arXivDaily arXiv每日学术速递 周一至周五更新
arXiv周末暂无论文更新,休息一下吧,周末愉快~~
arXiv 2404.14724cs.RO
收藏

基于因子图优化的无人机紧耦合定位与控制模型

Tightly Joined Positioning and Control Model for Unmanned Aerial Vehicles Based on Factor Graph Optimization

Polytechnic University, Hong Kong(香港理工大学)

Peiwen Yang, Weisong Wen, Shiyu Bai, Li-Ta Hsu

AI总结:

针对无人机定位与控制解耦导致导航可靠性下降的问题,提出基于因子图优化的紧耦合定位与控制模型,将定位测量和模型预测控制统一建模为因子图因子,并通过仿真验证其有效性和鲁棒性。

摘要:

无人机(UAV)执行飞行任务主要依赖导航。传统上,导航流程被划分为定位与控制两部分,并以顺序循环方式运行。然而,现有导航流程中定位与控制相互解耦,难以适应由测量噪声、突发扰动和非线性动力学引起的普遍不确定性。因此,在复杂动态区域中,无人机的导航可靠性受到显著挑战。例如,在复杂城市区域,无处不在的全球导航卫星系统(GNSS)定位可能因周围高层建筑的信号反射而退化,导致定位不确定性显著增加。此外,城市峡谷中复杂的风扰动给控制算法带来了额外挑战。鉴于系统定位与控制之间存在高度相关性,本研究提出了一种基于因子图优化(FGO)的紧耦合定位与控制模型(JPCM)。具体而言,所提出的JPCM将来自定位约束和控制约束的传感器测量融合到一个统一的概率因子图中。其中,定位测量被构建为因子图中的因子。此外,模型预测控制(MPC)也被构建为因子图中的附加因子。通过求解由定位相关因子和基于MPC的因子共同构成的因子图,可以深入挖掘定位与控制之间的互补性。最后,我们使用一个仿真的四旋翼系统验证了所提方法的有效性和鲁棒性,结果表明其轨迹跟踪性能显著提升。

英文摘要:

The execution of flight missions by unmanned aerial vehicles (UAV) primarily relies on navigation. In particular, the navigation pipeline has traditionally been divided into positioning and control, operating in a sequential loop. However, the existing navigation pipeline, where the positioning and control are decoupled, struggles to adapt to ubiquitous uncertainties arising from measurement noise, abrupt disturbances, and nonlinear dynamics. As a result, the navigation reliability of the UAV is significantly challenged in complex dynamic areas. For example, the ubiquitous global navigation satellite system (GNSS) positioning can be degraded by the signal reflections from surrounding high-rising buildings in complex urban areas, leading to significantly increased positioning uncertainty. An additional challenge is introduced to the control algorithm due to the complex wind disturbances in urban canyons. Given the fact that the system positioning and control are highly correlated with each other, this research proposes a **tightly joined positioning and control model (JPCM) based on factor graph optimization (FGO)**. In particular, the proposed JPCM combines sensor measurements from positioning and control constraints into a unified probabilistic factor graph. Specifically, the positioning measurements are formulated as the factors in the factor graph. In addition, the model predictive control (MPC) is also formulated as the additional factors in the factor graph. By solving the factor graph contributed by both the positioning-related factors and the MPC-based factors, the complementariness of positioning and control can be deeply exploited. Finally, we validate the effectiveness and resilience of the proposed method using a simulated quadrotor system which shows significantly improved trajectory following performance.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑