arXivDaily arXiv每日学术速递 周一至周五更新
arXiv周末暂无论文更新,休息一下吧,周末愉快~~
arXiv 2304.07690cs.NI
收藏

C-band 与 CBRS 之间邻道干扰影响的测量研究

A Measurement Study of the Impact of Adjacent Channel Interference between C-band and CBRS

Muhammad Iqbal Rochman, Vanlin Sathya, Bill Payne, Mehmet Yavuz, Monisha Ghosh

AI总结:

本文通过真实部署测量量化 4G CBRS 与 5G C-band 因无保护带且 TDD 配置不同步造成的双向邻道干扰,并验证信道间隔和 MicroSlicing 对吞吐量及时延的改善。

摘要:

3.7–3.98 GHz 频段(也称为 C-band)最近在美国被分配用于部署 5G 蜂窝服务。在此之前,较低的相邻频段 3.55–3.7 GHz 已被分配给公民宽带无线电服务(Citizens Broadband Radio Service,CBRS),其中整个 150 MHz 频谱可由第 3 层一般授权接入(General Authorized Access,GAA)用户免费使用,但频谱接入需要获得频谱接入系统(Spectrum Access System,SAS)授权。只有当区域内不存在第 1 层现有用户(Incumbents,海军雷达)或第 2 层优先接入许可(Priority Access License,PAL)用户时,GAA 用户才被允许使用某个信道。然而,由于 GAA 与 C-band 之间没有保护带,并且两个系统都采用时分双工(Time Division Duplexing,TDD),而上行链路/下行链路配置并不同步,邻道干扰可能会降低两个系统的性能。本文通过在真实部署中开展实验,量化这种相互干扰的影响。我们观察到,当两台设备彼此距离很近,且一台发送上行链路而另一台发送下行链路时,两个系统的下行链路吞吐量都会显著下降:4G CBRS 下降 60%,5G C-band 下降 43%。我们认为,这是首篇在真实部署中证明这一点的论文。当 CBSD 改变信道并在距离 C-band 20 MHz 的位置运行时,这种吞吐量下降得到缓解,实质上是在信道之间形成了保护带。我们还通过在 CBSD 上实现 MicroSlicing,证明了邻道干扰下时延的改善。结果表明,解决因缺少保护带和 TDD 配置不匹配而导致的邻道干扰,对于提升 CBRS 和 C-band 系统的性能至关重要。

英文摘要:

The 3.7 - 3.98 GHz frequency band (also known as C-band) was recently allocated in the US for the deployment of 5G cellular services. Prior to this, the lower adjacent band, 3.55 - 3.7 GHz, had been allocated to Citizens Broadband Radio Service (CBRS), where the entire 150 MHz can be used for free by Tier 3 General Authorized Access (GAA) users, but access to the spectrum needs to be authorized by the Spectrum Access System (SAS). GAA users are allowed on a channel only when there are no Tier 1 Incumbents (Navy radars) or Tier 2 Priority Access License (PAL) users in the area. However, since there are no guard bands between GAA and C-band, and both systems employ Time Division Duplexing (TDD) where the uplink/downlink configurations are not synchronized, adjacent channel interference can potentially reduce the performance of both systems. In this paper, we quantify the effect of this mutual interference by performing experiments with a real-world deployment. We observe significant downlink throughput reductions on both systems when two devices are in close proximity to each other, and one is transmitting uplink while the other is transmitting downlink: 60% for 4G CBRS and 43% for 5G C-band. We believe that this is the first paper to demonstrate this in a real deployment. This throughput degradation was reduced when the CBSD changed its channel and operated 20 MHz away from C-band, essentially creating a guard band between the channels. We also demonstrate the improvement in latency under adjacent channel interference by implementing MicroSlicing at the CBSD. Our results indicate that addressing adjacent channel interference due to the lack of guard bands and TDD configuration mismatch is crucial to improving the performance of both CBRS and C-band systems.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑