arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 2405.02022cs.NI
收藏

STX-Vote:在基于同步传输的物联网网络中通过比特投票提升可靠性

STX-Vote: Improving Reliability with Bit Voting in Synchronous Transmission-based IoT Networks

Burhanuddin Rangwala, Ava Powelson, Michael Baddeley, Israat Haque

AI总结:

针对基于同步传输的工业物联网网络存在的拍频效应导致丢包的问题,提出利用协议固有传输冗余、无额外开销的STX-Vote比特投票纠错方案,经仿真和实物实验验证可有效提升不同物理层的传输可靠性,可补充现有纠错方案。

摘要:

工业物联网(IIoT)网络必须满足严格的可靠性、延迟和低能耗要求。然而,传统低功耗无线协议难以在这些性能指标间找到最佳平衡点。近年来,基于同步传输(Synchronous Transmissions, STX)的网络洪泛协议被提出,用于对可靠性要求极高的IIoT场景,这类协议支持同时传输且不会发生数据包冲突。基于STX的协议相比基于路由的协议具备竞争优势,尤其是在可靠性方面。但它们存在明显的拍频效应问题——这是一种物理层现象,会在整个数据包上产生正弦干扰,进而导致丢包。为此,我们提出STX-Vote,一种可处理拍频效应引发错误的纠错方案。重要的是,我们利用了STX协议固有的传输冗余,因此不会产生额外的空中传输开销。通过仿真,我们证明STX-Vote可将可靠性提升40%。随后我们在nRF52840-DK设备上实现了STX-Vote并开展了大量实验。结果证实,对于BLE 5 PHYs,STX-Vote将可靠性提升25-28%;对于IEEE 802.15.4则提升8%,因此它可作为现有纠错方案的补充。

英文摘要:

Industrial Internet of Things (IIoT) networks must meet strict reliability, latency, and low energy consumption requirements. However, traditional low-power wireless protocols are ineffective in finding a sweet spot for balancing these performance metrics. Recently, network flooding protocols based on Synchronous Transmissions (STX) have been proposed for better performance in reliability-critical IIoT, where simultaneous transmissions are possible without packet collisions. STX-based protocols can offer a competitive edge over routing-based protocols, particularly in dependability. However, they notably suffer from the beating effect, a physical layer phenomenon that results in sinusoidal interference across a packet and, consequently, packet loss. Thus, we introduce STX-Vote, an error correction scheme that can handle errors caused by beating effects. Importantly, we utilize transmission redundancy already inherent within STX protocols so do not incur additional on-air overhead. Through simulation, we demonstrate STX-Vote can provide a 40% increase in reliability. We subsequently implement STX-Vote on nRF52840-DK devices and perform extensive experiments. The results confirm that STX-Vote improves reliability by 25-28% for BLE 5 PHYs and 8% for IEEE 802.15.4; thus, it can complement existing error correction schemes.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑