We show that a nano-resonator can be prepared in mesoscopic-superposition states merely by monitoring a qubit coupled to the square of the resonators position. This works for thermal initial states, and does not require a third-order nonlinearity. The required coupling can be generated using a simple open-loop control protocol, obtained with optimal control theory. We simulate the complete preparation process, including environmental noise. Our results indicate the power of open-loop control for state-engineering and measurement in quantum nano-systems.
We show that continuous real-time feedback can be used to track, control, and protect a mesoscopic superposition of two spatially separated wave-packets. The feedback protocol is enabled by an approximate state-estimator, and requires two continuous measurements, performed simultaneously. For nanomechanical and superconducting resonators, both measurements can be implemented by coupling the resonators to superconducting qubits.
We study the quantum dynamics of a symmetric nanomechanical graphene resonator with degenerate flexural modes. Applying voltage pulses to two back gates, flexural vibrations of the membrane can be selectively actuated and manipulated. For graphene, nonlinear response becomes important already for amplitudes comparable to the magnitude of zero point fluctuations. We show, using analytical and numerical methods, that this allows for creation of cat-like superpositions of coherent states as well as superpositions of coherent cat-like non-product states.
We analyse the quantum dynamics of a micromechanical resonator capacitively coupled to a Cooper box. With appropriate quantum state control of the Cooper box, the resonator can be driven into a superposition of spatially separated states. The Cooper box can also be used to probe the environmentally-induced decoherence of the resonator superposition state.
We show how to engineer an extensive range of non-linear Hamiltonians for a nano-mechanical resonator. The technique requires only a time dependent drive applied to a Cooper-pair box or second oscillator to which the nano-resonator is coupled. This method allows one to generate a large number of non-classical states, as well as Hamiltonians whose classical counterparts are chaotic.
We show that a continuous quantum non-demolition measurement of the energy of a nanomechanical resonator can be achieved by monitoring the resonator with a quantum point contact via a Cooper-pair box. This technique can further be used to prepare highly non-classical states of two resonators, such as canonical phase-reference states, and so-called "noon" states.
We show that it is possible to perform a continuous measurement that continually projects a nano-resonator into its energy eigenstates by employing a linear coupling with a two-state system. This technique makes it possible to perform a measurement that exposes the quantum nature of the resonator by coupling it to a Cooper-pair Box and a superconducting transmission-line resonator.
An experimental demonstration of a non-classical state of a nanomechanical resonator is still an outstanding task. In this paper we show how the resonator can be cooled and driven into a squeezed state by a bichromatic microwave coupling to a charge qubit. The stationary oscillator state exhibits a reduced noise in one of the quadrature components by a factor of 0.5 - 0.2. These values are obtained for a 100 MHz resonator with a Q-value of 10$^4$ to 10$^5$ and for support temperatures of T $\approx$ 25 mK. We show that the coupling to the charge qubit can also be used to detect the squeezed st…
The rapid experimental progress in the field of superconducting nanocircuits gives rise to an increasing quest for advanced quantum-control techniques for these macroscopically coherent systems. Here we demonstrate theoretically that stimulated Raman adiabatic passage (STIRAP) should be possible with the quantronium setup of a Cooper-pair box. The scheme appears to be robust against decoherence and should be realizable even with the existing technology. As an application we present a method to generate single-phonon states of a nanomechnical resonator by vacuum-stimulated adiabatic passage wit…
We study the optical properties of quantum dipole emitters coupled to hyperbolic metamaterial nano-resonators using a semi-analytical quasinormal mode approach. We show that coupling to metamaterial nano-resonators can lead to significant Purcell enhancements that are nearly an order of magnitude larger than those of plasmonic resonators with comparable geometry. However, the associated single photon output $β$-factors are extremely low (around 10$\%$), far smaller than those of comparable sized metallic resonators (70$\%$). Using a quasinormal mode expansion of the photon Green function, we d…
Observation of resonance modes is the most straightforward way of studying mechanical oscillations because these modes have maximum response to stimuli. However, a deeper understanding of mechanical motion could be obtained by also looking at modal responses at frequencies in between resonances. A common way to do this is to force a mechanical object into oscillations and study its off-resonance behaviour. In this paper, we present visualisation of the modal response shapes for a mechanical drum driven off resonance. By using the frequency modal analysis, we describe these shapes as a superpos…
Magnetically coupling a nano-mechanical resonator to a double quantum dot confining two electrons can enable the manipulation of a single electron spin and the readout of the resonator's natural frequency. When the Larmor frequency matches the resonator frequency, the electron spin in one of the dots can be selectively flipped by the magnetised resonator. By simultaneously measuring the charge state of the two-electron double quantum dots, this transition can be detected thus enabling the natural frequency of the mechanical resonator to be determined.
The current noise spectrum of a single-electron transistor (SET) coupled to a nano-mechanical resonator is calculated in the classical regime. Correlations between the charge on the SET island and the position of the resonator give rise to a distinctive noise spectrum which can be very different from that of the uncoupled SET. The current noise spectrum of the coupled system contains peaks at both the frequency of the resonator and double the resonator frequency, as well as a strong enhancement of the zero-frequency noise. The heights of the peaks are controlled by the strength of the coupling…
We provide a detailed description of a general procedure by which a nano/micro-mechanical resonator can be calibrated using its thermal motion. A brief introduction to the equations of motion for such a resonator is presented, followed by a detailed derivation of the corresponding power spectral density (PSD) function. The effective masses for a number of different resonator geometries are determined using both finite element method (FEM) modeling and analytical calculations.
A suspended, doubly clamped single wall carbon nanotube is characterized as driven nano-electromechanical resonator at cryogenic temperatures. Electronically, the carbon nanotube displays small bandgap behaviour with Coulomb blockade oscillations in electron conduction and transparent contacts in hole conduction. We observe the driven mechanical resonance in dc-transport, including multiple higher harmonic responses. The data shows a distinct negative frequency tuning at finite applied gate voltage, enabling us to electrostatically decrease the resonance frequency to 75% of its maximum value. …
Coupling, synchronization, and non-linear dynamics of resonator modes are omnipresent in nature and highly relevant for a multitude of applications ranging from lasers to Josephson arrays and spin torque oscillators. Nanomechanical resonators are ideal candidates to study these effects on a fundamental level and to realize all-mechanical platforms for information processing and storage. For larger resonator networks, however, this requires the ability to tune the mode frequencies selectively and to operate the resonators in the strong coupling regime. Here, we present a proof-of-principle real…
We report on the design of loop-gap resonators (LGR) operating in the frequency range 34-36 GHz with the goal to achieve single electron spin resonance (ESR) in quantum dot nanostructures. We present a comprehensive study of the magnetic field strength and the spatial distribution of the electric and magnetic fields in the resonator by means of experiments and numerical simulations.
We analyze the dynamics of a nano-mechanical resonator coupled to a single-electron transistor (SET) in the regime where the resonator behaves classically. A master equation is derived describing the dynamics of the coupled system which is then used to obtain equations of motion for the average charge state of the SET and the average position of the resonator. We show that the action of the SET on the resonator is very similar to that of a thermal bath, as it leads to a steady-state probability-distribution for the resonator which can be described by mean values of the resonator position, a re…
A suspended, doubly clamped single wall carbon nanotube is characterized at cryogenic temperatures. We observe specific switching effects in dc-current spectroscopy of the embedded quantum dot. These have been identified previously as nano-electromechanical self-excitation of the system, where positive feedback from single electron tunneling drives mechanical motion. A magnetic field suppresses this effect, by providing an additional damping mechanism. This is modeled by eddy current damping, and confirmed by measuring the resonance quality factor of the rf-driven nano-electromechanical resona…
Magnetic torque is used to actuate nano-torsional resonators, which are fabricated by focused-ion-beam milling of permalloy coated silicon nitride membranes. Optical interferometry is used to measure the mechanical response of two torsion modes at resonance, which is proportional to the magnetization vector of the nanomagnetic volume. By varying the bias magnetic field, the magnetic behavior can be measured with excellent sensitivity ($\approx 10^8 μ_B$) for single magnetic elements.
We probe electro-mechanical properties of InAs nanowire (diameter ~ 100 nm) resonators where the suspended nanowire (NW) is also the active channel of a field effect transistor (FET). We observe and explain the non-monotonic dispersion of the resonant frequency with DC gate voltage (VgDC). The effect of electronic screening on the properties of the resonator can be seen in the amplitude. We observe the mixing of mechanical modes with VgDC. We also experimentally probe and quantitatively explain the hysteretic non-linear properties, as a function of VgDC, of the resonator using the Duffing equa…
Bi-stable mechanical resonators play a significant role in various applications, such as sensors, memory elements, and quantum computing. While carbon nanotube (CNT) based resonators have been widely investigated as promising nano electro-mechanical devices, a bi-stable CNT resonator has never been demonstrated. Here, we report a new class of CNT resonators in which the nanotube is buckled upward. We show that a small upward buckling yields record electrical frequency tunability, whereas larger buckling can achieve Euler-Bernoulli (EB) bi-stability, the smallest mechanical resonator with two s…
We present an integrated scheme for dielectric drive and read-out of high-Q nanomechanical resonators which enables tuning of both the resonance frequency and quality factor with an applied DC voltage. A simple model for altering these quantities is derived, incorporating the resonator's complex electric polarizability and position in an inhomogeneous electric field, which agrees very well with the experimental findings as well as FEM simulations. By comparing two sample geometries we are able to show that careful electrode design can determine the direction of frequency tuning of flexural in-…
We give a quantum master equation description of the measurement scheme based on a coplanar microwave cavity capacitively coupled to nano mechanical resonator. The system exhibits a rich bifurcation structure that is analogous to sub/second harmonic generation in nonlinear optics. We show how it may be configured as a bifurcation amplifier transducer for weak force detection.
We report actuation and detection of gigahertz-range resonance frequencies in nano-crystalline diamond mechanical resonators. High order transverse vibration modes are measured in coupled-beam resonators exhibiting frequencies up to 1.441 GHz. The cantilever-array design of the resonators translates the gigahertz-range resonant motion of micron-long cantilever elements to the displacement of the central supporting structure. Use of nano-crystalline diamond further increases the frequency compared to single crystal silicon by a factor of three. High clamping losses usually associated with micro…
Strong Stokes and anti-Stokes one-photon luminescence from single gold nanorods is measured in experiments. It is found that the intensity and polarization of the Stokes and anti-Stokes emissions are in strong correlation. Our experimental observation discovered a coherent process in light emission from single gold nanorods. We present a theoretical mode, based on the concept of cavity resonance, for consistently understanding both Stokes and anti-Stokes photoluminescence. Our theory is in good agreement of all our measurements.
Single-walled carbon nanotubes have advantages as a nanoscale light source compatible with silicon photonics because they show room-temperature luminescence at telecom-wavelengths and can be directly synthesized on silicon substrates. Here we demonstrate integration of individual light-emitting carbon nanotubes with silicon microdisk resonators. Photons emitted from nanotubes are efficiently coupled to whispering gallery modes, circulating within the disks and lighting up their perimeters. Furthermore, we control such emission by tuning the excitation wavelength in and out of resonance with hi…
The equivalence between different physical systems permits us to transfer knowledge between them and to characterize the universal nature of their dynamics. We demonstrate that a nanopillar driven by a spin-transfer torque is equivalent to a rotating magnetic plate, which permits us to consider the nanopillar as a macroscopic system under a time-modulated injection of energy, that is, a simple parametric resonator. This equivalence allows us to characterize the phases diagram and to predict magnetic states and dynamical behaviors, such as solitons, stationary textures, and oscillatory localize…
In this work we present the fabrication and characterization of superconducting nano-mechanical resonators made from nanocrystalline boron doped diamond (BDD). The oscillators can be driven and read out in their superconducting state and show quality factors as high as 40,000 at a resonance frequency of around 10 MHz. Mechanical damping is studied for magnetic fields up to 3 T where the resonators still show superconducting properties. Due to their simple fabrication procedure, the devices can easily be coupled to other superconducting circuits and their performance is comparable with state-of…
