arXivDaily arXiv每日学术速递 周一至周五更新
arXiv周末暂无论文更新,休息一下吧,周末愉快~~
arXiv 2311.09414physics.acc-ph
收藏

用于微波测量与控制的一种低延迟参考跟踪算法

A low-delay reference tracking algorithm for microwave measurement and control

J. F. Zhu, H. L. Ding, H. K. Li, J. W. Han, X. W. Dai, Z. C. Chen, J. Y. Yang, W. Q. Zhang

AI总结:

本文针对LLRF系统时钟漂移影响微波相位测量的问题,提出一种基于复数乘法的低延迟参考跟踪算法,以4个时钟周期替代传统CORDIC的16个周期,实现逐点相位相减,虽增加幅度噪声,但适用于低延迟控制。

摘要:

在自由电子激光(FEL)加速器中,低电平射频(LLRF)系统通常采用需要精确微波测量的反馈或前馈算法。LLRF的时钟分配网络的缓慢漂移会显著影响所测量的微波相位,从而影响闭环运行的稳定性。参考跟踪算法用于消除测量漂移。传统算法是对来自主振荡器的同步参考信号进行相位和幅度解调,并在其他测量通道中减去参考相位。解调通常基于CORDIC(坐标旋转数字计算机)算法,在FPGA(现场可编程门阵列)中大约需要16个时钟周期。本文采用复数乘法,仅需4个时钟周期的计算延迟,并实现逐点相位相减。然而,实验表明,这会导致不相关的幅度噪声叠加并增加幅度测量噪声。尽管如此,该参考跟踪算法适用于对微波测量具有低延迟要求的控制算法。

英文摘要:

In FEL (Free-Electron Laser) accelerators, LLRF (Low-Level Radiofrequency) systems usually deploy feedback or feedforward algorithms requiring precise microwave measurement. The slow drift of the clock allocation network of LLRF significantly impacts the measured microwave phase, thereby affecting the stability of the closed-loop operation. The reference tracking algorithm is used to eliminate the measurement drift. The conventional algorithm is to perform phase and amplitude demodulation on the synchronous reference signal from the main oscillator and subtract the reference phase in other measurement channels. The demodulation is usually based on the CORDIC, which requires approximately 16 clock cycles in FPGA (Field Programmable Gate Arrays). This paper uses the multiplication of complex numbers, which only requires four clock cycles of computational delay and achieves phase subtraction point by point. However, experiments show that it causes irrelevant amplitude noise to overlap and increase the amplitude measurement noise. Nevertheless, this reference tracking algorithm is suitable for control algorithms with low-delay requirements of microwave measurement.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑