arXivDaily arXiv每日学术速递 周一至周五更新
arXiv周末暂无论文更新,休息一下吧,周末愉快~~
arXiv 2511.01787eess.SP
收藏

通过插入损耗偏差量化对内偏斜影响的实用方法

Practical Approaches to Quantifying Intra-Pair Skew Impact via Insertion Loss Deviation

Cisco Systems Inc.(思科系统公司)

David Nozadze, Zurab Kiguradze, Amendra Koul, Sayed Ashraf Mamun, Mike Sapozhnikov

AI总结:

针对超高速互连中对内偏斜量化方法的局限,本文提出SILD和FOM SILD两个互易参数,实验证明其与误码率强相关,为高速互连评估提供了实用指标。

摘要:

AI工作负载的激增和数据中心需求的不断升级,催生了对超过200 Gb/s的超高速互连的需求。随着单位间隔(UI)不断缩小,即使是几皮秒的对内偏斜也会显著降低串行器/解串器(SerDes)的性能。为了量化对内偏斜的影响,传统的时域方法对于耦合互连通常不可靠,因为不同电压电平下的偏斜会发生变化;而频域方法往往无法解决互易性和对称性问题。这可能导致通道在一个方向上满足偏斜规范,而在另一个方向上却不满足,尽管偏斜影响本质上具有互易性。为了解决这些局限性,我们引入了两个新的互易参数来量化对内偏斜效应:偏斜诱导的插入损耗偏差(SILD)及其补充的优值(FOM SILD)。使用224 Gb/s SerDes IP和具有不同对内偏斜的各种通道进行的测量表明,FOM SILD与误码率(BER)之间存在很强的相关性。结果表明,当FOM SILD低于0.2-0.3 dB时,BER保持稳定,表明信号完整性下降极小;然而,当FOM SILD超过0.3 dB时,BER明显增加。对3000多根高速双轴电缆的统计分析显示,大多数电缆的FOM SILD值小于0.1 dB,这突显了所提出的指标在高速互连评估中的实用相关性。

英文摘要:

The surge in AI workloads and escalating data center requirements have created demand for ultra-high-speed interconnects exceeding 200 Gb/s. As unit intervals (UI) shrink, even a few picoseconds of intra-pair skew can significantly degrade serializer-deserializer (SerDes) performance. To quantify the impact of intra-pair skew, conventional time-domain methods are often unreliable for coupled interconnects due to skew variations across voltage levels, while frequency-domain approaches frequently fail to address reciprocity and symmetry issues. This can result in channels that meet skew specifications in one direction but not the other, despite the inherently reciprocal nature of skew impact. To address these limitations, we introduce two new reciprocal parameters for quantifying intra-pair skew effects: Skew-Induced Insertion Loss Deviation (SILD) and its complementary Figure of Merit (FOM SILD). Measurements conducted using 224 Gb/s SerDes IP and a variety of channels with different intra-pair skews demonstrate a strong correlation between FOM SILD and bit error rate (BER). Results show that when FOM SILD is below 0.2-0.3 dB, BER remains stable, indicating minimal signal integrity degradation; however, BER increases noticeably as FOM SILD exceeds 0.3 dB. Statistical analysis across more than 3,000 high-speed twinax cables reveals that the majority exhibit FOM SILD values less than 0.1 dB, underscoring the practical relevance of the proposed metrics for high-speed interconnect assessment.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑