凸多面体域上Neumann最优控制问题的数值分析
Numerical Analysis for Neumann Optimal Control Problems on Convex Polyhedral Domains
AI总结:
本文研究凸多面体域上Neumann边界控制问题的有限元误差估计,针对不同离散方案建立误差界,分析内棱角对收敛速率的影响,证明状态量二阶收敛与棱角无关,并用数值实验验证理论结果。
摘要:
本文研究凸多面体域上Neumann边界控制问题的有限元误差估计。文中考虑了不同的离散化概念,并针对每种最优离散化方法建立了误差估计。具体而言,对于控制量采用分段线性全局连续函数、状态量采用标准线性有限元的完全离散化方案,本文证明了控制量的最优收敛速率仅取决于最大内棱角。更精确地说,当内棱角低于临界角$2π/3$时,边界上离散控制量的$L^2$范数可达到二阶收敛速率(含对数因子)。对于更大的内棱角,收敛速率会根据角度大小降低,这是由解中奇异项(依赖于域)的影响导致的。所得结果与二维情形的结果相当,但本文采用了该领域的新技术来证明边界上的估计,这些技术同样可推广到二维情形。此外,本文证明了域内离散状态量的$L^2$范数以二阶速率收敛,且与内棱角无关,即适用于任意凸多面体域。值得注意的是,这一结论不仅对控制量采用分段线性全局连续函数的完全离散化成立,对控制量采用分段常数函数的完全离散化同样成立,而后者的离散控制量在边界$L^2$范数下最多仅能达到一阶收敛速率。最后,通过若干数值实验验证了上述理论结果。
英文摘要:
This paper is concerned with finite element error estimates for Neumann boundary control problems posed on convex and polyhedral domains. Different discretization concepts are considered and for each optimal discretization error estimates are established. In particular, for a full discretization with piecewise linear and globally continuous functions for the control and standard linear finite elements for the state optimal convergence rates for the controls are proven which solely depend on the largest interior edge angle. To be more precise, below the critical edge angle of $2π/3$, a convergence rate of two (times a log-factor) can be achieved for the discrete controls in the $L^2$-norm on the boundary. For larger interior edge angles the convergence rates are reduced depending on their size, which is due the impact of singular (domain dependent) terms in the solution. The results are comparable to those for the two dimensional case. However, new techniques in this context are used to prove the estimates on the boundary which also extend to the two dimensional case. Moreover, it is shown that the discrete states converge with a rate of two in the $L^2$-norm in the domain independent of the interior edge angles, i.e. for any convex and polyhedral domain. It is remarkable that this not only holds for a full discretization using piecewise linear and globally continuous functions for the control, but also for a full discretization using piecewise constant functions for the control, where the discrete controls only converge with a rate of one in the $L^2$-norm on the boundary at best. At the end, the theoretical results are confirmed by several numerical experiments.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。