利用障碍物促进三维颗粒流
Facilitating a 3D granular flow with an obstruction
AI总结:
通过实验和模拟发现,在出口附近放置障碍物可利用几何机制有效抑制三维颗粒流堵塞,且最佳位置由简单几何规则决定,可推广至其他颗粒系统。
摘要:
确保颗粒从出口顺畅流出且不发生不可预测的堵塞事件,对于粉末和谷物加工至关重要。我们通过实验和模拟表明,在出口附近放置障碍物可以极大地抑制三维颗粒流中的堵塞形成;这种反直觉的现象此前已在二维系统中得到证实。值得注意的是,即使障碍物横截面仅与单个颗粒相当,且仅占出口面积的极小部分,抑制堵塞的效果也非常显著。来自两种不同障碍物形状的数据表明,抑制堵塞的底层机制是几何的:虽然效应的幅度可能受动力学因素影响,但障碍物的最佳位置完全由简单的几何规则决定。最佳放置的障碍物使最可能形成的堵塞拱处于危险且不稳定的位置,此处局部流动几何处于扩张点,轻微扰动即可使拱失去下游支撑。这一几何原理不依赖先前推测的动力学机制,可推广至其他基于智能体和颗粒的系统。
英文摘要:
Ensuring a smooth rate of efflux of particles from an outlet without unpredictable clogging events is crucial in processing powders and grains. We show by experiments and simulations that an obstacle placed near the outlet can greatly suppress clog formation in a 3-dimensional granular flow; this counterintuitive phenomenon had previously been demonstrated in 2-dimensional systems. Remarkably, clog suppression is very effective even when the obstacle cross-section is comparable to that of a single grain, and is only a small fraction of the outlet area. Data from two dissimilar obstacle shapes indicate that the underlying mechanism for clog suppression is geometric: while the magnitude of the effect can be affected by dynamical factors, the optimal location of the obstacle is determined entirely by a simple geometric rule. An optimally-placed obstacle arranges for the most-probable clogging arch to be at a perilous and unstable spot, where the local flow geometry is at a point of expansion and a slight perturbation leaves the arch without downstream support. This geometric principle does not rely on previously conjectured dynamical mechanisms and admits generalization to other agent-based and particulate systems.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。