不同设计几何形状与材料选择的 MKIDs 噪声优化
Noise Optimization for MKIDs with Different Design Geometries and Material Selections
AI总结:
本文分析了MKID几何形状和材料选择对噪声性能的影响,提取并表征了双能级系统噪声、产生-复合噪声和系统白噪声的来源,验证了通过改变电容器间隙、温度和电感器体积可优化噪声,且不同材料实验结果与物理模型相符。
摘要:
噪声分量的分离与优化对于微波动态电感探测器(MKID)的开发至关重要。我们分析了针对毫米波实验的一系列 MKID,其集总元件电感器和叉指电容器几何形状的若干变化对噪声性能的影响。我们从每个探测器的噪声功率谱中提取了介电层中的双能级系统噪声、超导薄膜固有的产生-复合噪声以及系统白噪声的贡献,并表征了这些噪声分量如何依赖于探测器几何形状、材料以及驱动功率和温度等测量条件。我们观察到,对于铝和铌探测器,随着样品温度升高和叉指电容器内部指间间隙增大,双能级系统噪声的幅度有所降低。我们还验证了随着电感器体积减小,产生-复合噪声及相关的准粒子寿命如预期般降低。本研究还对包括铝、铌和铝锰在内的不同材料进行了迭代测试,并将结果与潜在的物理模型进行了比较。
英文摘要:
The separation and optimization of noise components is critical to microwave-kinetic inductance detector (MKID) development. We analyze the effect of several changes to the lumped-element inductor and interdigitated capacitor geometry on the noise performance of a series of MKIDs intended for millimeter-wavelength experiments. We extract the contributions from two-level system noise in the dielectric layer, the generation-recombination noise intrinsic to the superconducting thin-film, and system white noise from each detector noise power spectrum and characterize how these noise components depend on detector geometry, material, and measurement conditions such as driving power and temperature. We observe a reduction in the amplitude of two-level system noise with both an elevated sample temperature and an increased gap between the fingers within the interdigitated capacitors for both aluminum and niobium detectors. We also verify the expected reduction of the generation-recombination noise and associated quasiparticle lifetime with reduced inductor volume. This study also iterates over different materials, including aluminum, niobium, and aluminum manganese, and compares the results with an underlying physical model.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。