水平剪切对从表面波数据中提取水流的影响
The Effect of Horizontal Shear on Extracting Water Currents From Surface Wave Data
AI总结:
本文分析了水平剪切对基于表面波色散提取水流的影响,发现高度定向波谱在视场内水流变化达10%时会产生强烈偏差,并提出了发现偏差的实际步骤。
摘要:
表面波的色散运动现在被常规用于遥感测量海洋和其他自然流体表面下方的近表层水流。水流在时空波谱中表现为与波长相关的多普勒频移,该波谱是通过对观测波场进行傅里叶变换获得的,此过程假设水流在视场内是水平均匀的。这一假设通常难以满足。我们在此分析了速度场中存在水平剪切的影响,特别强调了偏差:即“测量”速度在大小和/或方向上与视场内的平均水流存在系统性差异。我们根据在域中心处规定的波谱生成随机合成波数据,并改变水流及其梯度,以及波传播方向的平均方向 $θ_0$ 和角扩散,从中我们使用最常见的数值方法之一提取多普勒频移速度(DSVs)。假设水流在视场内的变化高达特征波相速度的 10%,我们发现对于高度定向的波谱可能会出现强烈偏差,且强烈依赖于 $θ_0$ 以及水流方向相对于其幅度梯度的方向。我们讨论了 DSV 提取过程中偏差是如何产生的,并提出了发现偏差的实际步骤。
英文摘要:
The dispersive motion of surface waves is now routinely used to remotely measure the currents close beneath the surface of oceans and other natural flows. The current manifests as wavelength-dependent Doppler shifts in the spatiotemporal wave spectrum, which is obtained by performing a Fourier transform of an observed wave field, a procedure which assumes that the current is horizontally uniform within the field of view. This assumption is frequently not satisfied. We here analyze the effects of the presence of horizontal shear in the velocity field, with special emphasis on biases: ``measured'' velocities which differ systematically in magnitude and/or direction compared to the average current within the field of view. We generate random synthetic wave data according to a spectrum prescribed at the domain center while varying the current and its gradient, and the mean direction $θ_0$ and angular spread of the waves' propagation direction, from which we extract Doppler shift velocities (DSVs) using one of the most common numerical schemes. Assuming currents vary by up to 10\% of a characteristic wave phase velocity across the field of view, we find that strong biases can occur for highly directional wave spectra, strongly dependent on $θ_0$ and the current direction relative to that of its magnitude gradient. We discuss how biases arise in the DSV extraction procedure and suggest practical steps to discover the presence of biases.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。