arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 2408.00176astro-ph.IM
收藏

开发与实现一颗立方体卫星的运动方程

Developing and implementing a CubeSat's equations of motion

Liam Wheen, Oscar Benjamin

AI总结:

针对布里斯托尔 PROVE 任务中立方体卫星跟踪地面目标的需求,本文推导运动方程并设计飞轮姿态控制器,通过仿真分析误差来源并确定各组件的最低性能要求。

摘要:

作为布里斯托尔 PROVE 任务的一部分,一颗位于低地球轨道的纳米卫星需要在 400 秒的飞越过程中跟踪一个地面目标。这要求敏捷的姿态控制,并将通过一套飞轮系统来实现。为了计算这些飞轮所需的力矩,设计了一个控制器。利用新推导出的系统运动方程,得到了一个用于优化增益的表达式。借助该控制器,进行了仿真以评估目标指向中最大的误差来源。干扰力矩被控制器安全地处理,但导致飞轮转速增加了 12%,达到 8325 转/分钟。这一更高的转速导致陀螺力矩增大,在最坏情况下达到 10^-7 牛·米。然而,由于飞轮能够提供 10^-5 牛·米的力矩,控制器也能够对此进行校正。随后改变硬件性能,以评估每个组件对指向精度的影响。结果发现,在最坏情况下,姿态传感器噪声会使指向误差增加 1.9 度。随后为每个组件确定了最低性能要求,以维持可接受的指向精度。

英文摘要:

As part of the Bristol PROVE mission, a nano satellite in low Earth orbit will be required to track a ground based target during a 400 second flyover. This requires agile attitude control that will be achieved using a system of flywheels. To calculate the necessary torque from these flywheels, a controller was designed. Using newly derived equations of motion for the system, an expression to optimise the gains was produced. With this controller, simulations were run to evaluate the largest causes of error in target pointing. Disturbance torques were safely handled by the controller, but led to a 12% increase in wheel speeds, reaching 8325 rpm. This higher speed led to an increased gyroscopic torque, reaching 10^-7 Nm in the worst case. However since the flywheels can deliver 10^-5 Nm of torque, the controller could also correct for this. Hardware performance was then varied to assess the effect of each component on pointing accuracy. Attitude sensor noise was found to increase pointing error by 1.9 degrees in the worst case. Minimum performance requirements were then determined for each component in order to maintain an acceptable pointing accuracy.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑