To generate entangled photon pairs via quantum dots (QDs), the exciton fine structure splitting (FSS) must be comparable to the exciton homogeneous line width. Yet in the (In,Ga)As/GaAs QD, the intrinsic FSS is about a few tens $μ$eV. To achieve photon entanglement, it is necessary to Cherry-pick a sample with extremely small FSS from a large number of samples, or to apply strong in-plane magnetic field. Using theoretical modeling of the fundamental causes of FSS in QDs, we predict that the intrinsic FSS of InAs/InP QDs is an order of magnitude smaller than that of InAs/GaAs dots, and better yet, their excitonic gap matches the 1.55 $μ$m fiber optic wavelength, therefore offer efficient on-demand entangled photon emitters for long distance quantum communication.
We investigate the electronic structure of the InAs/InP quantum dots using an atomistic pseudopotential method and compare them to those of the InAs/GaAs QDs. We show that even though the InAs/InP and InAs/GaAs dots have the same dot material, their electronic structure differ significantly in certain aspects, especially for holes: (i) The hole levels have a much larger energy spacing in the InAs/InP dots than in the InAs/GaAs dots of corresponding size. (ii) Furthermore, in contrast with the InAs/GaAs dots, where the sizeable hole $p$, $d$ intra-shell level splitting smashes the energy level …
We present a comprehensive study of the optical properties of InAs/InP self-assembled quantum dots (QDs) using an empirical pseudopotential method and configuration interaction treatment of the many-particle effects. The results are compared to those of InAs/GaAs QDs. The main results are: (i) The alignment of emission lines of neutral exciton, charged exciton and biexciton in InAs/InP QDs is quite different from that in InAs/GaAs QDs. (ii) The hidden correlation in InAs/InP QDs is 0.7 - 0.9 meV, smaller than that in InAs/GaAs QDs. (iii) The radiative lifetimes of neutral exciton, charged exci…
Time- and spectrally-resolved PL from a periodic array of InP/InAs/InP core-multishell nanowires is presented. InAs layer shows multipeak PL spectra. PL decay is nonexponential and very slow, with decay rate depending on energy.
By using a C3v symmetric (111) surface as a growth substrate, we are able to achieve high structural symmetry in self-assembled quantum dots, which are suitable for use as quantum-entangled photon emitters. Here we report on the wavelength controllability of InAs dots on InP(111)A, which we realized by tuning the ternary alloy composition of In(Al,Ga)As barriers that were lattice-matched to InP. We changed the peak emission wavelength systematically from 1.3 to 1.7 micrometer by barrier band gap tuning. The observed spectral shift agreed with the result of numerical simulations that assumed a …
We report on the systematic investigation of the optical properties of a selectively grown quantum dot gain material assisted by block-copolymer lithography for potential applications in active optical devices operating in the wavelength range around 1.55 um and above. We investigated a new type of diblock copolymer PS-b-PDMS (polystyrene-block-polydimethylsiloxane) for the fabrication of silicon oxycarbide hard mask for selective area epitaxy of InAs/InP quantum dots. An array of InAs/InP quantum dots was selectively grown via droplet epitaxy. Our detailed investigation of the quantum dot car…
The dynamic response of InAsP quantum dots grown on InP(001) substrates by low-pressure Metalorganic Vapor Phase Epitaxy emitting around 1.55 $μ$m, is investigated by means of time-resolved microphotoluminescence as a function of temperature. Exciton lifetime steadily increases from 1 ns at low temperature to reach 4 ns at 300K while the integrated photoluminescence intensity decreases only by a factor of 2/3. These characteristics give evidence that such InAsP/InP quantum dots provide a strong carrier confinement even at room temperature and that their dynamic response is not affected by ther…
The quantum efficiency of an electroluminescent intersubband emitter based on InAs/AlSb has been measured as a function of the magnetic field up to 20T. Two series of oscillations periodic in 1/B are observed, corresponding to the elastic and inelastic scattering of electrons of the upper state of the radiative transitions. Experimental results are accurately reproduced by a calculation of the excited state lifetime as a function of the applied magnetic field. The interpretation of these data gives an exact measure of the relative weight of the scattering mechanisms and allows the extraction o…
We report the detection of quantum confinement in single InAs-InP core-shell nanowires. The wires having an InAs core with ~25 nm diameter are characterized by emission spectra in which two peaks are identified under high excitation intensity conditions. The peaks are caused by emission from the ground and excited quantized levels, due to the quantum confinement in the plane perpendicular to the nanowire axis. We have identified in the emission spectra different energy contributions related to the wurtzite structure of the wires, the strain between the wurtzite core and shell, and the confinem…
The Stranski-Krastanov (SK) growth-mode facilitates the self-assembly of quantum dots (QDs) using lattice-mismatched semiconductors, for instance InAs and GaAs. SK QDs are defect-free and can be embedded in heterostructures and nano-engineered devices. InAs QDs are excellent photon emitters: QD-excitons, electron-hole bound pairs, are exploited as emitters of high quality single photons for quantum communication. One significant drawback of the SK-mode is the wetting layer (WL). The WL results in a continuum rather close in energy to the QD-confined-states. The WL-states lead to unwanted scatt…
A systematic manipulation of the morphology and the optical emission properties of MOVPE grown ensembles of InAs/InP quantum dots is demonstrated by changing the growth kinetics parameters. Under non-equilibrium conditions of a comparatively higher growth rate and low growth temperature, the quantum dot density, their average size and hence the peak emission wavelength can be tuned by changing efficiency of the surface diffusion (determined by the growth temperature) relative to the growth flux. We further observe that the distribution of quantum dot heights, for samples grown under varying co…
A virtual substrate for high quality InAs epitaxial layer has been attained via metalorganic vapor-phase epitaxy growth of Sb-assisted InxGa1-xAs metamorphic buffers, following a convex compositional continuous gradient of the In content from x = 53 % to 100 %. The use of trimethylantimony (or its decomposition products) as a surfactant has been found to crucially enable the control over the defect formation during the relaxation process. Moreover, an investigation of the wafer offcut-dependence of the defect formation and surface morphology has enabled the achievement of a reliably uniform gr…
The optical properties of single InAsP/InP quantum dots are investigated by spectrally-resolved and time-resolved photoluminescence measurements as a function of excitation power. In the short-wavelength region (below 1.45 $μ$m), the spectra display sharp distinct peaks resulting from the discrete electron-hole states in the dots, while in the long-wavelength range (above 1.45 $μ$m), these sharp peaks lie on a broad spectral background. In both regions, cascade emission observed by time-resolved photoluminescence confirms that the quantum dots possess discrete exciton and multi-exciton states.…
Biexciton cascade process in self-assembled quantum dots (QDs) provides an ideal system for deterministic entangled photon pair source, which is essential in quantum information science. The entangled photon pairs have recently be realized in experiments after eliminating the FSS of exciton using a number of different methods. However, so far the QDs entangled photon sources are not scalable, because the wavelengths of the QDs are different from dot to dot. Here we propose a wavelength tunable entangled photon emitter on a three dimensional stressor, in which the FSS and exciton energy can be …
InAs-based two-dimensional electron systems grown on lattice mismatched InP substrates offer a robust platform for the pursuit of topologically protected quantum computing. We investigated strained composite quantum wells of In$_{0.75}$Ga$_{0.25}$As/InAs/In$_{0.75}$Ga$_{0.25}$As with In$_{0.75}$Al$_{0.25}$As barriers. By optimizing the widths of the In$_{0.75}$Ga$_{0.25}$As layers, the In$_{0.75}$Al$_{0.25}$As barrier, and the InAs quantum well we demonstrate mobility in excess of $1 \times 10^{6}\,$cm$^{2}/$Vs. Mobility vs. density data indicates that scattering is dominated by a residual thr…
Photoluminescence data from single, self-assembled InAs/InP quantum dots in magnetic fields up to 7 T are presented. Exciton g-factors are obtained for dots of varying height, corresponding to ground state emission energies ranging from 780 meV to 1100 meV. A monotonic increase of the g-factor from -2 to +1.2 is observed as the dot height decreases. The trend is well reproduced by sp3 tight binding calculations, which show that the hole g-factor is sensitive to confinement effects through orbital angular momentum mixing between the light-hole and heavy-hole valence bands. We demonstrate tunabi…
We report on a atomistic theory of electronic structure and optical properties of a single InAs quantum dot grown on InP patterned substrate. The spatial positioning of individual dots using InP nano-templates results in a quantum dot embedded in InP pyramid. The strain distribution of a quantum dot in InP pyramid is calculated using the continuum elasticity theory. The electron and valence hole single-particle states are calculated using atomistic effective-bond-orbital model with second nearest-neighbor interactions, coupled to strain via Bir-Pikus Hamiltonian. The optical properties are det…
Nanowire (NW)-based opto-electronic devices require certain engineering in the NW geometry to realize polarized-dependent light sources and photodetectors. We present a growth procedure to produce InAs/InP quantum dot-nanowires (QD-NWs) with an elongated top-view cross-section relying on the vapor-liquid-solid method using molecular beam epitaxy. By interrupting the rotation of the sample during the radial growth sequence of the InP shell, hexagonal asymmetric (HA) NWs with long/short cross-section axes were obtained instead of the usual symmetrical shape. Polarization-resolved photoluminescen…
We present a study on the influence of strain-relieving InAlAs buffer layers on metamorphic InAs/InGaAs quantum wells grown by molecular beam epitaxy on GaAs. Residual strain in the buffer layer, the InGaAs barrier and the InAs wells were assessed by X-ray diffraction and high-resolution transmission electron microscopy. By carefully choosing the composition profile and thicknesses of the buffer layer, virtually unstrained InGaAs barriers embedding an InAs quantum well with thickness up to 7nm can be grown. This allows reaching low-temperature electron mobilities much higher than previously re…
The combination of core/shell geometry and band gap engineering in nanowire heterostructures can be employed to realize systems with novel transport and optical properties. Here, we report on the growth of InAs/InP/GaAsSb core-dual-shell nanowires by catalyst-free chemical beam epitaxy on Si(111) substrates. Detailed morphological, structural, and compositional analyses of the nanowires as a function of growth parameters were carried out by scanning and transmission electron microscopy and by energy-dispersive X-ray spectroscopy. Furthermore, by combining the scanning transmission electron mic…
Semiconductor nanowires based on non-nitride III-V compounds can be synthesized under certain growth conditions to favor the appearance of wurtzite crystal phase. Despite the reports in literature of ab initio band structures for these wurtzite compounds, we still lack effective multiband models and parameter sets that can be simply used to investigate physical properties of such systems, for instance, under quantum confinement effects. In order to address this deficiency, in this study we calculate the ab initio band structure of bulk InAs and InP in wurtzite phase and develop an 8$\times$8 k…
We report tunneling spectroscopy measurements of the Zeeman spin splitting in InAs few-electron quantum dots. The dots are formed between two InP barriers in InAs nanowires with a wurtzite crystal structure grown by chemical beam epitaxy. The values of the electron g-factors of the first few electrons entering the dot are found to strongly depend on dot size and range from close to the InAs bulk value in large dots |g^*|=13 down to |g^*|=2.3 for the smallest dots. These findings are discussed in view of a simple model.
The evolution of InAs quantum dots grown on InP substrates by metal-organic vapour phase epitaxy is studied as a function of InAs coverage. Under specific growth conditions, the onset of the two- to three-dimensional transition is seen to proceed via two distinct pathways: through (i) an abrupt appearance of quantum dots as expected in the usual Stranski-Krastanov growth picture and (ii) a continuous evolution of small surface features into well developed quantum dots. The average size of the features in both these families increases with coverage, leading to a bimodal distribution in dot size…
Excitonic spectra are calculated for free-standing, surface passivated InAs quantum dots using atomic pseudopotentials for the single-particle states and screened Coulomb interactions for the two-body terms. We present an analysis of the single particle states involved in each excitation in terms of their angular momenta and Bloch-wave parentage. We find that (i) in agreement with other pseudopotential studies of CdSe and InP quantum dots, but in contrast to k.p calculations, dot states wavefunction exhibit strong odd-even angular momentum envelope function mixing (e.g. $s$ with $p$) and large…
We report reproducible fabrication of InP-InAsP nanowire light emitting diodes in which electron-hole recombination is restricted to a quantum-dot-sized InAsP section. The nanowire geometry naturally self-aligns the quantum dot with the n-InP and p-InP ends of the wire, making these devices promising candidates for electrically-driven quantum optics experiments. We have investigated the operation of these nano-LEDs with a consistent series of experiments at room temperature and at 10 K, demonstrating the potential of this system for single photon applications.
Being able to combine different materials allows taking advantage of different properties and device engineering that cannot be found or exploited within a single material system. In quantum nano-photonics, one might want to increase the device functionalities by, for instance, combining efficient classical and quantum light emission available in III-V semiconductors, low-loss light propagation accessible in silicon-based materials, fast electro-optical properties of lithium niobate and broadband reflectors and/or buried metallic contacts for local electric field application or electrical inje…
A procedure to achieve the density-controlled growth of gold-catalyzed InP nanowires (NWs) on (111) silicon substrates using the vapor-liquid-solid method by molecular beam epitaxy is reported. We develop an effective and mask-free method based on controlling the number and the size of the Au-In catalyst droplets in addition to the conditions for the NW nucleation. We show that the NW density can be tuned with values in the range of 18 μm-2 to < 0.1 μm-2 by the suitable choice of the In/Au catalyst beam equivalent pressure (BEP) ratio, by the phosphorous BEP and the growth temperature. The sam…
