The theoretical description, based on the one-dimensional mass and momentum equations retaining the exact expression of the interfacial curvature, accurately predicts the onset of jet self-excited oscillations experimentally observed for wide ranges of liquid viscosity and nozzle diameter. Our analysis, which extends the work by Sauter & Buggisch (2005), reveals th…
Liquid-infused surfaces (LIS) are a promising technique for reducing friction, fouling and icing in both laminar and turbulent flows. Previous work has demonstrated that these surfaces are susceptible to shear-driven drainage. Here, we report a different failure mode using direct numerical simulations of a turbulent channel flow with liquid-infused longitudinal grooves. When the liquid-liquid surface tension is small and/or grooves are wide, we observe traveling-wave perturbations on the interface with amplitudes larger than the viscous sublayer of the turbulent flow. These capillary waves ind…
We present pore-scale simulations of two-phase flows in a reconstructed fibrous porous layer. The three dimensional microstructure of the material, a fuel cell gas diffusion layer, is acquired via X-ray computed tomography and used as input for lattice Boltzmann simulations. We perform a quantitative analysis of the multiphase pore-scale dynamics and we identify the dominant fluid structures governing mass transport. The results show the existence of three different regimes of transport: a fast inertial dynamics at short times, characterised by a compact uniform front, a viscous-capillary regi…
Capillary invasion of a liquid into an empty tube, which is called capillary rise when the tube axis is in the vertical direction, is one of the fundamental phenomena representing capillary effects. Usually, the tube is actually filled with another pre-existing fluid, air, whose viscosity and inertia can be practically neglected. In this study, we considered the effect of the pre-existing fluid, when its viscosity is non-negligible, in a horizontally geometry. This geometry is free from gravity and thus simpler than the geometry of capillary rise. We observed the dynamics when a capillary tube…
We present experiments to study the relaxation of a nano-scale cylindrical perturbation at one of the two interfaces of a thin viscous free-standing polymeric film. Driven by capillarity, the film flows and evolves towards equilibrium by first symmetrizing the perturbation between the two interfaces, and eventually broadening the perturbation. A full-Stokes hydrodynamic model is presented which accounts for both the vertical and lateral flows, and which highlights the symmetry in the system. The symmetrization time is found to depend on the membrane thickness, surface tension, and viscosity.
In this letter, we describe the capillary sorting of particles by size based on dip coating. A substrate withdrawn from a liquid bath entrains a coating whose thickness depends on the withdrawal speed and the liquid properties. If the coating material contains particles, they will only be entrained when the viscous force pulling them with the substrate overcomes the opposing capillary force at the deformable meniscus. This force threshold occurs at different liquid thicknesses for particles of different sizes. Here, we show that this difference can be used to separate small particles from a mi…
We show that during evaporation of a pore network, liquid can refill the gas occupied pores, snapping off a gas bubble, which then moves to a stable configuration. This phenomenon is induced by the capillary instability due to the wettability heterogeneity of the pore network and has a much smaller time scale as compared to the evaporation process. The capillary instability induced liquid refilling and bubble movement are explained in detail based on the analysis of the images obtained from the visualization experiment. The capillary valve effect, which hinders the movement of the gas-liquid i…
Newtonian fluid invasion into a Yield-Stress Fluid-Saturated Medium
Université Paris-Saclay, CNRS, FAST（巴黎萨克雷大学，法国国家科学研究中心，FAST）；PoreLab, Department of Physics, Norwegian University of Science and Technology（孔隙实验室，挪威科技大学物理系）；Université Paris-Saclay, CNRS, LPTMS（巴黎萨克雷大学，法国国家科学研究中心，LPTMS）；PoreLab, Department of Physics, University of Oslo（孔隙实验室，奥斯陆大学物理系）
