arXivDaily arXiv每日学术速递 周一至周五更新
arXiv周末暂无论文更新,休息一下吧,周末愉快~~
arXiv 1410.0885cs.RO
收藏

基于加速度计测量的六维力/力矩传感器现场标定

In Situ Calibration of Six-Axes Force Torque Sensors using Accelerometer Measurements

Istituto Italiano di Tecnologia(意大利理工学院)

Silvio Traversaro, Daniele Pucci, Francesco Nori

摘要:

本文提出了校准六维力-扭矩传感器的技术,这些技术可以在现场进行,即,而不需要从主机系统移除传感器。我们假设力-扭矩传感器被附接到配备有加速度计的刚性体。然后,建议的校准技术使用的加速度计的测量,但既不需要惯性参数的知识,也不需要的刚体的取向。所提出的方法利用传感器的原始测量值和相应的力-扭矩之间的模型引起的几何形状。通过对iCub人形机器人的两个六维力-力矩传感器进行标定,验证了该方法的有效性。

英文摘要:

This paper proposes techniques to calibrate six-axis force-torque sensors that can be performed in situ, i.e., without removing the sensor from the hosting system. We assume that the force-torque sensor is attached to a rigid body equipped with an accelerometer. Then, the proposed calibration technique uses the measurements of the accelerometer, but requires neither the knowledge of the inertial parameters nor the orientation of the rigid body. The proposed method exploits the geometry induced by the model between the raw measurements of the sensor and the corresponding force-torque. The validation of the approach is performed by calibrating two six-axis force-torque sensors of the iCub humanoid robot.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑