We report a detailed ab initio study of two superlattice heterostructures, one component of which is a unit cell of CuPt ordered InSb_(0.5)As_(0.5). This alloy part of the heterostructures is a topological semimetal. The other component of each system is a semiconductor, zincblende-InSb, and wurtzite-InAs. Both heterostructures are semiconductors. Our theoretical analysis predicts that the variation in the thickness of the InSb layer in InSb/InSb_(0.5)As_(0.5) heterostructure renders altered band gaps with different characteristics (i.e. direct or indirect). The study holds promise for fabricating heterostructures, in which the modulation of the thickness of the layers changes the number of carrier pockets in these systems.
The article presents a mapping of the residual strain along the axis of InAs/InSb heterostructured nanowires. Using confocal Raman measurements, we observe a gradual shift in the TO phonon mode along the axis of these nanowires. We attribute the observed TO phonon shift to a residual strain arising from the InAs/InSb lattice mismatch. We find that the strain is maximum at the interface and then monotonically relaxes towards the tip of the nanowires. We also analyze the crystal structure of the InSb segment through selected area electron diffraction measurements and electron diffraction tomogra…
The structural and electronic properties in common anion (GaSb)_1/(InSb)_1 and common cation (InAs)_1/(InSb)_1 [111] ordered superlattices have been determined using the local density total energy full potential linearized augmented plane wave method. The influence of the ordering direction, strain conditions and atomic substitution on the electronic properties of technological and experimental interest (such as energy band-gaps and charge carrier localization in the different sublattices) were determined. The results show an appreciable energy band-gap narrowing compared to the band-gap avera…
In recent experiments, high Curie temperatures Tc above room temperature were reported in ferromagnetic semiconductors Fe-doped GaSb and InSb, while low Tc between 20 K to 90 K were observed in some other semiconductors with the same crystal structure, including Fe-doped InAs and Mn-doped GaSb, InSb, and InAs. Here we study systematically the origin of high temperature ferromagnetism in Fe, Mn, Cr-doped GaSb, InSb, and InAs magnetic semiconductors by combining the methods of density functional theory and quantum Monte Carlo. In the diluted impurity limit, the calculations show that the impurit…
First-principles full potential linearized augmented plane wave (FLAPW) calculations have been performed for lattice-mismatched common-atom III-V interfaces. In particular, we have examined the effects of epitaxial strain and ordering direction on the valence band offset in [001] and [111] GaSb/InSb and InAs/InSb superlattices, and found that the valence band maximum is always higher at the InSb side of the heterojunction, except for the common-anion system grown on an InSb substrate. The comparison between equivalent structures having the same substrate lattice constant, but different growth …
The properties of a semiconductor get drastically modified when the crystal point group symmetry is broken under an arbitrary strain. We investigate the family of semiconductors consisting of GaAs, GaSb, InAs and InSb, considering their electronic band structure and deformation potentials subject to various strains based on hybrid density functional theory. Guided by these first-principles results, we develop strain-compliant local pseudopotentials for use in the empirical pseudopotential method (EPM). We demonstrate that the newly proposed empirical pseudopotentials perform well close to band…
Using atomistic pseudopotential and configuration-interaction many-body calculations, we predict a metal-nonmetal transition and an excitonic ground state in the InAs/InSb quantum dot (QD) system. For large dots, the conduction band minimum of the InAs dot lies below the valence band maximum of the InSb matrix. Due to quantum confinement, at a critical size calculated here for various shapes, the single-particle gap $E_g$ becomes very small. Strong electron-hole correlation effects are induced by the spatial proximity of the electron and hole wavefunctions, and by the lack of strong (exciton u…
We present a first-principles study of the electronic and magnetic properties of epitaxial interfaces between the Heusler compounds Ti$_2$MnIn and Ni$_2$MnIn and the III-V semiconductors, InSb and InAs, respectively. We use density functional theory (DFT) with a machine-learned Hubbard $U$ correction determined by Bayesian optimization. We evaluate these interfaces for prospective applications in Majorana-based quantum computing and spintronics. In both interfaces, states from the Heusler penetrate into the gap of the semiconductor, decaying within a few atomic layers. The magnetic interaction…
A Dirac-type energy spectrum was demonstrated in gapless ultra-short-period metamorphic InAsSb/InSb superlattices by angle-resolved photoemission spectroscopy (ARPES_ measurements. The Fermi velocity value 7.4x10^5 m/s in a gapless superlattice with a period of 6.2nm is in a good agreement with the results of magneto-absorption experiments. An "inverted" bandgap opens in the center of the Brillouin zone at higher temperatures and in the SL with a larger period. The ARPES data indicate the presence of a surface electron accumulation layer
Realizing a large Landé $g$-factor of electrons in solid-state materials has long been thought of as a rewarding task as it can trigger abundant immediate applications in spintronics and quantum computing. Here, by using metamorphic InAsSb/InSb superlattices (SLs), we demonstrate an unprecedented high value of $g\approx 104$, twice larger than that in bulk InSb, and fully spin-polarized states at low magnetic fields. In addition, we show that the $g$-factor can be tuned on demand from 20 to 110 via varying the SL period. The key ingredients of such a wide tunability are the wavefunction mixing…
The electronic structure of surfaces plays a key role in the properties of quantum devices. However, surfaces are also the most challenging to simulate and engineer. Here, we study the electronic structure of InAs(001), InAs(111), and InSb(110) surfaces using a combination of density functional theory (DFT) and angle-resolved photoemission spectroscopy (ARPES). We were able to perform large-scale first principles simulations and capture effects of different surface reconstructions by using DFT calculations with a machine-learned Hubbard U correction [npj Comput. Mater. 6, 180 (2020)]. To facil…
The large Landé g-factor, high spin-orbit coupling, and low effective mass of the two-dimensional electron gas in InSb quantum wells combined with proximal superconductivity may realize a scalable platform for topological quantum computation. Aluminum thin films directly deposited on top of InSb planar structures result in the formation of a reactive AlInSb layer at the interface. This interlayer progressively consumes the whole Al film, resulting in a disordered AlInSb layer after few months at room temperature. We report on a heterostructure design that results in a significant increase of t…
We employ first-principles techniques tailored to properly describe semiconductors (modified Becke-Johnson potential added to the exchange-correlation functional), to obtain the electronic band structures of both the zinc-blende and wurtzite phases of GaAs, GaSb, InAs, and InSb. We extract the spin-orbit fields for the relevant valence and conduction bands at zone center, by fitting the spin-splittings resulting from the lack of space inversion symmetry of these bulk crystal structures, to known functional forms---third-order polynomials. We also determine the orientations of the spin-orbit ve…
We examine the possibility of intrinsic interface states bound to the plane of In-Sb chemical bonds at InAs/AlSb interfaces. Careful parameterization of the bulk materials in the frame of the extended basis spds^* tight-binding model and recent progress in predictions of band offsets severely limit the span of tight-binding parameters describing this system. We find that a heavy-hole like interface state bound to the plane of In-Sb bonds exists for a large range of values of the InSb/InAs band offset.
In the present work, we have investigated the performances of L shaped Vertical broken bandgapheterostructureInSb InAsn-channel tunnel field effect transistors TFETs of 4 nm thin channel structures with the gate lengths of 20nm. We have used a 3D full band, quantum mechanical simulator based on atomistic sp3d5s spin-orbital coupled tight binding method.In this L shaped nonlinear geometry the gate electric field and tunnel junction internal field are oriented in same direction. A broken narrow bandgap BG structure has another advantage that transport is by mixture of electrons holes. TFETs are …
We present a detailed x-ray diffraction study of the strain in InAs/GaSb superlattices grown by molecular beam epitaxy. The superlattices were grown with either InSb or GaAs interfaces. We show that the superlattice morphology, either planar or nanostructured, is dependent on the chemical bonds at the heterointerfaces. In both cases, the misfit strain has been determined for the superlattice layers and the interfaces. We also determined how the magnitude and sign of this strain is crucial in governing the morphology of the superlattice. Our analysis suggests that the growth of self-assembled n…
[111] ordered common atom strained layer superlattices (in particular the common anion GaSb/InSb system and the common cation InAs/InSb system) are investigated using the ab initio full potential linearized augmented plane wave (FLAPW) method. We have focused our attention on the potential line-up at the two sides of the homopolar isovalent heterojunctions considered, and in particular on its dependence on the strain conditions and on the strain induced electric fields. We propose a procedure to locate the interface plane where the band alignment could be evaluated; furthermore, we suggest tha…
We calculate the electronic and optical properties of InAs/InAs$_{0.625}$Sb$_{0.375}$ superlattices within relativistic density functional theory. To have a good description of the electronic and optical properties, the modified Becke-Johnson exchange-correlation functional is pondered to correctly approximate the band gap. First, we analyze electronic and optical characteristics of bulk InAs and InSb, and then we investigate the InAs/InAs$_{0.625}$Sb$_{0.375}$ superlattice. The optical gaps deduced from the imaginary part of the dielectric function are associated with the characteristic inter…
The quasiparticle band structures of four polytypes 3C, 6H, 4H, and 2H of GaP, GaAs, GaSb, InP, InAs, and InSb are computed with high accuracy including spin-orbit interaction applying a recently developed approximate calculation scheme, the LDA-1/2 method. The results are used to derive band offsets $ΔE_c$ and $ΔE_v$ for the conduction and valence bands between two polytypes. The alignment of the band structures is based on the branch-point energy $E_{\rm BP}$ for each polytype. The aligned electronic structures are used to explain properties of heterocrystalline but homomaterial junctions. T…
We have calculated band-edge energies for most combinations of zincblende AlN, GaN, InN, GaP, GaAs, InP, InAs, GaSb and InSb in which one material is strained to the other. Calculations were done for three different geometries, quantum wells, wires, and dots, and mean effective masses were computed in order to estimate confinement energies. For quantum wells, we have also calculated band-edges for ternary alloys. Energy gaps, including confinement, may be easily and accurately estimated using band energies and a simple effective mass approximation, yielding excellent agreement with experimenta…
Unveiling AlSb as a Promising Zincblende Semiconductor for Visible-Light Shift-Current Generation
Universidad de Guadalajara（瓜达拉哈拉大学）；Universidad de Sonora（索诺拉大学）；Centro de Investigaciones en Óptica A.C.（光学研究中心）；Universidad Autónoma de Zacatecas（萨卡特卡斯自治大学）；Universidad Politécnica de Tapachula（塔帕丘拉理工大学）
Despite the large number of theoretical III-V semiconductor studies reported every year, our atomistic understanding is still limited. The limitations of the theoretical approaches to yield accurate structural and electronic properties on an equal footing, due to the unphysical self-interaction problem that affects mainly the band gap and spin-orbit splitting (SOC) in semiconductors and, in particular, III-V systems with similar magnitude of the band gap and SOC. In this work, we will report a consistent study of the structural and electronic properties of the III-V semiconductors employing th…
Semiconductor Rashba nanowires are quasi-one dimensional systems that have large spin-orbit (SO) coupling arising from a broken inversion symmetry due to an external electric field. There exist parametrized multiband models that can describe accurately this effect. However, simplified single band models are highly desirable to study geometries of recent experimental interest, since they may allow to incorporate the effects of the low dimensionality and the nanowire electrostatic environment at a reduced computational cost. Commonly used conduction band approximations, valid for bulk materials,…
