It is shown that a good estimate of the fidelity of an experimentally realized quantum process can be obtained by measuring the outputs for only two complementary sets of input states. The number of measurements required to test a quantum network operation is therefore only twice as high as the number of measurements required to test a corresponding classical system.
Reduced fidelities for free fermions out of equilibrium: From dynamical quantum phase transitions to Mpemba effect
Laboratoire d’Annecy de Physique Théorique (LAPTh), CNRS, Université Savoie Mont Blanc（萨瓦-蒙布朗大学）；Dipartimento di Fisica, Università di Pisa, and INFN Sezione di Pisa（比萨大学）
Nuclear spins were among the first physical platforms to be considered for quantum information processing, because of their exceptional quantum coherence and atomic-scale footprint. However, their full potential for quantum computing has not yet been realized, due to the lack of methods to link nuclear qubits within a scalable device combined with multi-qubit operations with sufficient fidelity to sustain fault-tolerant quantum computation. Here we demonstrate universal quantum logic operations using a pair of ion-implanted 31P donor nuclei in a silicon nanoelectronic device. A nuclear two-qub…
We propose a scheme for driving a dimer of spatially separated qubits into a maximally entangled non-equilibrium steady state. A photon-mediated retarded interaction between the qubits is realized by coupling them to two tunnel-coupled leaky cavities where each cavity is driven by a coherent microwave tone. The proposed cooling mechanism relies on striking the right balance between the unitary and driven-dissipative dynamics of the qubit subsystem. We map the dimer to an effective transverse-field XY model coupled to a non-equilibrium bath that can be suitably engineered through the choice of …
Demonstration of a quantum comparator on an ion-trap quantum device
RIKEN Center for Quantum Computing（理化学研究所量子计算中心）；BlocQ, Inc.（BlocQ公司）；Faculty of Social Informatics, ZEN University（ZEN大学社会信息学部）；Department of Applied Physics, Hokkaido University（北海道大学应用物理系）；Department of Applied Physics, The University of Tokyo（东京大学应用物理系）；Department of Physics, The University of Tokyo（东京大学物理学系）；Institute for Photon Science and Technology, The University of Tokyo（东京大学光子科学技术研究所）；Center for Quantum Information and Quantum Biology, The University of Osaka（大阪大学量子信息与量子生物学中心）
A scheme for the enhanced generation of higher photon-number states is realized, using an optical time-multiplexing setting that exploits a parametric down-conversion source for an iterative state generation. We use a quantum feedback mechanism for already generated photons to induce self-seeding of the consecutive nonlinear process, enabling us to coherently add photons to the light that propagates in the feedback loop. The addition can be carried out for any chosen number of round trips, resulting in a successive buildup of multiphoton states. Our system is only limited by loop losses. The l…
Recently, nonadiabatic geometric quantum computation has been received much attention, due to its fast manipulation and intrinsic error-resilience characteristics. However, to obtain universal geometric quantum control, only limited and special evolution paths have been proposed, which usually requires longer gate-time and more operational steps, and thus leads to lower quality of the implemented quantum gates. Here, we present an effective scheme to find the shortest geometric path under the conventional conditions of geometric quantum computation, where high-fidelity and robust geometric gat…
There are two general requirements to harness the computational power of quantum mechanics: the ability to manipulate the evolution of an isolated system and the ability to faithfully extract information from it. Quantum error correction and simulation often make a more exacting demand: the ability to perform non-destructive measurements of specific correlations within that system. We realize such measurements by employing a protocol adapted from [S. Nigg and S. M. Girvin, Phys. Rev. Lett. 110, 243604 (2013)], enabling real-time selection of arbitrary register-wide Pauli operators. Our impleme…
A crucial requirement for scalable quantum-information processing is the realization of multiple-qubit quantum gates. Universal multiple-qubit gates can be implemented by a set of universal single qubit gates and any one kind of two-qubit gate, such as a controlled-NOT (CNOT) gate. Semiconductor quantum dot qubits are a leading approach for the physical implementation of quantum computation, due to their potential for large-scale integration. Two-qubit gate operations have been so far only demonstrated in individual electron spin-based quantum dot systems. Due to the relatively short de-cohere…
A design for a large-scale surface code quantum processor based on a node/network approach is introduced for semiconductor quantum dot spin qubits. The minimal node contains only 7 quantum dots, and nodes are separated on the micron scale, creating useful space for wiring interconnects and integration of conventional transistor circuits. Entanglement is distributed between neighbouring nodes by loading spin singlets locally and then shuttling one member of the pair through a linear array of empty dots. Each node contains one data qubit, two ancilla qubits, and additional dots to facilitate ele…
Quantum computation requires qubits that can be coupled and realized in a scalable manner, together with universal and high-fidelity one- and two-qubit logic gates \cite{DiVincenzo2000, Loss1998}. Strong effort across several fields have led to an impressive array of qubit realizations, including trapped ions \cite{Brown2011}, superconducting circuits \cite{Barends2014}, single photons\cite{Kok2007}, single defects or atoms in diamond \cite{Waldherr2014, Dolde2014} and silicon \cite{Muhonen2014}, and semiconductor quantum dots \cite{Veldhorst2014}, all with single qubit fidelities exceeding th…
