Application of a negative field on a positively poled ferroelectric sample can enhance the electrocaloric cooling and appears as a promising method to optimize the electrocaloric cycle. Experimental measurements show that the maximal cooling does not appear at the zero-polarization point, but around the shoulder of the P-E loop. This phenomenon cannot be explained by the theory based on the constant total entropy assumption under adiabatic condition. In fact, adiabatic condition does not imply constant total entropy when irreversibility is involved. A direct entropy analysis approach based on work loss is proposed in this work, which takes the entropy contribution of the irreversible process into account. The optimal reversed field determined by this approach agrees with the experimental observations. This study signifies the importance of considering the irreversible process in the electrocaloric cycles.
Giant electrocaloric (EC) effect is observed in BaTiO3 multilayer thick film structure. The temperature change is as high as 4.0 oC under an applied electric field of 352 kV/cm. Most importantly, the EC effect is found to depend on the varying rate of the applied field. Based on the giant net cooling (~0.37 J/g) resulting from the difference in the varying rates of rising and falling fields, the kinetic EC effect provides an effective solution for the design of refrigeration cycle in ferroelectric micro-refrigerator.
Over the past decades, there has been significant interest in new cooling technology based on the electrocaloric effect. The large electrocaloric effect observed in polymeric and inorganic ferroelectric materials made possible development of dielectric cooling devices of a new generation. We report a significant impact of annealing on the electrocaloric effect observed in 12/65/35 PLZT bulk ceramics. The electrocaloric data were obtained by direct measurements. Electrocaloric results confirm the existence of the significant electrocaloric response in this relaxor ferroelectric PLZT composition…
An improved thermodynamic cycle is proposed, where the cooling effect of an electrocaloric refrigerant is enhanced by applying a reversed electric field. In contrast to conventional adiabatic heating or cooling by on-off cycles of the external electric field, applying a reversed field is significantly improving the cooling efficiency, since the variation in configurational entropy is increased. By comparing results from computer simulations using Monte-Carlo algorithms and experiments using direct electrocaloric measurements, we show that the electrocaloric cooling efficiency can be enhanced b…
Refrigeration systems based on compression of greenhouse gases are environmentally threatening and cannot be scaled down to on-chip dimensions. In the vicinity of a phase transition caloric materials present large thermal responses to external fields, which makes them promising for developing alternative solid-state cooling devices. Electrocaloric effects are particularly well-suited for portable refrigeration applications; however, most electrocaloric materials operate best at non-ambient temperatures or require the application of large electric fields. Here, we predict that modest electric f…
We report a heat dynamics analysis of the electrocaloric effect (ECE) in commercial multilayer capacitors based on BaTiO3 dielectric, a promising candidate for applications as a solid state cooling device. Direct measurements of the time evolution of the sample's temperature changes under different applied voltages allow us to decouple the contributions from Joule heating and from the ECE. Heat balance equations were used to model the thermal coupling between different parts of the system. Fingerprints of Joule heating and the ECE could be resolved at different time scales. We argue that Joule…
There is growing interest in heat pumps based on materials that show thermal changes when phase transitions are driven by changes of electric, magnetic or stress field. Importantly, regeneration permits sinks and loads to be thermally separated by many times the changes of temperature that can arise in the materials themselves. However, performance and parameterization are compromised by net heat transfer between caloric working bodies and heat transfer fluids. Here we show that this net transfer can be avoided-resulting in true, balanced regeneration-if one varies the applied electric field w…
We analyse the effects of applying an electric field on the critical temperature, Ts, at which superionicity appears in archetypal fast ion conductor CaF2 by means of molecular dynamics simulations. We find that the onset of superionicity can be reduced by about 100K when relatively small electric fields of ~50KV/cm are employed. Under large enough electric fields, however, ionic conductivity is depleted. The normal to superionic phase transition is characterised by a large increase of entropy, thereby sizeable electrocaloric effects can be realised in fast ion conductors that are promising fo…
Ferroelectric perovskite oxides possess a large electrocaloric (EC) effect, but usually at high temperatures near the ferroelectric/paraelectric phase transition temperature, which limits their potential application as next-generation solid-state cooling devices. We use classical molecular dynamics to study the electric field induced phase transitions and EC effect in PMN-PT (PbMg1/3Nb2/3O3-PbTiO3). We find that the maximum EC strength of PMN-PT occurs within the morphotropic phase boundary (MPB) region at 300 K. The large adiabatic temperature change is caused by easy rotation of polarization…
The existence and feasibility of the multicaloric, polycrystalline material 0.8Pb(Fe1/2Nb1/2)O3-0.2Pb(Mg1/2W1/2)O3, exhibiting magnetocaloric and electrocaloric properties, are demonstrated. Both the electrocaloric and magnetocaloric effects are observed over a broad temperature range below room temperature. The maximum magnetocaloric temperature change of ~0.26 K is obtained with a magnetic-field amplitude of 70 kOe at a temperature of 5 K, while the maximum electrocaloric temperature change of ~0.25 K is obtained with an electric-field amplitude of 60 kV/cm at a temperature of 180 K. The mat…
There is a surge of interest in developing environmentally friendly cooling technology based on the solid--state electrocaloric effect (ECE). Here, we point out that negative ECE with a fast cooling rate ($\approx$10$^{11}$ K/s) can be achieved by driving solid crystals to a high--temperature phase with a properly designed electric field pulse. Specifically, we predict that an ultrafast electric field pulse can cause a negative ECE up to 35 K in PbTiO$_3$ occurring on few picosecond time scales. We acquire and analyze these results by clarifying the mechanism of ECE during an adiabatic irrever…
Due to critical environmental and technological issues, there is a pressing need to switch from current refrigeration methods based on compression of gases to novel solid-state cooling technologies. Solid-state cooling is based on the thermal response of materials to external magnetic, electric, or mechanic fields, the so-called caloric effect. The electrocaloric (EC) effect, which is caused by electric fields and typically occurs in polar materials, is particularly promising from a technological point of view owing to its good scalability and natural implementation in circuitry. Simulation of…
In this study, we report on a direct measurement method for the electrocaloric effect, the heating/cooling upon application/removal of an electric field in dielectric materials, based on a lock-in thermography technique. By use of sinusoidal excitation and multi-harmonic detection, the actual temperature change can be measured by a single measurement in the frequency domain even when the electrocaloric effect shows nonlinear response to the excitation field. We have demonstrated the method by measuring the temperature dependence of the electric-field-induced temperature change for two Sr-doped…
We report the discovery of serendipitous electrocaloric effects in commercial multilayer capacitors based on ferroelectric BaTiO3. Direct thermometry records ~0.5 K changes due to 300 kV cm-1, over a wide range of temperatures near and above room temperature. Similar results are obtained indirectly, via thermodynamic analysis of ferroelectric hysteresis loops. We compare and contrast these two results. Optimised electrocaloric multilayer capacitors could find applications in future cooling technologies.
In acceptor doped ferroelectrics and in ferroelectric films and nanocomposites, defect dipoles, strain gradients, and the electric boundary conditions at interfaces and surfaces often impose internal bias fields. In this work we delicately study the impact of internal bias fields on the electrocaloric effect (ECE), utilizing an analytical model and \emph{ab initio}-based molecular dynamics simulations. We reveal the complex dependency of the ECE on field protocol and relative strength of internal and external fields. The internal fields may even reverse the sign of the response (inverse or neg…
Electrocaloric (EC) materials show promise in eco-friendly solid-state refrigeration and integrable on-chip thermal management. While direct measurement of EC thin-films still remains challenging, a generic theoretical framework for quantifying the cooling properties of rich EC materials including normal-, relaxor-, organic- and anti-ferroelectrics is imperative for exploiting new flexible and room-temperature cooling alternatives. Here, we present a versatile theory that combines Master equation with Maxwell relations and analytically relates the macroscopic cooling responses in EC materials …
Robust Electrocaloric Performance Enabled by Highly-Polar Frustrated Nanodomains in NaNbO3-Based Ferrodistortive Relaxor
Institutes of Physical Science and Information Technology, Leibniz International Joint Research Center of Materials Sciences of Anhui Province, Anhui University（安徽大学物理科学与信息技术学院，安徽省材料科学莱布尼茨国际联合研究中心）；School of Materials Science and Engineering, Hainan University（海南大学材料科学与工程学院）；Department of Physics, University of Science and Technology Beijing（北京科技大学物理系）；Hunan Provincial Key Laboratory of Thin Film Materials and Devices, School of Materials Science and Engineering, Xiangtan University（湘潭大学材料科学与工程学院薄膜材料与器件湖南省重点实验室）；Laboratory of Dielectric Functional Materials, School of Materials Science and Engineering, Anhui University（安徽大学材料科学与工程学院介电功能材料实验室）；Institute for Superconducting and Electronic Materials, Australian Institute for Innovative Materials, University of Wollongong（伍伦贡大学澳大利亚创新材料研究所超导与电子材料研究院）
The magneto-electrocaloric effect which can be defined as the coupling between magnetocaloric and electrocaloric effects attracts currently considerable attention due to the advantages provided by the caloric effect in designing solid-state refrigeration technologies. The magneto-electrocaloric effect of a multiferroic antiferromagnetic spin system with the Dzyaloshinskii Moriya (DM) interaction is investigated in this paper. The DM interaction is assimilated to a coupling between an external site-dependent electric field and a local electric polarization. The external magnetic is also conside…
Using Landau-Ginzburg-Devonshire theory and effective medium approximation, we analytically calculate typical dependences of the pyroelectric and electrocaloric coefficients on external electric field, temperature and radius for spherical single-domain ferroelectric nanoparticles. The considered physical model corresponds to the nanocomposite with small fraction of ferroelectric nanoparticles. Within the framework of the analytical model we establish how the size changes determine the temperature and field behavior pyroelectric and electrocaloric coefficients on example of BaTiO3 nanoparticles…
A material with reversible temperature change capability under an external electric field, known as the electrocaloric effect (ECE), has long been considered as a promising solid-state cooling solution. However, electrocaloric (EC) performance of EC materials generally is not sufficiently high for real cooling applications. As a result, exploring EC materials with high performance is of great interest and importance. Here, we report on the ECE of ferroelectric materials with van der Waals layered structure (CuInP2S6 or CIPS in this work in particular). Over 60% polarization charge change is ob…
The influence of defect dipoles on the electrocaloric effect (ECE) in acceptor doped BaTiO$_3$ is studied by means of lattice-based Monte-Carlo simulations. A Ginzburg-Landau type effective Hamiltonian is used. Oxygen vacancy-acceptor associates are described by fixed defect dipoles with orientation parallel or anti-parallel to the external field. By a combination of canonical and microcanoncial simulations the ECE is directly evaluated. Our results show that in the case of anti-parallel defect dipoles the ECE can be positive or negative depending on the density of defect dipoles. Moreover, a …
The advent of caloric materials for magnetocaloric, elastocaloric, and electrocaloric cooling is changing the landscape of solid state cooling technologies with potentials for high-efficiency and environmentally-friendly residential and commercial cooling as well as heating applications. Given that caloric materials are ferroic materials which undergo first (or second) order transitions near room temperature, they open up intriguing possibilities for novel multiferroic devices with hitherto unexplored functionalities coupling their thermal properties with different fields (magnetic, electric, …
In the framework of solid-state cooling technology, four kinds of caloric effects, magnetocaloric (MC), electrocaloric (EC), barocaloric (BC) and elastocaloric (eC) effects, are compared in view of environment discussion and application fields. This field is primarily developed in the intention of protecting the environment. However, some widely researched caloric materials do not meet environmental friendly criteria. Currently, new caloric materials (called "good" material) possessing the properties of friendly environment, low cost, high caloric performance and practicability (low stress) ne…
Due to critical environmental issues there is a pressing need to switch from current refrigeration methods based on compression of greenhouse gases to novel solid-state cooling technologies. Solid-state cooling capitalizes on the thermal response of materials to external fields named "caloric effect". The barocaloric (BC) effect driven by hydrostatic pressure is particularly promising from a technological point of view since typically presents larger cooling potential than other caloric variants (e.g., magnetocaloric and electrocaloric effects driven by magnetic and electric fields, respective…
Magnetic properties of polycrystalline Sm0.1Ca0.84Sr0.06MnO3 in pristine and metastable states have been investigated in wide range of temperatures and magnetic fields. It was found that below Curie temperature TC = 105 K the pristine state exhibits phase separation comprising ferromagnetic and antiferromagnetic phases. The metastable states with reduced magnetization were obtained by successive number of quick coolings of the sample placed in container with kerosene-oil mixture. By an increasing number of quick coolings (> 6) the long time relaxation appeared at 10 K and the magnetization rev…
