几种绝缘体次级电子发射的测量
Measurements of the Secondary Electron Emission of Some Insulators
摘要:
电子束轰击绝缘体表面后,在厚样品中,表面与电子收集极之间的电场符号相反;在薄膜中,表面与电子收集极之间的电场符号相反。这两种情况都放弃了次级电子发射(SEE)的正确测量,并且可以通过减少束剂量来避免。使用了脉冲持续时间为几十微秒的单脉冲方法。通过在偏转板电路中引入的模拟开关来执行射束脉冲,该模拟开关根据数字脉冲的电平在“射束开”和“射束关”电压之间切换其输出。由于采用直流法测量SEE值较低的钛样品,使SEE值较高的绝缘子束流测量误差显著减小。一些未涂敷绝缘子的结果表明,在3500 ℃烘烤后,SEE显著增加,这可以用功函数的变化来解释。氧化铝上的钛涂层表现出接近纯钛的结果,可以被认为是一种有效的抗倍增器涂层。
英文摘要:
Charging up the surface of an insulator after beam impact can lead either to reverse sign of field between the surface and collector of electrons for case of thick sample or appearance of very high internal field for thin films. Both situations discard correct measurements of secondary electron emission (SEE) and can be avoided via reducing the beam dose. The single pulse method with pulse duration of order of tens microseconds has been used. The beam pulsing was carried out by means of an analog switch introduced in deflection plate circuit which toggles its output between "beam on" and "beam off" voltages depending on level of a digital pulse. The error in measuring the beam current for insulators with high value of SEE was significantly reduced due to the use for this purpose a titanium sample having low value of the SEE with DC method applied. Results obtained for some not coated insulators show considerable increase of the SEE after baking out at 3500C what could be explained by the change of work function. Titanium coatings on alumina exhibit results close to the ones for pure titanium and could be considered as an effective antimultipactor coating.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。