Self-similarity has been the paradigmatic picture for the pinch-off of a drop. Here we will show through high-speed imaging and boundary integral simulations that the inverse problem, the pinch-off of an air bubble in water, is not self-similar in a strict sense: A disk is quickly pulled through a water surface, leading to a giant, cylindrical void which after collapse creates an upward and a downward jet. Only in the limiting case of large Froude number the neck radius $h$ scales as $h(-\log h)^{1/4} \propto τ^{1/2}$, the purely inertial scaling. For any finite Froude number the collapse is slower, and a second length-scale, the curvature of the void, comes into play. Both length-scales are found to exhibit power-law scaling in time, but with different exponents depending on the Froude number, signaling the non-universality of the bubble pinch-off.
Analytical considerations and potential flow numerical simulations of the pinch-off of bubbles at high Reynolds numbers reveal that the bubble minimum radius, $r_n$, decreases as $τ\propto r_n^2 \, (-\ln{r_n^2})^{1/2}$, where $τ$ is the time to break-up, when the local shape of the bubble near the singularity is symmetric. However, if the gas convective terms in the momentum equation become of the order of those of the liquid, the bubble shape is no longer symmetric and the evolution of the neck changes to a $r_n\proptoτ^{1/3}$ power law. These findings are verified experimentally.
The pinch-off of an axisymmetric air bubble surrounded by an inviscid fluid is compared in four physical realizations: (i) cavity collapse in the wake of an impacting disc, (ii) gas bubbles injected through a small orifice, (iii) bubble rupture in a straining flow, and (iv) a bubble with an initially necked shape. Our boundary-integral simulations suggest that all systems eventually follow the universal behavior characterized by slowly varying exponents predicted in [Eggers et al., PRL 98, 094502 (2007)]. However, the time scale for the onset of this final regime is found to vary by orders of …
The stability of high-end piezo-acoustic drop-on-demand (DOD) inkjet printing is sometimes compromised by the entrainment of an air bubble inside the ink channel. Here, bubble pinch-off from an acoustically driven meniscus is studied in an optically transparent DOD printhead as a function of the driving waveform. We show that bubble pinch-off follows from low-amplitude higher-order meniscus oscillations on top of the global high-amplitude meniscus motion that drives droplet formation. In a certain window of control parameters, phase inversion between the low and high frequency components leads…
At the point of pinch-off of an underwater air bubble, the speed of water rushing in diverges. Previous studies that assumed radial flow throughout showed that the local axial shape is two smoothly connected, slender cones that transition very slowly (logarithmically) to a cylindrical segment. Our simulations show that even with initially radial flow, a transient vertical flow develops with comparable speeds. Bernoulli pressure draws water into the singularity region while incompressibility forces it away from the neck minimum, generating significant vertical flows that rapidly slenderize and …
Topological singularities occur in a broad range of physical systems, including collapsing stars and pinching fluid interfaces. They are important for being able to concentrate energy into a small region. Underwater air bubbles in particular appear in many practical applications, including new technologies to reduce skin drag on cargo ships. Previous theories show that just before an air bubble pinches off, the neck looks like a cylinder at its very smallest point. Unusually, however, the neck approaches this shape so gradually that the theoretical cylinder solution is not reached in practice;…
The pinch-off of an air bubble from an underwater nozzle ends in a singularity with a remarkable sensitivity to a variety of perturbations. I report on experiments that break both the axial (i.e., vertical) and azimuthal symmetry of the singularity formation. The density of the inner gas influences the axial asymmetry of the neck near pinch-off. For denser gases, flow through the neck late in collapse changes the pinch-off dynamics. Gas density is also implicated in the formation of satellite bubbles. The azimuthal shape oscillations described by Schmidt et al., can be initiated by anisotropic…
The impact of droplets on a liquid pool is ubiquitous in nature and important in many industrial applications. A droplet impacting on a liquid pool can result in the pinch-off of a regular bubble or entrap a large bubble under certain impact conditions. In this study, the cavity deformation and the bubble entrapment during the impact of droplets on a liquid pool are studied by combined experimental measurements and numerical simulations. The time evolution of the free surface profile obtained in the numerical simulation is in good agreement with the experimental results. The cavity created by …
The pressure-driven inertial collapse of a cylindrical void in an inviscid liquid is an integrable, Hamiltonian system that forms a finite-time singularity as the radius of the void collapses to zero. Here it is shown that when the natural cylindrical symmetry of the void is perturbed azimuthally, the perturbation modes neither grow nor decay, but instead cause constant amplitude vibrations about the leading-order symmetric collapse. Though the amplitudes are frozen in time, they grow relative to the mean radius which is collapsing to zero, eventually overtaking the leading-order symmetric imp…
We use high-speed X-ray phase-contrast imaging, weakly nonlinear analysis and boundary integral simulations to characterize the final stage of underwater bubble break-up. The X-ray imaging study shows that an initial azimuthal perturbation to the shape of the bubble neck gives rise to oscillations that increasingly distort the cross-section shape. These oscillations terminate in a pinch-off where the bubble surface develops concave regions that contact similar to what occurs when two liquid drops coalesce. We also present a weakly nonlinear analysis that shows that this coalescence-like mode o…
We study a model for the evolution of an axially symmetric bubble of inviscid fluid in a homogeneous porous medium otherwise saturated with a viscous fluid. The model is a moving boundary problem that is a higher-dimensional analogue of Hele-Shaw flow. Here we are concerned with the development of pinch-off singularities characterised by a blow-up of the interface curvature and the bubble subsequently breaking up into two; these singularities do not occur in the corresponding two-dimensional Hele-Shaw problem. By applying a novel numerical scheme based on the level set method, we show that sol…
The oscillatory flows present in an inkjet printhead can lead to strong deformations of the air-liquid interface at the nozzle exit. Such deformations may lead to an inward directed air jet with bubble pinch-off and the subsequent entrainment of an air bubble, which is highly detrimental to the stability of inkjet printing. Understanding the mechanisms of bubble entrainment is therefore crucial in improving print stability. In the present work, we use ultrafast X-ray phase-contrast imaging and direct numerical simulations based on the Volume-of-Fluid method to study the mechanisms underlying t…
We investigate the gas jet breakup and the resulting microbubble formation in a microfluidic flow-focusing device using ultra high-speed imaging at 1 million frames/s. In recent experiments [Dollet et al., Phys. Rev. Lett. 100, 034504 (2008)] it was found that in the final stage of the collapse the radius of the neck scales with time with a 1/3 power-law exponent, which suggested that gas inertia and the Bernoulli suction effect become important. Here, ultra high-speed imaging was used to capture the complete bubble contour and quantify the gas flow through the neck. It revealed that the resul…
Using mixtures of soap, water, and long chain polymers, free-floating soap bubbles can be formed with volumes approaching 100 m$^3$. Here we investigate how such thin films are created and maintained over time. We show how the extensional rheology is the most important factor in creating the bubble, and how polydispersity in molecular weight of the solvated polymers leads to better performance at lower concentrations. Additionally, using IR absorption, we measure soap film thickness profiles and film lifetimes. Although the initial thickness mostly depends on the choice of detergent, polymers …
We study singular jets from the collapse of drop-impact craters, when the drop and pool are of different immiscible liquids. These jets emerge from a dimple at the bottom of the rebounding crater, when no bubble is pinched off. The parameter space is considerably more complex than for identical liquids, revealing intricate compound-dimple shapes. In contrast to the universal capillary-inertial drop-regime, where the pinch-off neck radius scales as $R\sim t^{2/3}$, a purely inertial air-dimple has $R \sim t^{1/2}$ and is sensitive to initial and boundary conditions. Capillary waves can therefor…
Big bubbles are largely used in physics laboratories to study 2D turbulence, surface wavers, fundamental properties of soap systems... On a more artistic point of view, blowing big bubbles is part of many artistic shows. Both communities usually wan to get reasonably stable foam films. The purpose of this article is to propose the main physical ingredients allowing to identify a good recipe for making stable films and bubbles. We propose controlled experiments, to measure both the easiness to generate a bubble and its stability for different stabilizing solutions, which we choose by adding one…
Acoustic Signatures of Pinch-Off Cavities During Water-Entry
College of Shipbuilding Engineering, Harbin Engineering University（哈尔滨工程大学船舶工程学院）；Nanhai Institute of Harbin Engineering University（哈尔滨工程大学南海研究院）；Southampton Ocean Engineering Joint Institute, Harbin Engineering University（哈尔滨工程大学南安普顿海洋工程联合学院）；National Key Lab of Ship Structural Safety, Harbin Engineering University（哈尔滨工程大学船舶结构安全国家重点实验室）
We report a detailed experimental characterization of the periodic bubbling regimes that take place in an axisymmetric air-water jet when the inner air stream is forced by periodic modulations of the pressure at the upstream air feeding chamber. When the forcing pressure amplitude is larger than a certain critical value, the bubble formation process is effectively driven by the selected frequency, leading to the formation of nearly monodisperse bubbles whose volume is reduced by increasing the forcing frequency. We reveal the existence of two different breakup modes, M1 and M2, under effective…
Nonlinear optical processes are vital for fields including telecommunications, signal processing, data storage, spectroscopy, sensing, and imaging. As an independent research area, nonlinear optics began with the invention of the laser, because practical sources of intense light needed to generate optical nonlinearities were not previously available. However the high power requirements of many nonlinear optical systems limit their use, especially in portable or medical applications, and so there is a push to develop new materials and resonant structures capable of producing nonlinear optical p…
Water-immersed gold nanoparticles irradiated by a laser can trigger the nucleation of plasmonic bubbles after a delay time of a few microseconds [Wang et al., Proc. Natl. Acad. Sci. USA 122, 9253,(2018)]. Here we systematically investigated the light-vapor conversion efficiency, η, of these plasmonic bubbles as a function of the ambient pressure. The efficiency of the formation of these initial-phase and mainly water-vapor containing bubbles, which is defined as the ratio of the energy that is required to form the vapor bubbles and the total energy dumped in the gold nanoparticles before nucle…
All children enjoy blowing soap bubbles that also show up in our bath and when we wash dishes. We analyze the thinning and breaking of soap bubble neck when it is stretched. To contrast with the more widely studied film whose boundaries are open, we concentrate on the bubble with a conserved air volume V. Like film (F), non-equilibrium state can be divided into four regimes for bubble (B): (1) roll-off, (2) cusp approach, (3) pinch-off and (4) breakup. We establish the existence of self-similarity in F-1, B-1 and B-3, and universal property in F-1 and B-1 for the profile of soap membrane. The …
Bubble dynamics and luminol emissions of cavitation in sub-millimeter-sized PFA flow tubes, submerged in an ultrasonic bath reactor, are studied at 27 kHz driving frequency. Nucleation of cavitation inside the tubes only takes place via a free interface, realized here in form of an alternating water-air slug flow. High-speed recordings show that cavitation bubbles in the water slugs often develop localized structures in form of clusters or bubble plugs, and that such structures can be seeded via a single pinch-off from the free interface. Within the structures, bubbles strongly interact and fr…
We report about an intriguing boiling regime occurring for small heaters embedded on the boundary in subcooled water. The microheater is realized by focusing a continuous wave laser beam to about $10\,μ$m in diameter onto a 165\,nm-thick layer of gold, which is submerged in water. After an initial vaporous explosion a single bubble oscillates continuously and repeatably at several $100\,$kHz. The microbubble's oscillations are accompanied with bubble pinch-off leading to a stream of gaseous bubbles into the subcooled water. The self-driven bubble oscillation is explained with a thermally kicke…
In 1904, while experimenting with high-speed photography, Lucien Bull recorded a pellet passing through a soap bubble. We investigate the dynamics that allow for a rigid body to pass through a hemispherical soap film without rupturing it. In this fluid dynamics video spheres were dropped from rest above a hemispherical soap film. At impact, the soap film stretches into a cavity around the sphere. As the sphere continues to descend, the film cavity pinches off and the film returns to its initial hemispherical shape. Upon closer observation of the film-sphere-air interface, the stability of the …
Under continuous laser irradiation, noble metal nanoparticles immersed in water can quickly heat up, leading to the nucleation of so-called plasmonic bubbles. In this work, we want to further understand the bubble nucleation and growth mechanism. In particular, we quantitatively study the effect of the amount of dissolved air on the bubble nucleation and growth dynamics, both for the initial giant bubble, which forms shortly after switching on the laser and is mainly composed of vapor, and for the final life phase of the bubble, during which it mainly contains air expelled from water. We found…
