Using an identity, directly derived from the Young-Laplace equation, the problem of the equilibrium shape of an axisymmetric sessile drop is reduced to a one-parameter shooting method problem. Based on the method the numerical solutions for drops with Bond number up to 15 are plotted. The agreement between the method and the ADSA-D method as well as the experimental data is tested. A Mathematica code based on the method is presented.
We compare the lateral retention forces on sessile drops (which are drops that are placed on top of a solid surface), pendant drops (which are drops that are placed on the underside of the surface), and inverted sessile drops (which are drops that are first placed on top and then on the underside of the surface by flipping the surface). We have found experimentally that the retention force on a truly pendant drop is always smaller than that on a sessile drop. However, the retention force on an inverted sessile drop is comparable to, and usually larger than, that on a sessile drop. Thus, the re…
We address the issues raised in [R. Tadmor et al., Langmuir 2020, 36, 475-476]. In particular, we explain why we did not use Tadmor's theory to explain our results.
We present a simple experiment that demonstrates how a water drop hanging from a Plexiglas surface (pendant drop) experiences a lateral retention force that is comparable to, and in some cases larger than, the lateral retention force on a drop resting on top of the surface (sessile drop). The experiment also affords a simple demonstration of the Coriolis effect in two dimensions.
A new set of mathematical identities is presented for axi-symmetric sessile drops on flat and curved substrates. The geometrical parameters, including the apex curvature and height, and the contact radius, are related by the identities. The validity of the identities are checked by various numerical solutions both for flat and curved substrates.
Using lubrication theory, drying processes of sessile colloidal droplets on a solid substrate are studied. A simple model is proposed to describe temporal dynamics both the shape of the drop and the volume fraction of the colloidal particles inside the drop. The concentration dependence of the viscosity is taken into account. It is shown that the final shapes of the drops depend on both the initial volume fraction of the colloidal particles and the capillary number. The results of our simulations are in a reasonable agreement with the published experimental data. The computations for the drops…
We present a theoretical study related to a recent experiment on the coalescence of sessile drops. The study deals with the kinetics of relaxation towards equilibrium, under the action of surface tension, of a spheroidal drop on a flat surface. For such a nonspherical drop under partial wetting conditions, the dynamic contact angle varies along the contact line. We propose a new nonlocal approach to the wetting dynamics, where the contact line velocity depends on the geometry of the whole drop. We compare our results to those of the conventional approach in which the contact line velocity depe…
We have proposed and investigated a model of drying colloidal suspension drop placed onto a horizontal substrate in which the sol to gel phase transition occurs. The temporal evolution of volume fraction of the solute and the gel phase dynamics were obtained from numerical simulations. Our model takes into account the fact that some physical quantities are dependent on volume fraction of the colloidal particles.
A finite element model was developed to compute the fluid flow inside a sessile evaporating droplet on hydrophilic substrate in ambient conditions. The evaporation is assumed as quasi-steady and the flow is considered as axisymmetric with a pinned contact line. The Navier-Stokes equations in cylindrical coordinates were solved inside the droplet. Galerkin weight residual approach and velocity pressure formulation was used to discretise the governing equations. Six node triangular mesh and quadratic shape functions were used to obtain higher accuracy solutions. Radial velocity profiles in axial…
The investigation of evaporating liquid drop deposited onto a flat surface is of great importance for physical, engineering and medical applications. Novel analytical expressions are proposed to calculate the evaporation rate of sessile drop (mass loss per unit surface area per unit time) and total evaporation rate (mass loss per unit time). To obtain these results, the H.M. Macdonald's solution for a flat wedge was transformed by method of inversion in a sphere originally developed by J.C. Maxwell in the Treatise on Electricity and Magnetism with further derivation the solution for a lens bas…
Coalescence of sessile polymeric fluid drops on a partially wettable substrate exhibits a transition from inertial to viscoelastic regime at concentration ratio $c/c^* \sim 1$. Our findings unveil that the temporal evolution of the growing bridge height follows a power-law behaviour $t^b$, such that the coefficient $b$ continuously decreases from 2/3 in the inertial regime ($c/c^*<1$) to an asymptotic value of 1/2 in the visco-elastic regime ($c/c^*>1$). To account for fluid elasticity and characteristic time-scale in the viscoelastic regime, a modified thin film equation under lubrication app…
We study here the microscopic deformations of elastic lamellae constituting a superhydrophobic substrate under different wetting conditions of a sessile droplet using electrowetting. The deformation profiles of the lamellae are experimentally evaluated using confocal microscopy. These experimental results are then explained using a variational principle formalism within the framework of linear elasticity. We show that the local deformation profile of a lamella is mainly controlled by the net horizontal component of the capillary forces acting on its top due to the pinned droplet contact line. …
It is shown here that concurrence between advection and diffusion in a drying sessile drop of a biological fluid can produce spatial redistribution of albumen and salt. The result gives an explanation for the patterns observed in the dried drops of the biological fluids.
We study the effects of vertical sinusoidal vibrations on a liquid droplet with a low surface tension (ethanol) deposited on a solid substrate. In a precise range of amplitudes and frequencies, the drop exhibits a dramatic worm-like shape instability with a strong symmetry breaking, comparable to the one observed by Pucci et al. (Phys. Rev. Lett., 106 (2011) 024503) on a vibrated floating lens. However, the geometry of our system is much simpler since it does not involve the oscillation and deformation of a liquid-liquid-air contact line. We show that the Faraday waves appearing on the surface…
We propose simple model of colloidal sessile drop desiccation. The model describes correctly both evolution of the phase boundary between sol and gel inside such a drop and the final shape of the dried film (deposit). The model is based on mass conservation and natural assumption that deposit (gel phase) prevents flows and evaporation.
The directional motion of sessile drops can be induced by slanted mechanical vibrations of the substrate. As previously evidenced \cite{Brunet07,Brunet09,Noblin09}, the mechanical vibrations induce drop deformations which combine axisymmetric and antisymmetric modes. In this paper, we establish quantitative trends from experiments conducted within a large range of parameters, namely the amplitude $A$ and frequency $f$ of the forcing, the liquid viscosity $η$ and the angle between the substrate and the forcing axis $α$. These experiments are carried out on weak-pinning substrates. For most para…
We study a spontaneous relaxation dynamics of arbitrarily shaped liquid drops on solid surfaces in the partial wetting regime. It is assumed that the energy dissipated near the contact line is much larger than that in the bulk of the fluid. We have shown rigorously in the case of quasi-static relaxation using the standard mechanical description of dissipative system dynamics that the introduction of a dissipation term proportional to the contact line length leads to the well known local relation between the contact line velocity and the dynamic contact angle at every point of an arbitrary cont…
We study the equilibrium solutions of a sessile drop on top of a horizontal substrate when it is partially covered by another inmiscible liquid, so that part of the drop is in contact with a third fluid (typically, air). The shapes of the interfaces are obtained by numerical integration of the differential equations resulting from the application of the Neumann's and Young's laws at the three fluids junction (triple point) and the two fluids--solid contact line (at the substrate), as well as no--flow boundary conditions at the wall of the container under axial symmetry. The formulation shows t…
The so-called coffee stain effect has been intensively studied over the past decades, but most of the studies are focused on sessile droplets. In this paper, we analyse the origin of the difference between the deposition of suspended particles in a sessile drop and in an axisymmetric drop deposited on a fibre. First, we model the shape of a drop on a fibre and its evaporative flux with some approximations to derive analytical calculations. Then, for pinned contact lines, we solve the hydrodynamics equations in the liquid phase under the lubrication approximation to determine the flow velocity …
Unexpectedly, under certain conditions, sessile drops from different but completely miscible liquids do not always coalesce instantaneously upon contact: the drop bodies remain separated in a temporary state of noncoalescence, connected through a thin liquid bridge. Here we investigate the transition between the states of instantaneous coalescence and temporary noncoalescence. Experiments reveal that it is barely influenced by viscosities and absolute surface tensions. The main system control parameters for the transition are the arithmetic means of the three-phase angles, $\overlineΘ_a$ and t…
Phase separated macromolecules play essential roles in many biological and synthetic systems. Physical characterization of these systems can be challenging because of limited sample volumes, particularly for phase-separated proteins. Here, we demonstrate that a classic method for measuring the surface tension of liquid droplets, based on the analysis of the shape of a sessile droplet, can be effectively scaled down for this application. The connection between droplet shape and surface tension relies on the density difference between the droplet and its surroundings. This can be determined with…
Stokes flows in a sessile hemispherical drop due to evaporation and surface tension gradient
Shubnikov Institute of Crystallography, Kurchatov Complex of Crystallography and Photonics of NRC‘Kurchatov Institute’（舒布尼科夫晶体学研究所，俄罗斯国家研究中心库尔恰托夫研究所晶体学与光子学库尔恰托夫综合体）
The inter-connection between the elasticity of a dielectric film and the wetting of a sessile drop on the same, under an applied electrical voltage, remains unaddressed. Here, we report the electrowetting-on-dielectric (EWOD) behaviour of sessile drops on dielectric elastomer films of varying elasticities- from an apparently rigid dielectric film to a soft, deformable dielectric film. Our results reveal that the elasticity of the underlying dielectric film provides an additional control over the droplet electrowetting behaviour, which may be best addressed from free energy based consideration,…
Water droplet freezing is a common phenomenon in our daily life. In both natural scenarios and industrial production, different surface inclinations bring distinctive deformation and freezing dynamics to frozen droplets. We explore the freezing of pendent and sessile droplets at different Bond number regimes. The effect of gravity on the droplet freezing process is analyzed by considering droplet morphology, freezing front dynamics, and freezing time. It is found that gravity can significantly influence droplet freezing processes via shaping the initial droplet, resulting in the flattening or …
Sessile drops of soft hydrogels were vibrated vertically by subjecting them to a mechanically induced Gaussian white noise. Power spectra of the surface fluctuation of the gel allowed identification of its resonant frequency that decreases with their mass, but increases with its shear modulus. The principal resonant frequencies of the spheroidal modes of the gel of shear moduli ranging from 55 Pa to 290 Pa were closest to the lowest Rayleigh mode of vibration of a drop of pure water. These observations coupled with the fact that the resonance frequency varies inversely as the square root of th…
A model is developed for describing the transport of charged colloidal particles in an evaporating sessile droplet on the electrified metal substrate in the presence of a solvent flow. The model takes into account the electric charge of colloidal particles and small ions produced by electrolytic dissociation of the active groups on the colloidal particles and solvent molecules. We employ a system of self-consistent Poisson and Nernst--Planck equations for electric potential and average concentrations of colloidal particles and ions with the appropriate boundary conditions. The fluid dynamics, …
We present an experimental and theoretical description of the kinetics of coalescence of two water drops on a plane solid surface. The case of partial wetting is considered. The drops are in an atmosphere of nitrogen saturated with water where they grow by condensation and eventually touch each other and coalesce. A new convex composite drop is rapidly formed that then exponentially and slowly relaxes to an equilibrium hemispherical cap. The characteristic relaxation time is proportional to the drop radius R * at final equilibrium. This relaxation time appears to be nearly 10 7 times larger th…
The influence of finite system size on the free energy of a spherical particle floating at the surface of a sessile droplet is studied both analytically and numerically. In the special case that the contact angle at the substrate equals $π/2$ a capillary analogue of the method of images is applied in order to calculate small deformations of the droplet shape if an external force is applied to the particle. The type of boundary conditions for the droplet shape at the substrate determines the sign of the capillary monopole associated with the image particle. Therefore, the free energy of the par…
We study numerically the deformation of sessile dielectric drops immersed in a second fluid when submitted to the optical radiation pressure of a continuous Gaussian laser wave. Both drop stretching and drop squeezing are investigated at steady state where capillary effects balance the optical radiation pressure. A boundary integral method is implemented to solve the axisymmetric Stokes flow in the two fluids. In the stretching case, we find that the drop shape goes from prolate to near-conical for increasing optical radiation pressure whatever the drop to beam radius ratio and the refractive …
This short review is devoted to the simple process of drying a multi-component droplet consisting of a complex fluid containing a salt. These processes provide a fascinating subject for study. The explanation of the rich variety of patterns formed is not only an academic challenge, but a problem of practical importance, as applications are growing in medical diagnosis and improvement of coating/printing technology. The fundamental scientific problem is the study of the mechanism of micro- and nanoparticle self-organization in open systems. The specific fundamental problem to be solved, related…
Molecular dynamics simulation is used for studying the contact angle of nanoscale sessile drops on a planar solid wall in a system interacting via the truncated and shifted Lennard-Jones potential. The entire range between total wetting and dewetting is investigated by varying the solid--fluid dispersive interaction energy. The temperature is varied between the triple point and the critical temperature. A correlation is obtained for the contact angle in dependence of the temperature and the dispersive interaction energy. Size effects are studied by varying the number of fluid particles at othe…
