arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 1602.03701physics.ins-detphysics.optics
收藏

低噪声外差干涉测量中的一种简单数字测相算法

Simple digital phase-measuring algorithm for low-noise heterodyne interferometry

Wataru Kokuyama, Hideaki Nozato, Akihiro Ohta, Koichiro Hattori

摘要:

我们提出了一种数字算法,用于测量两个正弦信号之间的相位差,结合修改后的条纹计数方法与两个样本过零点,使顺序信号处理。该技术可应用于高分辨率动态相位差测量,特别是外差干涉测量。从使用电气设备的演示中获得的本底噪声在高于约0.1 Hz的频率下为$5\times10^{-8} \mathrm{rad/\sqrt{Hz}}$。此外,通过将该方法应用于商用外差干涉仪,从4 kHz到1 MHz的本底噪声电平被确认为$7\times10^{-14} \mathrm{m/\sqrt{Hz}}$。我们还通过与标准零差干涉仪测量大于5000 m/s^2的冲击运动峰值加速度和10 mm行程的结果进行比较,证实了该算法的有效性。

英文摘要:

We present a digital algorithm for measuring the phase difference between two sinusoidal signals that combines the modified fringe-counting method with two-sample zero crossing to enable sequential signal processing. This technique can be applied to a phase meter for measuring dynamic phase differences with high resolution, particularly for heterodyne interferometry. The floor noise obtained from a demonstration with an electrical apparatus is $5\times10^{-8} \mathrm{rad/\sqrt{Hz}}$ at frequencies above approximately 0.1 Hz. In addition, by applying this method to a commercial heterodyne interferometer, the floor-noise level is confirmed to be $7\times10^{-14} \mathrm{m/\sqrt{Hz}}$ from 4 kHz to 1 MHz. We also confirm the validity of the algorithm by comparing its results with those from a standard homodyne interferometer for measuring shock-motion peak acceleration greater than 5000 m/s^2 and a 10 mm stroke.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑