重力作用下圆柱体变形的解析解
Analytical Solution for the Deformation of a Cylinder under Tidal Gravitational Forces
摘要:
在未来的高精度空间探测任务中,有相当一部分将采用光学谐振腔来稳定激光频率,以验证狭义相对论和广义相对论。这些装置用于进行光的各向同性(迈克耳孙-莫雷实验)和引力红移的普适性的测试。由于谐振器频率不仅取决于光速,而且取决于谐振器长度,因此这些测量的质量对光学谐振器本身的弹性形变非常敏感。因此,有必要详细了解空腔的变形情况。因此,在这篇文章中,我们研究在空间环境中的光学谐振腔的建模。通常对于仿真问题,应用有限元法(FEM)以研究干扰对谐振器测量的影响。然而,为了仔细控制FEM模拟的数值质量,与简化谐振器模型的分析解进行比较是有益的。在这篇文章中,我们提出了一个解析解的问题的弹性,各向同性,均匀自由飞行的圆柱体在空间的影响下的潮汐引力。通过求解特殊边界条件下的弹性力学线性方程组,得到了问题的解。应通过将分析解与FEM代码中获得的结果进行比较,验证使用FEM代码进行这些模拟的适用性。
英文摘要:
Quite a few future high precision space missions for testing Special and General Relativity will use optical resonators which are used for laser frequency stabilization. These devices are used for carrying out tests of the isotropy of light (Michelson-Morley experiment) and of the universality of the gravitational redshift. As the resonator frequency not only depends on the speed of light but also on the resonator length, the quality of these measurements is very sensitive to elastic deformations of the optical resonator itself. As a consequence, a detailed knowledge about the deformations of the cavity is necessary. Therefore in this article we investigate the modeling of optical resonators in a space environment. Usually for simulation issues the Finite Element Method (FEM) is applied in order to investigate the influence of disturbances on the resonator measurements. However, for a careful control of the numerical quality of FEM simulations a comparison with an analytical solution of a simplified resonator model is beneficial. In this article we present an analytical solution for the problem of an elastic, isotropic, homogeneous free-flying cylinder in space under the influence of a tidal gravitational force. The solution is gained by solving the linear equations of elasticity for special boundary conditions. The applicability of using FEM codes for these simulations shall be verified through the comparison of the analytical solution with the results gained within the FEM code.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。