We numerically propose a scheme for realizing an all-optical femtosecond soliton diode based on a tailored heterojunction Bragg grating, which is designed by two spatially asymmetric chirped cholesteric liquid crystals. Our simulations demonstrate that with the consideration of optical nonlinearity, not only the femtosecond diode effect with nonreciprocal transmission ratio up to 120 can be achieved, but also the optical pulse evolving into soliton which maintains its shape during propagation through the sample is observed. Further, the influence of pulse width and the carrier wavelength to the femtosecond diode effect is also discussed in detail. Our demonstrations might suggest a new direction for experimentally realizing the femtosecond soliton diode based on the cholesteric liquid crystals.
Direct compression of femtosecond optical pulses from a Ti:sapphire laser oscillator was realized with a cholesteric liquid crystal acting as a nonlinear 1D periodic Bragg grating. With a 6-um thick sample, the pulse duration could be compressed from 100 to 48 femtoseconds. Coupled-mode equations for forward and backward waves were employed to simulate the dynamics therein and good agreement between theory and experiment was obtained.
Femtosecond laser writing is applied to form Bragg grating waveguides in the diamond bulk. Type II waveguides are integrated with a single pulse point-by-point periodic laser modification positioned towards the edge of the waveguide core. These photonic devices, operating in the telecommunications band, allow for simultaneous optical waveguiding and narrowband reflection from a 4th order grating. This fabrication technology opens the way towards advanced 3D photonic networks in diamond for a range of applications.
We propose an efficient method to determine the effective refractive index of step-index optical fibers from the visible to the mid-IR and thus allowing to infer their dispersive properties over a broad spectral range. The validity of the method, based on the writing of an array of fiber Bragg gratings (FBGs) with known periods using the fs scanning phase mask technique, is first confirmed with a standard silica fiber, then applied to various fluoride glass fibers to determine their effective refractive index and dispersion over more than three octaves, i.e. from 550 to 4800 nm.
We demonstrate apodized fiber Bragg gratings inscribed with a point-by-point technique. We tailor the grating phase and coupling amplitude through precise control over the longitudinal and transverse position of each laser-inscribed modification. This method of apodization is facilitated by the highly-localized, high-contrast modifications generated by focussed IR femtosecond laser inscription. Our technique provides a simple method for the design and implementation of point-by-point fiber Bragg gratings with complex apodization profiles.
We report the fabrication and performance of the first C-band directly-written monolithic waveguide-laser. The waveguide-laser device was created in an Erbium and Ytterbium doped phosphate glass host and consisted of an optical waveguide that included a distributed feedback Bragg grating structure. The femtosecond laser direct-write technique was used to create both the waveguide and the waveguide-Bragg grating simultaneously and in a single processing step. The waveguide-laser was optically pumped at approximately 980 nm and lased at 1537nm with a bandwidth of less than 4 pm.
We present here the inscription of single-mode waveguides with Bragg gratings in sapphire. The waveguide Bragg gratings have a novel multi-layer depressed cladding design in the 1550 nm telecommunications waveband. The Bragg gratings have a narrow bandwidth (<0.5 nm) and have survived annealing at 1000°C. The structures are inscribed with femtosecond laser direct writing, using adaptive beam shaping with a non-immersion objective. A single-mode sapphire fiber Bragg grating is created by writing a waveguide with a Bragg grating within a 425 μm diameter sapphire optical fiber, providing signific…
Comparative analysis of fiber Bragg grating filter losses inscribed by continuous wave UV and femtosecond-IR lasers for astrophotonics
Leibniz Institute for Astrophysics Potsdam（波茨坦阿斯特罗物理莱布尼茨研究所）；Friedrich Schiller University Jena（耶拿弗里德里希·席勒大学）；National Astronomical Research Institute of Thailand（泰国国家天文研究所）；University of Potsdam（波茨坦大学）；Technische Universität Berlin（柏林工业大学）
The first demonstration of narrowband spectral filtering of multimode light on a 3D integrated photonic chip using photonic lanterns and waveguide Bragg gratings is reported. The photonic lanterns with multi-notch waveguide Bragg gratings were fabricated using the femtosecond direct-write technique in boro-aluminosilicate glass (Corning, Eagle 2000). Transmission dips of up to 5 dB were measured in both photonic lanterns and reference single-mode waveguides with 10.4-mm-long gratings. The result demonstrates efficient and symmetrical performance of each of the gratings in the photonic lantern.…
Structured light, in particular light possessing orbital angular momentum (OAM), has been actively studied in recent decades. Helical Bragg grating (HBG) is a reflecting optical element, which predicted to be able to convert the OAM of light in waveguides and fibers. However, the HBG has not been demonstrated experimentally yet. Here we report the first experimental manifestation of HBG created in the form of a waveguide with depressed-index cladding. Few-mode channel helical-depressed-cladding waveguides (HDCWs) have been written in a YAG crystal by a femtosecond laser beam. The HDCW pitches …
Ultrafast Nano-Imaging and Optical Control of Hyperbolic Phonon Polaritons at hBN/WS$_2$ Heterojunctions
Institute for Molecular Science, National Institutes of Natural Sciences（国立自然科学研究所分子科学研究所）；Department of Physics and Electronics, Graduate School of Engineering, Osaka Metropolitan University（大阪公立大学工学研究科物理电子学专业）；The Graduate University for Advanced Studies, SOKENDAI（日本高级研究院）；Research Center for Materials Nanoarchitectonics, National Institute for Materials Science（国立材料研究所物质结构纳米构造研究中心）；Research Center for Electronic and Optical Materials, National Institute for Materials Science（国立材料研究所电子光学材料研究中心）；Fritz-Haber-Institut der Max-Planck-Gesellschaft（马克斯·普朗克学会弗里茨·哈伯研究所）
Integrated femtosecond pulse and frequency comb sources are critical components for a wide range of applications. The leading approaches for on-chip pulse generation rely on mode locking inside microresonator with either third-order nonlinearity or with semiconductor gain. These approaches, however, are limited in noise performance, wavelength tunability and repetition rates. Alternatively, sub-picosecond pulses can be synthesized without mode-locking, by modulating a continuous-wave (CW) single-frequency laser using a cascade of electro-optic (EO) modulators. This method is particularly attra…
Prior to the invention of holography or lasers, Bragg's X-ray microscope opened the door to optical computation in short-wavelength studies using spatially coherent visible light, including phase retrieval methods. This optical approach lost ground to semiconductor detection and digital computing in the 1960s. Since then, visible optics including spatial light modulators (SLMs), array detectors and femtosecond lasers have become widely available, routinely allowing versatile and computer-interfaced imposition of optical phase, molecular coherent control, and detection. Today, high brilliance X…
Third harmonic generation microscopy has been used to analyze the morphology of photonic structures created using the femtosecond laser direct-write technique. Three dimensional waveguide arrays and waveguide-Bragg gratings written in fused-silica and doped phosphate glass were investigated. A sensorless adaptive optical system was used to correct the optical aberrations occurring in the sample and microscope system, which had a lateral resolution of less than 500 nm. This non-destructive testing method creates volume reconstructions of photonic devices and reveals details invisible to other l…
A fully integrated dispersion-managed femtosecond mode-locked laser
Institute of Physics, Swiss Federal Institute of Technology Lausanne (EPFL)（洛桑联邦理工学院物理研究所）；Institute of Electrical and Micro Engineering, Swiss Federal Institute of Technology Lausanne (EPFL)（洛桑联邦理工学院电气与微工程学院）；EDWATEC SA（EDWATEC公司）；Helmholtz-Zentrum Dresden-Rossendorf (HZDR)（德累斯顿-罗森多夫亥姆霍兹中心）
Diffusion of heat in metals is a fundamental process which is crucial for a variety of applications of metal nanostructures. Surprisingly, however, {\em ultrafast} heat diffusion received only limited attention so far. Here, we show that heat diffusion can be made faster than $e-ph$ energy transfer rate, in which case, it dominates the spatio-temporal dynamics of the temperature. This enables the metals to overcome the conventional limitations of the nonlinear optical response of materials - it can be simultaneously fast and strong. As a specific example, we identify the underlying (femtosecon…
Hybrid plasmonic photonic structures combine the plasmonic response with the photonic band gap, holding promise for utilization as optical switches and sensors. Here, we demonstrate the active modulation of the optical response in such structures with two different external stimuli, e.g. laser pulses and bacteria. First, we report the fabrication of a miniaturized (5 x 5 mm) indium tin oxide (ITO) grating employing femtosecond laser micromachining, and we show the possibility to modulate the photonic band gap in the visible via ultrafast photoexcitation in the infrared part of the spectrum. No…
One-dimensional (1D) metal-dielectric (MD) periodic structures take advantage of large refractive index contrast between metal and dielectrics to invoke extremely high nonlinear ultrafast responses of metal. These structures are also special due to their extremely high laser damage threshold. The Bragg like 1D MD structure (Ag/SiO2)4 enables strong optical field confinement with much enhanced nonlinear features as compared to simple metal or single (Ag/SiO2)1 structure. In the present work, the ultrafast nonlinear optical responses of the above structures are investigated via femtosecond broad…
