Bit-interleaved coded modulation (BICM) transceivers often use equally spaced constellations and a random interleaver. In this paper, we propose a new BICM design, which considers hierarchical (nonequally spaced) constellations, a bit-level multiplexer, and multiple interleavers. It is shown that this new scheme increases the degrees of freedom that can be exploited in order to improve its performance. Analytical bounds on the bit error rate (BER) of the system in terms of the constellation parameters and the multiplexing rules are developed for the additive white Gaussian Noise (AWGN) and Nakagami-$m$ fading channels. These bounds are then used to design the BICM transceiver. Numerical results show that, compared to conventional BICM designs, and for a target BER of $10^{-6}$, gains up to 3 dB in the AWGN channel are obtained. For fading channels, the gains depend on the fading parameter, and reach 2 dB for a target BER of $10^{-7}$ and $m=5$.
It is challenging to precisely configure the phase shifts of the reflecting elements at the reconfigurable intelligent surface (RIS) due to inherent hardware impairments (HIs). In this paper, the mean square error (MSE) performance is investigated in an RIS-aided single-user multiple-input multipleoutput (MIMO) communication system with transceiver HIs and RIS phase noise. We aim to jointly optimize the transmit precoder, linear received equalizer, and RIS reflecting matrices to minimize the MSE. To tackle this problem, an iterative algorithm is proposed, wherein the beamforming matrices are a…
{Robust transceiver design against unresolvable system uncertainties is of crucial importance for reliable communication. We consider a MIMO multi-hop system, where the source, the relay, and the destination are equipped with multiple antennas. Further, an intelligent reconfigurable surface (IRS) is established to cancel the RSI as much as possible. The considered decode-and-forward (DF) hybrid relay can operate in either half-duplex or full-duplex mode, and the mode changes adaptively depending on the RSI strength. We investigate a robust transceiver design problem, which maximizes the throug…
Accurate and efficient estimation of the high dimensional channels is one of the critical challenges for practical applications of massive multiple-input multiple-output (MIMO). In the context of hybrid analog-digital (HAD) transceivers, channel estimation becomes even more complicated due to information loss caused by limited radio-frequency chains. The conventional compressive sensing (CS) algorithms usually suffer from unsatisfactory performance and high computational complexity. In this paper, we propose a novel deep learning (DL) based framework for uplink channel estimation in HAD massiv…
Joint Transceiver Orientation Optimization for Rotatable-Antenna MIMO Capacity Maximization
School of Information Science and Electronic Engineering, Shanghai Jiao Tong University（上海交通大学信息科学与电子工程学院）；State Key Laboratory of Internet of Things for Smart City and the Department of Electrical and Computer Engineering, University of Macau（澳门大学物联网智能城市国家重点实验室及电气与计算机工程系）
We perform geometric constellation shaping with optimized bit labeling using a binary autoencoder including a differential blind phase search (BPS). Our approach enables full end-to-end training of optical coherent transceivers taking into account the digital signal processing.
We test the concept of extended channel probing in an Optical Spectrum as a Service scenario in coherent optimized flex-grid long-haul and 10Gbit/s OOK optimized 100-GHz fixed-grid dispersion-managed legacy DWDM networks. An estimation accuracy better than +/- 0.1dB in GSNR implementation margin is obtained for both networks by using flexible coherent transceivers on lightpaths up to 822km on regional haul legacy network and up to 5738km on a long-haul network. We also explain, how to detect the operation regime of the channel by analyzing the received GSNR results from constant power spectral…
