arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 1610.04148physics.plasm-ph
收藏

传导热输运中偏滤器区偏滤器加宽S的一维解析近似

Analytic 1D Approximation of the Divertor Broadening S in the Divertor Region for Conductive Heat Transport

Dirk Nille, Bernhard Sieglin, Thomas Eich

摘要:

主题是偏滤器加宽$S$,这是刮除层中垂直输运的结果,并导致偏滤器靶上功率负载的更好分布。最近的研究表明,偏滤器加宽的比例与逆幂律的目标温度$T_t$,有前途的减少是一种分配的权力进入偏滤器体积到一个大的表面积的方式。结果表明,在偏滤器区的纯导电输运建议逆幂律缩放到$T_t$只适用于高目标电子温度。对于降低的目标温度($T_t < 20\,$ eV),$S$的增加停滞,并且即使对于零目标温度,导电模型也导致$S$的有限值。得出的结论是,目标温度是没有有效的参数幂律缩放,因为它是不代表整个偏滤器体积。这在求解2D热扩散方程的模拟中示出,该方程用作描述偏滤器沿着场线仅通过垂直扩散率与平行扩散率的比率加宽的分析1D模型的参考。通过假设这两个量的温度依赖性的积分形式的$S$导出,仅依赖于沿X点和目标之间的分界线的温度分布。沿分界线积分的结果在一个近似的$S$,与2D模拟一致。该模型也适用于包括热损失的情况,例如由于辐射。对于高再循环条件,对流输送不能被忽略,因此推导出的$S$的表达式预计不成立。然而,基于非零的平行输运,相应的有限的平行输运时间,偏滤器加宽预计将达到一个有限的值。

英文摘要:

Topic is the divertor broadening $S$, being a result of perpendicular transport in the scrape-off layer and resulting in a better distribution of the power load onto the divertor target. Recent studies show a scaling of the divertor broadening with an inverse power law to the target temperature $T_t$, promising its reduction to be a way of distributing the power entering the divertor volume onto a large surface area. It is shown that for pure conductive transport in the divertor region the suggested inverse power law scaling to $T_t$ is only valid for high target electron temperatures. For decreasing target temperatures ($T_t < 20\,$eV) the increase of $S$ stagnates and the conductive model results in a finite value of $S$ even for zero target temperature. It is concluded that the target temperature is no valid parameter for a power law scaling, as it is not representative for the entire divertor volume. This is shown in simulations solving the 2D heat diffusion equation, which is used as reference for an analytic 1D model describing the divertor broadening along a field line solely by the ratio of the perpendicular to the parallel diffusivity. By assuming the temperature dependence of these two quantities an integral form of $S$ is derived, relying only on the temperature distribution along the separatrix between X-point and target. Integration along the separatrix results in an approximation for $S$, being in agreement with the 2D simulations. This model is also applicable to scenarios including heat losses, e.g. due to radiation. Convective transport can not be neglected for high recycling conditions, hence the derived expression for $S$ is not expected to hold. However, based on the non-vanishing parallel transport, respective the finite parallel transport time, the divertor broadening is expected to reach a finite value.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑