60 GHz的多千兆位无线数据传输
Multi-Gigabit Wireless data transfer at 60 GHz
摘要：
在本文中，我们描述的第一个原型的60 GHz无线千兆位数据传输拓扑结构目前正在开发中的海德堡大学使用IBM 130 nm SiGe HBT BiCMOS技术的状态。60 GHz频段非常适合于高数据速率和短距离应用，例如HEP实验中所需的应用。无线收发器由发射器和接收器组成。发射机包括一个开关键控（OOK）调制器，一个本地振荡器（LO），一个功率放大器（PA）和一个带通滤波器（BPF）。接收机部分由带通滤波器（BPF）、低噪声放大器（LNA）、双平衡下变频吉尔伯特混频器、本振（LO）、消除混频器噪声的BPF、中频放大器（IF）、开关键控解调器和限幅放大器组成。第一个原型将能够在1米的链路距离上处理约3.5 Gbps的数据速率。该LNA的第一次仿真结果表明，噪声系数（NF）为5 dB，功率增益为21 dB（60 GHz），3 dB带宽大于20 GHz，功耗为11 mW。PA的仿真显示，在60 GHz时，输出参考压缩点P1dB为19.7 dB。
英文摘要：
In this paper we describe the status of the first prototype of the 60 GHz wireless Multi-gigabit data transfer topology currently under development at University of Heidelberg using IBM 130 nm SiGe HBT BiCMOS technology. The 60 GHz band is very suitable for high data rate and short distance applications as for example needed in the HEP experments. The wireless transceiver consist of a transmitter and a receiver. The transmitter includes an On-Off Keying (OOK) modulator, an Local Oscillator (LO), a Power Amplifier (PA) and a BandPass Filter (BPF). The receiver part is composed of a BandPass- Filter (BPF), a Low Noise Amplifier (LNA), a double balanced down-convert Gilbert mixer, a Local Oscillator (LO), then a BPF to remove the mixer introduced noise, an Intermediate Amplifier (IF), an On-Off Keying demodulator and a limiting amplifier. The first prototype would be able to handle a data-rate of about 3.5 Gbps over a link distance of 1 m. The first simulations of the LNA show that a Noise Figure (NF) of 5 dB, a power gain of 21 dB at 60 GHz with a 3 dB bandwidth of more than 20 GHz with a power consumption 11 mW are achieved. Simulations of the PA show an output referred compression point P1dB of 19.7 dB at 60 GHz.
机构、总结、中文摘要均由AI分析而来，可能存在错误，请以论文正文为准。
