arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 2403.07438eess.SP
收藏

TRC基准系统的实验分析

Experimental analysis of the TRC benchmark system

Arati Bhattu, Svenja Hermann, Nidhal Jamia, Florian Müller, Maren Scheel, Christoph Schwingshackl, H. Nevzat Özgüven, Malte Krack

AI总结:

本文对TRC基准系统进行实验分析,提出固定相位区间的响应控制测试新方法,获取高置信度振幅相关模态数据,并揭示装配变异性、热敏感性、初始曲率及对齐状态对振动行为的影响。

摘要:

Tribomechadynamics研究挑战赛(TRC)是对一块通过螺栓连接在两侧夹紧的薄板振动行为进行的盲预测。要求给出第一阶弯曲模态的固有频率和阻尼比随振幅变化的函数关系,从线性阶段一直到高水平阶段,在该阶段摩擦接触和非线性弯-伸耦合都变得重要。预测结果已在一篇配套论文中与实验结果进行了对比;本文则对该基准系统进行实验分析。通过相位共振和响应控制测试获得了随振幅变化的模态数据。提出了一种响应控制测试的原始变体:分析固定的相位区间,而不是固定的频率区间。这样,就避免了在共振区外所需的高激励水平,因为这种高激励水平可能激发不希望出现的激振器非线性。对测试方法的一致性进行了仔细分析。总体而言,这些措施使得对所获取的模态数据具有很高的置信度。进一步分析了剩余不确定性的不同来源。识别出较低的重新装配变异性,但存在中等程度的时间变异性,后者被归因于系统具有一定的热敏感性。分析了两块名义上相同的板,它们都具有明显的初始曲率,并且发现板与支撑结构是否对齐/错位对振动行为有显著影响。此外,还观察到与第一阶扭转模态之间的1:2非线性模态相互作用,该相互作用仅出现在对齐构型中。

英文摘要:

The Tribomechadynamics Research Challenge (TRC) was a blind prediction of the vibration behavior of a thin plate clamped on two sides using bolted joints. The first bending mode's natural frequency and damping ratio were requested as function of the amplitude, starting from the linear regime until high levels, where both frictional contact and nonlinear bending-stretching coupling become relevant. The predictions were confronted with experimental results in a companion paper; the present article addresses the experimental analysis of this benchmark system. Amplitude-dependent modal data was obtained from phase resonance and response controlled tests. An original variant of response controlled testing is proposed: Instead of a fixed frequency interval, a fixed phase interval is analyzed. This way, the high excitation levels required outside resonance, which could activate unwanted exciter nonlinearity, are avoided. Consistency of testing methods is carefully analyzed. Overall, these measures have permitted to gain high confidence in the acquired modal data. The different sources of the remaining uncertainty were further analyzed. A low reassembly-variability but a moderate time-variability were identified, where the latter is attributed to some thermal sensitivity of the system. Two nominally identical plates were analyzed, which both have an appreciable initial curvature, and a significant effect on the vibration behavior was found depending on whether the plate is aligned/misaligned with the support structure. Further, a 1:2 nonlinear modal interaction with the first torsion mode was observed, which only occurs in the aligned configurations.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑