The intakes of air-breathing high-speed flying vehicles produce a large share of the thrust propulsion. Furthermore, the propulsion performance of these engines increases when the single-ramp intake is replaced with a multiple-ramps intake. Many scholars numerically and experimentally studied the high-speed engine performance over static single and multiple compression ramps. However, the transient behavior of the flow during the rotation of the double compression ramp from a single ramp is not fully investigated. The present paper aims to numerically investigate the transient shock reflection phenomenon over a rotating double wedge. The problem will start with a 3-Mach number inviscid flow over a single wedge. Then, a portion of the wedge will be rotated upstream at a quite low trailing Mach number to avoid the significant lag effect in the shock waves system. This idea could be applied in the supersonic intake or extensionally in the hypersonic intake of scramjets with a somehow complex mechanism. Further, the length of the rotating portion of the wedge will be changed three times to study its effect on the shock system. The results show a high gain in the pressure due to the rotation of the wedge. Moreover, the wave angles were larger at the low chord ratio value of $w_2/w_i= 0.25$ than at the high values of $w_2/w_i$ at the same second wedge rotating angle, $θ_2$, resulting in a higher pressure distribution.
Mechanism of separation hysteresis in curved compression ramp
提出了一种新的空间相关机制来理解最近发现的弯曲压缩斜坡(CCR)流中的分离滞后过程(Hu et al. Phy.流体,32(11):113601,2020)。对两种分离涡进行了数值研究,这两种分离涡是由马赫数和壁面温度的变化引起的。这两个结果表明,必须存在马赫数和壁温的参数区间,在此区间内,附着和分离状态都能稳定地建立。分析了这两种情况下的气动特性(包括壁面摩擦、压力和热流)与激波形态的关系。进一步,利用经典理论估算了上游分离过程引起的逆压梯度Isb(x)和下游等熵压缩过程引起的逆压梯度Icw(x)。从形状因子和声速线高度等物理量的空间分布来评估边界层APG阻力Ib(x)的趋势。当Isb、Icw和Ib具有适当的空间分布时,在分离和附着稳定条件下,得到了自洽机制.
Hypersonic curved compression ramp flows with bistable states
对弯曲压缩斜面(CCR)流动中的双稳态状态和分离滞后现象以及相应的气动特性(包括壁面摩擦、压力和热流)进行了数值和理论研究。对旋转角变化引起的分离滞后现象以及来流马赫数和壁面温度对滞后现象的影响进行了直接数值模拟。分析了壁面摩擦力、压力和热流密度的分布。此外,壁摩擦的第一和第二个最小值的出现在分离泡的解释,揭示它是由分离和再附着冲击引起的逆压梯度占主导地位。目前的结果和分析表明,史密斯(伦敦皇家学会会刊。A. Mathematical and Physical Sciences,1988,420:21-52)在CCR流中不太可能发生。分离态峰值压力的预测证实了基于最小粘性耗散定理的模型(Physics of Fluids,2020,32(10):101702)。而压力超调可以通过压缩和膨胀过程的压力匹配激波极线来分析。根据经典的幂函数关系,讨论了分离态和附着态的峰值热流密度与峰值压升之间的关系。
Direct numerical simulation of compressible turbulence accelerated by graphics processing unit. Part 1: An open-source high accuracy accelerated computational fluid dynamic software