MEMS器械高压封装用高强度密封剂的选择
Selection of High Strength Encapsulant for MEMS Devices Undergoing High Pressure Packaging
摘要:
为了确定MEMS器件的最佳封装材料,研究了几种封装材料在均匀压力下的变形行为。在高压传递模塑封装过程中,需要封装来保护MEMS器件的活动部件。选定的封装材料必须具有小于5?在100 atm垂直载荷下,使用CoventorWare ver.2005软件模拟了挠度,并使用壳体弯曲理论得到的计算结果进行了验证。筛选设计被用来构建一个系统的方法来选择最佳的封装材料和厚度下均匀的压力高达100大气压。本研究考虑的材料为聚酰亚胺、聚对二甲苯C和碳基环氧树脂。据观察,碳基环氧树脂的挠度小于5?对于所有厚度和压力变化,聚对二甲苯C是可接受的,聚酰亚胺不适合作为高强度密封剂。碳基环氧树脂由于其高强度被认为是MEMS高压封装工艺中最好的封装材料。
英文摘要:
Deflection behavior of several encapsulant materials under uniform pressure was studied to determine the best encapsulant for MEMS device. Encapsulation is needed to protect movable parts of MEMS devices during high pressure transfer molded packaging process. The selected encapsulant material has to have surface deflection of less than 5 ?m under 100 atm vertical loading. Deflection was simulated using CoventorWare ver.2005 software and verified with calculation results obtained using shell bending theory. Screening design was used to construct a systematic approach for selecting the best encapsulant material and thickness under uniform pressure up to 100 atm. Materials considered for this study were polyimide, parylene C and carbon based epoxy resin. It was observed that carbon based epoxy resin has deflection of less than 5 ?m for all thickness and pressure variations. Parylene C is acceptable and polyimide is unsuitable as high strength encapsulant. Carbon based epoxy resin is considered the best encapsulation material for MEMS under high pressure packaging process due to its high strength.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。