Suppression of Vertical Oscillation and Observation of Flux Improvement during Top-up Injection at PLS-II

Effects of Elliptically Polarizing Undulator on Beam Dynamics in PLS-II

The non-linear effects caused by the intrinsic field transverse roll-off in an Elliptically Polarizing Undulator with 72-mm period and maximum peak field of 0.72 T (EPU72) on the dynamics aperture of the Pohang Light Source II (PLS-II) were investigated. A kick map and Frequency map analysis both demonstrated that EPU72 will not reduce the lifetime or cause injection problems in PLS-II.

Beam Emittance Measurement for PLS-II Linac

The PLS-II has a 100 MeV pre-injector for the 3 GeV Linac. A thermionic gun produces electron charge of 200 pC with a bunch duration of 500 ps by a 250 ps triggering pulser. At the pre-injector, one of the most important beam parameters to identify the beam quality is a transverse emittance of electron bunches. Therefore we measure the beam emittance and twiss functions at 100 MeV in order to match the beam optics to beam transport line and go through it to the storage ring. To get the transverse emittance measurement, well-known technique, quadrupole scan, is used at the pre-injector. The emi…

Physical Design of Superconducting Magnet for ADS Injection I

Superconducting solenoid magnet prototype for ADS Injection I had been designed and fabricated, and also had been tested in liquid Helium state inside a vertical Dewar in Haerbin institute of Technology in Nov. 2012. The design current is 210A, when the test current reached 400A no quench occurred, the solenoid magnet was forced to quench by the embedded heaters. The integral field strength, leakage field at the nearby upstream and downstream superconducting spoke cavities all meet the design requirements. At the same time, it also checked the system reliability of the vertical test Dewar and …

An ultimate storage ring lattice with vertical emittance generated by damping wigglers

We discuss the approach of generating round beams for ultimate storage rings using vertical damping wigglers (with horizontal magnetic field). The vertical damping wigglers provide damping and excite vertical emittance. This eliminates the need to generate large linear coupling that is impractical with traditional off-axis injection. We use a PEP-X compatible lattice to demonstrate the approach. This lattice uses separate quadrupole and sextupole magnets with realistic gradient strengths. Intrabeam scattering effects are calculated. The horizontal and vertical emittances are 22.3 pm and 10.3 p…

FCC-ee中使用多极注入冲击磁铁的同轴补充注入

On-axis top-up injection with multipole injection kicker in FCC-ee

本研究针对FCC-ee的同轴补充注入，提出补偿型多极注入冲击磁铁方案，可将Z模式下循环束水平发射度增长控制在约7%、垂直方向低于2%，是有潜力的候选方案。

Concept for controlled transverse emittance transfer within a linac ion beam

For injection of beams into circular machines with different horizontal and vertical emittance acceptance, the injection efficiency can be increased if these beams are flat, i.e. if they feature unequal transverse emittances. Generation of flat electron beams is well known and has been demonstrated already in beam experiments. It was proposed also for ion beams that were generated in an Electron Cyclotron-Resonance (ECR) source. We introduce an extension of the method to beams that underwent charge state stripping without requiring their generation inside an ECR source. Results from multi-part…