arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 2603.15528cs.RO
收藏

在抑制振荡视角下不同ially平坦欠驱动平面机器人的最优控制

Optimal control of differentially flat underactuated planar robots in the perspective of oscillation mitigation

Department of Industrial Engineering, University of Padova(帕多瓦大学工业工程系)

Stefano Lovato, Michele Tonan, Matteo Bottin, Matteo Massaro, Alberto Doria, Giulio Rosati

AI总结:

本文研究了欠驱动平面机器人在抑制振荡视角下的最优控制方法,通过动态平坦性理论和优化控制相结合,提升轨迹跟踪性能,减少因关节 stiffness/damping 不匹配引起的振荡。

摘要:

欠驱动机器人具有比执行器更多的自由度,若设计有特定质量分布,可通过微分平坦性理论进行控制。这种结构特性使开发轻量化且成本效益高的机器人系统成为可能,但管理被动关节是一个关键挑战,其控制需要精确且全面的系统动态建模。为了简化动态模型,特别是低速轨迹,摩擦常被忽略。虽然这一假设简化了分析和控制设计,但会引入末端执行器围绕目标位置的残余振荡。本文研究了利用最优控制与微分平坦性控制相结合的可能性,以提高规划轨迹的跟踪性能。首先通过形式分析进行研究,然后通过数值模拟验证。结果表明,最优控制可用于考虑不同(二次)性能指标的平坦变量规划:控制努力,即电机扭矩,以及所考虑欠驱动关节的势能。此外,势能的最小化可用于设计对欠驱动关节刚度和阻尼变化具有鲁棒性的运动规律,从而在刚度/阻尼不匹配的情况下减少振荡。

英文摘要:

Underactuated robots are characterized by a larger number of degrees of freedom than actuators and if they are designed with a specific mass distribution, they can be controlled by means of differential flatness theory. This structural property enables the development of lightweight and cost-effective robotic systems with enhanced dexterity. However, a key challenge lies in managing the passive joints, whose control demands precise and comprehensive dynamic modeling of the system. To simplify dynamic models, particularly for low-speed trajectories, friction is often neglected. While this assumption simplifies analysis and control design, it introduces residual oscillations of the end-effector about the target position. In this paper, the possibility of using optimal control along with differential flatness control is investigated to improve the tracking of the planned trajectories. First, the study was carried out through formal analysis, and then, it was validated by means of numerical simulations. Results highlight that optimal control can be used to plan the flat variables considering different (quadratic) performance indices: control effort, i.e. motor torque, and potential energy of the considered underactuated joint. Moreover, the minimization of potential energy can be used to design motion laws that are robust against variation of the stiffness and damping of the underactuated joint, thus reducing oscillations in the case of stiffness/damping mismatch.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑