Heat is an inevitable outcome in energy consumption processes, as more than 65% of input energy is wasted as heat. If we can generate electricity from waste heat, it will help minimize the needs for fossil fuels in power plants and can reduce carbon emissions. One way to generate power from heat is through the use of thermophotovoltaics (TPVs), where photons radiated from thermal emitters are converted into electricity. To optimize TPV performance, it is crucial to design emitters such that their emissivity spectrum matches their operating temperature. For example, higher emissivity is needed at shorter (longer) wavelengths at higher (lower) temperatures. Thus, having the ability to create wavelength-selective emitters can enable TPV applications for a wider range of temperatures.
This research focuses on utilizing metamaterials (2D emitters) and planar thin films (1D emitters) to create those emitters. Simulation, fabrication, material property analysis, and radiation measurements were used to characterize the emitters. Based on simulation, metamaterial emitters exhibit engineerable emissivity due to various mechanisms of their optical resonance. Also, large-area fabrication of 1D emitters (78 cm2) was achieved owing to their simple structure, which is required to produce higher TPV power output. Incorporating the characteristics of emitters of each type, their advantages and challenges are discussed. Therefore, the comprehensive results of this research help realize practical implementation of TPV applications.
Broadening near-field emission for performance enhancement in thermophotovoltaics
在热光电转换(TPV)中实现高效率的传统概念是使用在对应于电池的带隙的光子能量下的单色发射。在这里,我们从理论上证明,这样的概念是准确的理想化条件下,并进一步表明,当考虑到非辐射复合,效率的提高可以通过拓宽发射光谱,由于在开路电压的增强。通过增加短路电流,加宽发射光谱也提高了电功率密度。为了实际说明这些发现,我们专注于表面极化激元介导的近场TPV。我们提出了一种通用的设计策略,通过堆叠多个等离子体薄膜层来加宽发射光谱。作为一个例子,我们考虑一个现实的ITO/InAs TPV,并预测的转换效率的$50\%$同时与近$80$ W $/\mathrm{cm}^2$在$1300$ K发射极温度的功率密度。我们提出的系统的性能远远超过以前的作品在类似的系统中使用一个单一的等离子体层发射器。
Performance Analysis of a Near-Field Thermophotovoltaic Device with a Metallodielectric Selective Emitter and Electrical Contacts for the Photovoltaic Cell