X-Ads降液管热分层的CFD模拟
CFD Simulation of X-Ads Downcomer Thermal Stratification
摘要:
本文采用CFX 4.4软件对能量放大器实验装置(X-ADS)降液管通道进行了数值模拟。仿真的重点是稳态分析。X-ADS参考配置的中间换热器(IHX)浸没在下降管的铅铋共晶中。由于一回路冷却剂热收集器和冷收集器之间没有物理隔离,因此在下降管区域中有两种不同的流动路径:IHX内部和外部(IHX旁通流)。IHX旁通流量由浮力驱动力(由IHX内部冷却流体和外部热降液管流体之间的重量差产生)和IHX压力损失之间的平衡决定。在IHX出口处,两条流路在堆芯入口之前混合。这一事实提供了下降管热分层的可能性,其受到IHX外部冷却剂流速的实际值的影响。热分层现象的数量和范围是本研究的对象。模拟允许研究的位置和强度的热分层现象。已进行了多次运行。然而,为了限制本文的扩展,我们只处理其中一个计算的结果,从结构上的热负荷的角度来看,这导致了最坏的条件。所获得的其他结果将在需要时在短期内回顾。
英文摘要:
This work presents a numerical simulation using CFX 4.4 of the Energy Amplifier Experimental Facility (X-ADS) downcomer channel. The simulation is focused on the Steady-State Analysis. The Intermediate Heat exchangers (IHX) of the X-ADS reference configuration are immersed in the lead-bismuth eutectic of the downcomer. Due to the absence of a physical separation between the primary coolant hot and cold collectors, two different flow paths are available in the downcomer region: inside the IHX and outside it (IHX by-pass flow). The amount of IHX by-pass flow is determined by the balance between the driving force due to buoyancy (originated by the weight difference between the cooled fluid inside the IHX and the hot outside downcomer fluid) and the IHX pressure losses. At the IHX exit the two flow paths are mixed before the core inlet. This fact provides a potential for a downcomer thermal stratification, which is influenced by the actual value of coolant flow rate outside the IHX. The amount and extension of the thermal stratification phenomena is the object of this study. The simulation allowed studying the position and intensity of the thermal stratification phenomena. Several runs have been performed. However, to limit the extension of the paper, we deal with the results of only one of the calculations performed, which resulted in the worst condition from the point of view of thermal loads on the structure. Other results obtained will be shortly recalled when needed.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。