退火对通过冷旋转锻造获得细晶钛α合金Ti-2.5Al-2.6Zr抗热盐腐蚀性能的影响
Effect of annealing on the hot salt corrosion resistance of the fine-grained titanium alpha-alloy Ti-2.5Al-2.6Zr obtained via cold Rotary Swaging
AI总结:
研究了冷旋转锻造制备的超细晶钛α合金Ti-2.5Al-2.6Zr在退火处理后的热盐腐蚀行为,发现退火显著影响晶间腐蚀、点蚀与均匀腐蚀间的竞争关系,且长时间低温退火比短时高温退火更显著地增加均匀腐蚀速率。
摘要:
对细晶钛α合金Ti-2.5Al-2.6Zr(俄罗斯工业合金PT-7M)进行了热盐腐蚀(HSC)测试。该钛α合金中的超细晶(UFG)微观结构是通过冷旋转锻造形成的。通过选择合适的退火温度和时间,改变了合金中再结晶微观结构的晶粒尺寸和体积分数。研究了UFG合金在500-700C退火30分钟以及在250C退火1000小时后的微观结构和耐腐蚀性。通过金相学研究考察了退火对钛α合金Ti-2.5Al-2.6Zr腐蚀损伤性质和程度的影响。HSC测试后,利用X射线衍射和电子显微镜对钛α合金样品进行了表面分析。在Ti-2.5Al-2.6Zr的HSC测试中,观察到了晶间腐蚀(IGC)与点蚀之间的竞争性相互作用。据我们所知,本研究首次表明退火会影响该钛合金的IGC、点蚀和均匀腐蚀速率之间的关系。在250C下长时间低温退火导致的均匀腐蚀速率增加,比在500-700C下短时高温退火30分钟更为显著。深入分析了晶界结构和相组成对α合金Ti-2.5Al-2.6Zr HSC敏感性的影响。
英文摘要:
A hot salt corrosion (HSC) test was performed on the fine-grained titanium alpha-alloy Ti-2.5Al-2.6Zr (Russian industrial alloy PT-7M). The ultrafine-grained (UFG) microstructure in the titanium alpha-alloy was formed via cold Rotary Swaging. The grain size and volume fraction of the recrystallized microstructure in the alloy were varied by choosing appropriate annealing temperatures and times. The microstructure and corrosion resistance of UFG alloys were studied after 30 min of annealing at 500-700C and after 1000 h of annealing at 250C. Metallographic studies were carried out to investigate the effects of annealing on the nature and extent of corrosive damage in the titanium alpha-alloy Ti-2.5Al-2.6Zr. After HSC tests, surface analyses of the titanium alpha-alloy samples were conducted using X-ray diffraction and electron microscopy. During the HSC testing of the titanium alpha-alloy Ti-2.5Al-2.6Zr, a competitive interaction between intergranular corrosion (IGC) and pitting corrosion was observed. To the best of our knowledge, it was shown for the first time that annealing affects the relationship among the IGC, pitting corrosion and uniform corrosion rates of the titanium alloy. Prolonged low-temperature annealing at 250C resulted in a more pronounced increase in the uniform corrosion rate than short-term high-temperature annealing for 30 min at 500-700C. An in-depth analysis of the effect of the structure and phase composition of the grain boundaries on the susceptibility of the alpha-alloy Ti-2.5Al-2.6Zr to HSC was conducted.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。