通过在$200^o C,$下水解蔗糖溶液制备直径在$2 - 10 μm$范围内的碳球(CS),随后在$800^o C.$下在$N_2$中退火。在我们以前的工作中,CS和绝缘聚合物聚环氧乙烷(PEO)的复合样品的制备和它们的电荷传输进行了分析,在温度范围$ 80 K < T < 300 K. $在这里,我们分析了电荷传输CS涂有薄聚苯胺(PANi)膜掺杂盐酸(HCl),在相同的温度范围内。我们的目标是研究在CS中使用导电聚合物(PANi)作为粘合剂的电荷传输,并与CS/PEO发生比较。在CS/PEO复合材料中观察到电导率最大值,但在CS/PANi中不存在。我们的数据分析表明,在CS/PANi复合材料中,电子在聚合物链之间的可变程跳跃在CS/PANi复合材料中的传输中占据主导地位,而在CS/PEO复合材料中,电子仅通过直接隧穿穿过CS之间的间隙。这种传输机制的差异导致电导率的不同温度依赖性。
英文摘要:
Carbon spheres (CS) with diameters in the range $2 - 10 μm$ were prepared via hydrolysis of a sucrose solution at $200^o C,$ and later annealed in $N_2$ at $800^o C.$ The spheres were highly conducting but difficult to process into thin films or pressed pellets. In our previous work, composite samples of CS and the insulating polymer polyethylene oxide (PEO) were prepared and their charge transport was analyzed in the temperature range $ 80 K < T < 300 K. $ Here, we analyze charge transport in CS coated with a thin polyaniline (PANi) film doped with hydrochloric acid (HCl), in the same temperature range. The goal is to study charge transport in the CS using a conducting polymer (PANi) as a binder and compare with that occurring at CS/PEO. A conductivity maxima was observed in the CS/PEO composite but was absent in CS/PANi. Our data analysis shows that variable range hopping of electrons between polymeric chains in PANi-filled gaps between CS takes on a predominant part in transport through CS/PANi composites, whereas in CS/PEO composites, electrons travel through gaps between CS solely by means of direct tunneling. This difference in transport mechanisms results in different temperature dependences of the conductivity.
OpTiDDM (Optical Tweezers integrating Differential Dynamic Microscopy) maps the spatiotemporal propagation of nonlinear stresses in polymer blends and composites
Modeling phase separation in polymer-derived silicon carbonitride ceramics through extended machine learning molecular dynamics
Université de Strasbourg(斯特拉斯堡大学);Laboratoire ICube UMR 7357(ICube 实验室);ADYNMAT CNRS consortium(ADYNMAT CNRS 联盟);Institut de Physique et Chimie des Matériaux de Strasbourg, UMR 7504(斯特拉斯堡材料物理与化学研究所);Centre for Catalysis and Clean Energy, School of Environment and Science, Griffith University(格里菲斯大学环境与科学学院催化与清洁能源中心)