arXivDaily arXiv每日学术速递 周一至周五更新
arXiv周末暂无论文更新,休息一下吧,周末愉快~~
arXiv 2510.05084physics.plasm-ph
收藏

电喷射推进器喷流对立方星太阳能阵列的冲击:粒子追踪研究

Electrospray Thruster Plume Impingement on CubeSat Solar Arrays: A Particle-Tracking Study

Ethan Kahn

AI总结:

研究通过粒子追踪模拟分析电喷射推进器位置对立方星推力效率和表面污染的影响,发现侧置推进器可完全消除冲击,而可展开太阳能阵列能显著降低污染。

摘要:

电喷射推进器正成为立方星的主要推进技术,提供高比冲(I_sp>1000秒)和低功率需求。然而,发散的离子喷流可能冲击航天器表面,特别是安装在主体上的太阳能阵列,导致污染和推力效率损失。本研究提出了一种经过验证的粒子追踪模拟,以量化推进器位置对推力效率和表面污染的影响,针对1U、3U和6U立方星。喷流模型采用余弦幂分布(k=1.8)和半角46度,经实验数据验证,误差低于7%。结果显示,推力效率范围从3U主体安装配置后置推进器的53.6%到侧置配置可展开阵列的100%。立方星尺寸显著影响冲击:3U平台在后置推进器时污染率为46.4%,而1U为16.6%。可展开太阳能阵列相比主体安装阵列可减少污染77%,而侧置推进器完全消除冲击,仅导致1.6%的效率损失。角落安装配置在30度时提供中间性能,效率为88.9%,污染率为11.1%。这些定量设计指南使任务规划者能够基于功率预算和推进剂质量约束优化推进器集成,所有配置的统计不确定性低于0.15%。

英文摘要:

Electrospray thrusters are emerging as a leading propulsion technology for CubeSats, offering high specific impulse ($I_{sp} > 1000$ s) and low power requirements. However, the divergent ion plumes can impinge on spacecraft surfaces, particularly body-mounted solar arrays, causing contamination and thrust efficiency losses. This study presents a validated particle-tracking simulation to quantify the effects of thruster placement on thrust efficiency and surface contamination for 1U, 3U, and 6U CubeSats. The plume model employs a cosine power distribution ($k=1.8$) with half-angle $46^\circ$, validated against experimental data with errors below 7%. Results show that thrust efficiency ranges from 53.6% for rear-mounted thrusters on 3U body-mounted configurations to 100% for side-mounted configurations with deployable arrays. CubeSat size significantly affects impingement: 3U platforms experience 46.4% contamination with rear-mounted thrusters compared to 16.6% for 1U. Deployable solar arrays reduce contamination by 77% compared to body-mounted arrays, while side-mounted thrusters eliminate impingement entirely at the cost of only 1.6% efficiency loss. Corner-mounted configurations at $30^\circ$ cant provide intermediate performance with 88.9% efficiency and 11.1% contamination. These quantitative design guidelines enable mission planners to optimize thruster integration based on power budget and propellant mass constraints, with statistical uncertainty below 0.15% across all configurations.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑