arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 1005.5554cond-mat.mtrl-sci
收藏

多孔镀锌层在不同腐蚀介质中的耐蚀性研究

On the Corrosion Resistance of Porous Electroplated Zinc Coatings in Different Corrosive Media

Youcef Hamlaoui, Fernando Pedraza, Lakhdar Tifouti

摘要:

研究了经化学腐蚀产生表面缺陷(孔隙)的电镀锌层的耐蚀性。采用交流阻抗和直流极化测试方法研究了该涂层在各种腐蚀介质(NaCl、NaOH和雨水)中的行为。在不同的NaCl浓度下(0.1 ~ 1 M),可清楚地观察到四种不同的法拉第弛豫过程。在最集中的解决方案中,至少有三个弛豫过程在低频(LF)出现,并与锌沉积和溶解。在较低浓度下,根据pH值,仅观察到一个过程。电荷转移电阻(Rct)和腐蚀电流(Icorr)在pH 5至10的范围内实际上是稳定的。在0.1M脱气NaCl溶液中,交流阻抗图在非常接近的频率处显示出两个时间常数。从EIS图中,涂层的多孔性质被突出显示,并显示溶解机制发生在孔的底部。

英文摘要:

The corrosion resistance of an electroplated (EP) Zn coating whose surface was chemically etched to produce surface defects (pores) is investigated in this work. Impedance and DC polarisation measururements were employed to study the behaviour of such coating in various corrosive media (NaCl, NaOH and rain water). Four different faradaic relaxation processes were clearly revealed in different NaCl concentrations (from 0.1M to 1M). In the most concentrated solutions at least three relaxation processes at low frequencies (LF) appeared and were related to zinc deposition and dissolution. At lower concentrations and depending on the pH, only one process was observed. The charge transfer resistance (Rct) and the corrosion current (Icorr) were practically stable in the pH range 5 to 10. In deaerated NaCl 0.1M, the EIS diagrams showed two time-constants at very close frequencies. From the EIS diagrams the porous nature of the coating was highlighted and showed that the dissolution mechanisms occurred at the base of the pores.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑