用于软格栅系统的双向光学传感器(BOAT)用于驱动跟踪
Bidirectional Optical sensors for Actuation Tracking (BOAT) in soft lattice systems
AI总结:
本文提出了一种基于椭球几何排列的双波导光学传感器(BOAT),用于监测软格栅结构的全局变形,特别是压缩和伸展,并通过实验验证了其在压力循环中的高重复性和可靠性。
摘要:
随着格栅结构在软机器人中的广泛应用,需要更先进的传感解决方案来监测其整体变形,特别是压缩和伸展。本文通过引入基于两个图案化波导的新型光学传感器来解决这一挑战。该双向光学传感器用于驱动跟踪(BOAT)与一个由嵌入式气动人工肌肉(PAM)驱动的格栅结构无缝共印制,并对其性能进行了评估。在PAM伸长或收缩时,嵌入的BOAT波导的弯曲会引起输出信号的变化,从而能够清楚地区分压缩和伸展状态。两种波导结构(通过表面图案化)和传感器化的格栅单元嵌入两个BOAT的设计均通过数值模拟得到支持。经过100次连续的压力循环(从+50 kPa到-40 kPa)的实验校准,显示出高度可重复的响应,使得能够可靠地区分伸展和压缩。最后,利用传感器反馈实现数字影子,使整个传感器化单元与其虚拟对应物持续同步。这些结果证明了BOAT在软格栅机器人系统变形监测中的强大和可靠作用。
英文摘要:
The growing adoption of lattice-based structures in soft robotics creates a need for advanced sensing solutions capable of monitoring their global deformation, particularly compression and extension. In this work, we address this challenge by introducing a novel optical sensor based on two patterned waveguides arranged in an ellipsoidal geometry. This Bidirectional Optical sensor for Actuation Tracking (BOAT) is seamlessly co-printed with a lattice structure actuated by an embedded pneumatic artificial muscle (PAM), and its performance is assessed. During PAM elongation or contraction, the bending of the embedded BOAT waveguides induces output signal variations that enable a clear discrimination between compression and extension states. The designs of both each specific waveguide structure (by surface patterning) and of the sensorized lattice-based unit embedding two BOATs are supported by numerical simulations. Experimental calibration over 100 consecutive pressure cycles ranging from +50 kPa to $-$40 kPa demonstrates a highly repeatable response, allowing a reliable distinction between extension and compression. Finally, sensor feedback is used to implement a digital shadow, enabling continuous synchronization between the whole sensorized unit and its virtual counterpart. These results establish BOAT as a powerful and reliable approach for deformation monitoring in soft lattice-based robotic systems.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。