磁通排出研究中的AMR磁传感器
AMR Magnetic Sensors in Flux Expulsion Studies
摘要:
超导材料如铌的磁通量排出特性,广泛用于射频腔的制造,显著地影响腔的性能特性。SRF谐振器的品质因数可能由于捕获通量涡流的存在而显著受损,从而导致材料中的额外RF能量损失。不同的研究小组已经进行了大量的实验,以建立铌腔中的磁通捕获与铌中杂质的存在以及各种表面处理方法的相关性。这些实验中的大多数利用市售的低温磁通门磁传感器来测量铌转变到超导状态之前和之后的场,以量化捕获的磁通量。通常使用的磁通门的一个缺点是感测体积的大小。作为示例,Barting-ton F和G型低温磁通门具有约30 mm的感测芯长度,这与腔壁的曲率半径相当,并且因此与排出之后的磁场线曲率半径相当。因此,需要校正所测量的场值以考虑在感测体积上的传感器有效平均。在更尖锐的几何形状的情况下,例如,如果在厚度为~ 5 mm的矩形铌平板的边缘上测量磁通排出,则使用磁通门将是不切实际的。
英文摘要:
Magnetic flux expulsion properties of the superconducting material such as bulk niobium, widely used for the radio-frequency cavity fabrication, substantially affect the performance characteristics of the cavities. The quality factor of the SRF resonators can be significantly compromised due to the presence of the trapped flux vortices causing additional RF energy losses in the material. Large number of experiments have been carried out by different research groups to establish the correlation of the flux trapping in niobium cavities with the presence of impurities in niobium as well as various surface treatment methods. Majority of these experiments utilize commercially available cryogenic fluxgate magnetic sensors to measure the field before and after the niobium transition to the superconducting state to quantify the amount of flux trapped. One disadvantage of the typically used fluxgates is the size of the sensing volume. As an example, the Barting-ton F and G type cryogenic fluxgates have a sensing core length of about 30mm, which is comparable to the curvature radius of the cavity walls and hence the magnetic field lines curvature radius after the expulsion. Thus, the measured field value needs to be corrected to account for the sensor effective averaging over the sensing volume. In case of the sharper geometries, for instance if the flux expulsion to be measured on the edge of the rectangular niobium flat sheet with a thickness of ~5mm, the use of the fluxgate would be impractical.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。