多方向布局的三传感器2ω方法:一种测量固体材料热导率的通用方法
Three-Sensor 2ω Method with Multi-directional Layout: A General Methodology for Measuring Thermal Conductivity of Solid Materials
AI总结:
提出三传感器2ω方法测量固体材料各向异性热导率,通过多方向布局和交叉法消除表层热阻误差并避免局部最优,在四种单晶半导体上验证了其准确性与通用性。
摘要:
各向异性热传输在传热的理论研究和工程实践中均起着关键作用,但准确测量各向异性热导率仍是一项重大挑战。为解决这一问题,本研究提出了三传感器2ω方法,该方法能够准确测量固体材料的各向同性或各向异性热导率。在该方法中,按照设计指南在样品上沿不同特征方向制备了若干三传感器组,每组由三个平行的金属传感器组成,其不等的宽度和间距基于灵敏度分析进行了最优设计。在这三个传感器中,外侧两个作为交流加热器,中间一个作为直流探测器。测量每个三传感器组中探测器两端的2ω电压信号,随后通过提出的交叉法处理数据,以推导出沿感兴趣方向的热导率。使用探测器的2ω而非加热器的3ω电压信号,消除了由表层结构(金属层、绝缘层、界面等)热阻不确定性引入的误差。同时,通过用交叉法替代拟合算法,避免了多元拟合的局部最优陷阱。为验证准确性和可靠性,测量了四种典型的单晶半导体,即Si、GaN、AlN和{β-Ga _2 O _3},结果与文献一致。该方法将为固体材料的热导率测量提供一种全面且通用的解决方案。
英文摘要:
Anisotropic thermal transport plays a key role in both theoretical study and engineering practice of heat transfer, but accurately measuring anisotropic thermal conductivity remains a significant challenge. To address this issue, we propose the three-sensor 2ω method in this study, which is capable of accurately measuring the isotropic or anisotropic thermal conductivity of solid materials. In this method, several three-sensor groups following the design guidelines are fabricated upon the sample along different characteristic directions, and each group consists of three parallel metal sensors with unequal widths and distances optimally designed based on sensitivity analysis. Among the three sensors, the outer two serve as AC heaters and the middle one as a DC detector. The 2ω voltage signals across the detector in each three-sensor group are measured, and then the data are processed by the proposed Intersection Method to derive the thermal conductivities along directions of interest. The application of the detector's 2ω instead of the heater's 3ω voltage signals eliminates the errors introduced by the uncertainties of thermal resistance in superficial structures (metal layer, insulation layer, interface, etc.). Meanwhile, by replacing the fitting algorithm with the Intersection Method, the local optimum trap of multivariate fitting is avoided. To verify the accuracy and reliability, four typical monocrystalline semiconductors, i.e., Si, GaN, AlN, and {β-Ga _2 O _3}, are measured, and the results are consistent with the literature. This method will provide a comprehensive and versatile solution for the thermal conductivity measurements of solid materials.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。