基于无人机的北极高纬度地区天线波束校准
Drone-Based Antenna Beam Calibration in the High Arctic
AI总结:
针对北极高纬度地区ALBATROS射电干涉仪天线波束校准难题,提出用配备校准射频发射器的无人机平台PteroSoar进行现场测量,生成50MHz时二维波束图,精度约10%,并有望将不确定性降至5%以下,为相关实验校准提供途径。
摘要:
精确校准是未来早期宇宙超低频观测的关键要求。位于加拿大北极高纬度地区的长基线射电天线阵列(ALBATROS),作为未来实验的探路者,旨在绘制银河前景发射图。在这些频率下进行精确的天线波束表征至关重要,但极具挑战性。我们展示了PteroSoar,这是一个定制的无人机平台,配备了校准过的射频发射器,能够对低频天线波束进行可控的现场测量。作为初步演示,我们生成了ALBATROS天线在50MHz时的二维波束图,天顶附近精度约为10%。我们确定了系统不确定性的主要来源,包括时间不精确性,并概述了有望将波束测量不确定性降低到5%以下的硬件和软件改进措施。该目标低于这些频率下电离层闪烁引入的约20%幅度变化,为ALBATROS和其他超低频射电实验的精确波束校准提供了实用途径。
英文摘要:
Precision calibration is a critical requirement for future ultra-low-frequency observations of the early universe. The Array of Long Baseline Antennas for Taking Radio Observations from the Seventy-Ninth Parallel (ALBATROS), a radio interferometer located in the Canadian high Arctic, is designed to map Galactic foreground emission as a pathfinder for these future experiments. Accurate antenna beam characterization at these frequencies is therefore essential, yet remains uniquely challenging. We present PteroSoar, a custom-built drone platform equipped with a calibrated radio-frequency transmitter that enables controlled, in-situ measurements of low-frequency antenna beams. As an initial demonstration, we produce a two-dimensional beam map of an ALBATROS antenna at 50~MHz to a precision of approximately $10\%$ near zenith. We identify the dominant sources of systematic uncertainty, including timing imprecision, and outline hardware and software improvements that are expected to reduce beam measurement uncertainties to below $5\%$. This target is sub-dominant to the $\sim20\%$ amplitude variability introduced by ionospheric scintillation at these frequencies, providing a practical pathway toward precision beam calibration for ALBATROS and other ultra-low-frequency radio experiments.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。