Seismic mapping of the top of the inner core indicates two distinct areas of high P-wave velocity, the stronger one located beneath Asia, and the other located beneath the Atlantic. This two-fold pattern supports the idea that a lower-mantle heterogeneity can be transmitted to the inner core through outer core convection. In this study, a two-component convective dynamo model, where thermal convection is near critical and compositional convection is strongly supercritical, produces a substantial inner core heterogeneity in the rapidly rotating strongly driven regime of Earth's core. While the temperature profile that models secular cooling ensures that the mantle heterogeneity propagates as far as the inner core boundary (ICB), the distribution of heat flux at the ICB is determined by the strength of compositional buoyancy. A large heat flux variation $q^*$ of $O(10)$ at the core-mantle boundary (CMB), where $q^*$ is the ratio of the maximum heat flux difference to the mean heat flux at the CMB, produces a core flow regime of long-lived convection in the east and time-varying convection in the west. Here, the P-wave velocity estimated from the ICB heat flux in the dynamo is higher in the east than in the west, with the hemispherical difference of the same order as the observed lower bound, 0.5%. Additional observational constraints are satisfied in this regime -- the variability of high-latitude magnetic flux in the east is lower than that in the west; and the stratified F-layer at the base of the outer core, which is fed by the mass flux from regional melting of the inner core and magnetically damped, attains a steady-state height of $\sim$ 200 km.
Assessing the enrichment of heat-producing elements in deep-mantle structures using a directional geoneutrino detector
Tohoku University(东北大学);Research Center for Neutrino Science, Tohoku University(东北大学中微子科学研究中心);Center for Geoneutrino Research, Institute of Oceanology, Chinese Academy of Sciences(中国科学院海洋研究所地球中微子研究中心);Department of Earth Science, Tohoku University(东北大学地球科学系);Department of Geological, Environmental, and Planetary Sciences, University of Maryland(马里兰大学地质、环境与行星科学系);University of Maryland(马里兰大学);High Energy Accelerator Research Organization (KEK)(高能加速器研究机构(KEK))
Modelling of thermal stratification at the top of a planetary core: Application to the cores of Earth and Mercury and the thermal coupling with their mantles
月球的地幔、流体核和固体内核的自旋轴以$Ω_p=2π/18.6$ yr $^{-1}$的频率进动,尽管方向不同,导致核幔边界(CMB)和内核边界(ICB)处的粘性摩擦。在这里,我们使用一个旋转模型的月球与一系列的内核和外核半径调查粘性耗散的相对重要性在CMB和ICB,并显示这种耗散是如何连接到相位超前角($ϕ_p$)的地幔提前卡西尼状态。我们表明,当内核半径为$>80$公里和自由内核章动频率$Ω_{ficn}$的方法$Ω_p$,粘性耗散在ICB可以媲美的CMB,并在最极端的情况下超过它多达10倍。如果是这样的话,那么月球核心中的粘性耗散在时间上的投射取决于$Ω_{ficn}$相对于$Ω_p$的演变。我们进一步表明,在月球核心的CMB和ICB半径的约束,原则上可以通过匹配观测到的相位铅的$ϕ_p=0.27$角秒,这需要一个改进的估计潮汐耗散和湍流粘性扭矩的准确模型。最后,当我们的旋转模型被约束到匹配$ϕ_p=0.27$ arcsec时,我们的结果表明,在ICB的粘性耗散可能不足以超过热驱动发电机的阈值。
Reconciliation of experiments and theory on transport properties of iron and the geodynamo
来自核心的热量传输量,限制了该地区的动力学和热演化,取决于铁的传输特性。Ohta等人(2016)和Konopkova et al.(2016)在相关的地球核心压力-温度(P-T)条件下,分别在激光加热的金刚石对顶砧单元(DAC)中测量铁的电阻率和热导系数,并获得了非常矛盾的结果。在这里,我们测量hcp-铁的电阻率高达~170 GPa和~3,000 K使用四探针范德堡方法耦合均匀平顶激光加热DAC。我们还计算了它的电导率和热导系数的第一性原理方法,包括电子-声子和电子-电子散射。我们发现,测量的hcp-铁的电阻率随温度的升高几乎呈线性增加,并与当前的第一性原理计算是一致的。hcp-铁的电阻率和热导系数之间的比例系数(洛伦兹数)与理想值(2.44*10^-8 W Ω·K^-2)不同,因此使用~(2.0-2.1)*10^-8 W Ω·K^-2的非理想洛伦兹数将实验电阻率转换为hcp-铁在高P-T下的热导系数。结果表明,在核幔边界附近,hcp铁的电阻率和热导系数分别为80(5)u Ω cm和100(10)W/mK。我们的研究结果表明,通过核-幔边界的液态铁合金外核的绝热热流约为10(1)TW,支持当今地球发电机驱动的热对流通过核心的长期冷却和成分对流通过潜热和重力能在内核的凝固。