序贯蒙特卡洛方法在虚拟流量计校准中的应用
Sequential Monte Carlo applied to virtual flow meter calibration
AI总结:
本文提出基于生产分离器测量值和序贯蒙特卡洛的虚拟流量计连续联合校准方法,在十口井案例中无需井测试即可有效估计各井调节因子与流量组成。
摘要:
软测量传感器因其能够以较低的资产干预和低成本提供关键过程变量的估计而日益受到欢迎。在油气生产中,虚拟流量计量(VFM)是一种流行的软测量传感器,旨在实时估计多相流量。VFM基于模型,而这些模型需要校准。由于模型种类繁多且可用测量数据各异,校准高度依赖于具体应用。最精确的校准通过将VFM参数仔细调整至井测试数据来实现,但这种方式可能工作量大,且并非所有井都有频繁的井测试数据可用。本文提出一种基于生产分离器提供的测量值的校准方法,并假设观测到的流量应等于各单井流量之和。这使我们能够持续地联合校准各井的VFM。该方法应用序贯蒙特卡洛(SMC)来推断每口井的调节因子和流量组成。该方法在一个包含十口井的案例上进行了测试,使用了合成数据和真实数据。结果令人鼓舞,该方法能够在不依赖井测试的情况下提供合理的参数估计。然而,也识别并讨论了一些挑战,特别是与过程噪声以及如何管理变化的数据质量相关的问题。
英文摘要:
Soft-sensors are gaining popularity due to their ability to provide estimates of key process variables with little intervention required on the asset and at a low cost. In oil and gas production, virtual flow metering (VFM) is a popular soft-sensor that attempts to estimate multiphase flow rates in real time. VFMs are based on models, and these models require calibration. The calibration is highly dependent on the application, both due to the great diversity of the models, and in the available measurements. The most accurate calibration is achieved by careful tuning of the VFM parameters to well tests, but this can be work intensive, and not all wells have frequent well test data available. This paper presents a calibration method based on the measurement provided by the production separator, and the assumption that the observed flow should be equal to the sum of flow rates from each individual well. This allows us to jointly calibrate the VFMs continuously. The method applies Sequential Monte Carlo (SMC) to infer a tuning factor and the flow composition for each well. The method is tested on a case with ten wells, using both synthetic and real data. The results are promising and the method is able to provide reasonable estimates of the parameters without relying on well tests. However, some challenges are identified and discussed, particularly related to the process noise and how to manage varying data quality.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。