arXivDaily arXiv每日学术速递 周一至周五更新
arXiv周末暂无论文更新,休息一下吧,周末愉快~~
arXiv 2401.02885astro-ph.SR
收藏

利用 DYNAMO-VLBA 测量蛇夫座中等质量恒星系统 S1 的动力学质量

Dynamical mass of the Ophiuchus intermediate-mass stellar system S1 with DYNAMO-VLBA

Jazmín Ordóñez-Toro, Sergio A. Dzib, Laurent Loinard, Gisela Ortiz-León, Marina A. Kounkel, Josep M. Masqué, S. -N. X. Medina, Phillip A. B. Galli, Trent J. Dup… 展开作者

Jazmín Ordóñez-Toro, Sergio A. Dzib, Laurent Loinard, Gisela Ortiz-León, Marina A. Kounkel, Josep M. Masqué, S. -N. X. Medina, Phillip A. B. Galli, Trent J. Dupuy, Luis F. Rodríguez, Luis H. Quiroga-Nuñez

AI总结:

本研究结合档案数据与 DYNAMO-VLBA 项目的 VLBA 观测,精确测量了蛇夫座双星系统 S1 的动力学质量,发现主星 S1A 质量低于文献值且与演化模型存在矛盾,次星 S1B 为低质量年轻恒星。

摘要:

我们报告了附近蛇夫座恒星形成区中最明亮且质量最大的恒星成员,即年轻紧密双星系统 S1 中各恒星的动力质量测量结果。我们将 28 个档案数据集与作为 \textit{利用 VLBA 测量年轻恒星多重系统的动力学质量} 项目(DYNAMO--VLBA)一部分的 7 项最新专有 VLBA 观测相结合,以约束该系统的天体测量和轨道参数,并恢复高精度的动力学质量。主星 S1A 的质量为 4.11$\pm$0.10~M$_\odot$,明显低于文献中此前报告的典型值约 6~M$_\odot$。我们表明,S1A 的光谱能量分布可以用温度大致在 14,000~K 到 17,000~K 之间的微红黑体来重现。根据演化模型,这一温度范围对应于 4~M$_\odot$ 到 6~M$_\odot$ 之间的恒星质量,因此 SED 与 S1A 的动力学质量并非先验地不一致。然而,通过 SED 拟合推导出的 S1 光度仅与恒星质量大于 5~M$_\odot$ 的模型一致。因此,我们无法使演化模型与 S1A 的动力学质量测量结果相调和:与 S1A 在 HR 图上的位置一致的模型,其对应的质量比动力学质量至少高出 25%。对于次星 S1B,测得质量为 0.831~$\pm$~0.014~M$_\odot$,与低质量年轻恒星相符。虽然 S1A 的射电通量在整个轨道期间保持大致恒定,但发现 S1B 的通量在远星点附近更高。

英文摘要:

We report dynamical mass measurements of the individual stars in the most luminous and massive stellar member of the nearby Ophiuchus star-forming region, the young tight binary system S1. We combine 28 archival datasets with seven recent, proprietary VLBA observations obtained as part of the \textit{Dynamical Masses of Young Stellar Multiple Systems with the VLBA} project (DYNAMO--VLBA), to constrain the astrometric and orbital parameters of the system, and recover high accuracy dynamical masses. The primary component, S1A, is found to have a mass of 4.11$\pm$0.10~M$_\odot$, significantly less than the typical value, $\sim$~6~M$_\odot$ previously reported in the literature. We show that the spectral energy distribution of S1A can be reproduced by a reddened blackbody with a temperature between roughly 14,000~K and 17,000~K. According to evolutionary models, this temperature range corresponds to stellar masses between 4~M$_\odot$ and 6~M$_\odot$ so the SED is not a priori inconsistent with the dynamical mass of S1A. The luminosity of S1 derived from SED-fitting, however, is only consistent with models for stellar masses above 5~M$_\odot$. Thus, we cannot reconcile the evolutionary models with the dynamical mass measurement of S1A: the models consistent with the location of S1A in the HR diagram correspond to masses at least 25\% higher than the dynamical mass. For the secondary component, S1B, a mass of 0.831~$\pm$~0.014~M$_\odot $ is determined, consistent with a low-mass young star. While the radio flux of S1A remains roughly constant throughout the orbit, the flux of S1B is found to be higher near the apastron.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑